VANDAL PROOF B&W POLYCARBONATE
DOME CAMERA WITH 3 BOARD LENS
Owners Manual
Please read the manual thoroughly before operating this unit.
VQ1232
Download from Www.Somanuals.com. All Manuals Search And Download.
INTRODUCTION:
Congratulations on your purchase of this Vision Q Vandal Proof B&W Dome Camera. This Dome camera comes with
a Polycarbonate construction to provide high impact protection. The heavy duty all metal base with swivel
bracket and tamper proof hardware adds extra protection against possible vandalism. This Dome camera can be
tilted 90° for optimum angle selection.
CONNECTING VISION Q CAMERA TO A 2 PAGE / 8 CHANNEL QUAD OBSERVATION SYSTEM
1.
2.
3.
4.
5.
Mount the camera to the ceiling.
Connect the video extension cable (not included) from the camera to the monitor.
Connect the power extension cable (not included) to the supplied power 12V DC adaptor.
Attach the video extension cable to the monitor’s camera inputs (see diagram below).
Attach the supplied 12V DC power supply to the power extension cable (not included) and plug into
an electrical outlet.
6.
7.
Turn your monitor ON and select the desired channel to see the picture.
Repeat above procedures for connecting all 3 cameras to the monitor.
BACK VIEW OF 2 PAGE 8 CHANNEL QUAD MONITOR
CAMERA 1
BNC INPUTS
VANDALPROOF
B&W DOME CAMERA
CAMERA 2
CAMERA 3
VIDEO EXTENSION CABLE
(NOT INCLUDED)
CONNECTING CAMERA TO A SINGLE PAGE QUAD OBSERVATION SYSTEM
1.
2.
3.
4.
5.
Mount the camera to the ceiling.
Connect the video extension cable (not included) from the camera to the monitor.
Connect the power extension cable (not included) to the supplied power 12V DC adaptor.
Attach the video extension cable to the monitor’s camera inputs (see diagram below).
Attach the supplied 12V DC power supply to the power extension cable (not included) and plug
into an electrical outlet.
6.
7.
Turn your monitor ON and select the desired channel to see the picture.
Repeat above procedures for connecting all 3 cameras to the monitor.
BACK VIEW OF SINGLE PAGE QUAD MONITOR
CAMERA 1
BNC INPUTS
VANDALPROOF
B&W DOME CAMERA
CAMERA 2
CAMERA 3
VIDEO EXTENSION CABLE
(NOT INCLUDED)
Download from Www.Somanuals.com. All Manuals Search And Download.
-2-
TROUBLE SHOOTING:
If the camera does not function properly, check the following points. If you continue to have problems, please call our
Toll Free Customer Support line for assistance.
PROBLEMS
CAUSE AND REMEDIES
NO PICTURE
DC ADAPTOR NOT PLUGGED IN
MONITOR NOT TURNED TO CORRECT
MODE OR CHANNEL
POOR PICTURE QUALITY
CLEAN THE CAMERA LENS
ADJUST THE CONTRAST OR BRIGHTNESS CONTROL
OF YOUR MONITOR
FOR MORE INFORMATION
OR TO SEE THE COMPLETE RANGE OF LOREX PRODUCTS
PLEASE VISIT OUR WEBSITE:
WWW.STRATEGICVISTA.COM
TECHNICAL SPECIFICATIONS
Image Sensor
Pixels
1/3” CCD B&W
510 x 492
Scanning System
Resolution
525 lines, 60 field/sec
380 lines
Min Illumination
S/N Ratio
White Balance
Electronic Shutter
Lens
0.5 lux
More than 48 db
Auto White Balance
1/60 – 1/100,000 sec
2.9mm
Power Consumption
Operational Temp.
Dimensions
Weight
12 V DC, 500mA
-26° - 122°F
4 7/8” Dia x 3 ½” H
17.6 oz
ALWAYS USE DISCRETION WHEN INSTALLING VIDEO AND/OR AUDIO SURVEILLANCE EQUIPMENT
WHEN THERE IS PERCEIVED PRIVACY. INQUIRE REGARDING FEDERAL, STATE AND/OR LOCAL
REGULATIONS APPLICABLE TO THE LAWFUL INSTALLATION OF VIDEO AND OR AUDIO RECORDING
OR SURVEILLANCE. PARTY CONSENT MAY BE REQUIRED.
BECAUSE OUR PRODUCTS ARE SUBJECT TO CONTINUOUS IMPROVEMEMT, SVC RESERVES THE RIGHT TO MAKE PRODUCT MODIFICATION
WITHOUT NOTICE AND WITHOUT INCURRING ANY OBLIGATION. E&OE
Download from Www.Somanuals.com. All Manuals Search And Download.
-3-
|