SB-POL-RNGR/SYS INSTR_SKU# 011278
InstallatIon
d I F F I C u lt Y :
If you choose to perform the installation yourself, it is absolutely vital that the
out
oF
enclosures be properly mounted to the vehicle according to these instructions.
Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
I n s t a l l a t I o n G u I d e
for the
35
SB-POL-RNGR/SYS
sKu#94425
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
estImated tIme:
2-3 HouRs
2004-2008
s t e P
1
Many of the following steps will be repeated on both
sides of the vehicle.
Remove the five screws that secure each of the kick
panels.
(see circled areas, there are also two inside)
Thank you for choosing a JL Audio Stealthbox® for your all-terrain vehicle. With proper installation,
your new vehicle-specific enclosed speaker system will deliver years of listening pleasure.
s t e P
2
The kick panels can be removed by pulling up at the bottom
and towards the rear, hinging the panel backwards and out.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. If you prefer to perform your own installation,
please read this installation guide completely
before beginning the process.
s t e P
3
Before test fitting the subwoofer enclosure, make yourself
familiar with the location of the threaded insert on the top of
the enclosure.
From the passengers side, test fit the subwoofer enclosure
into the dash with the raised part of the enclosure going up
and, behind the dash cross-dash bar as shown.
Now is a good time to test the performance of the
Subwoofer.
Continued on Next Page
Download from Www.Somanuals.com. All Manuals Search And Download.
SB-POL-RNGR/SYS INSTR_SKU# 011278
I n C l u d e d H a R d W a R e
s t e P
9
Install a piece of the included Self Adhesive Gasket Material
along the outer edge of each frame rail where the OEM kick
panels had been attached.
1) Custom Aluminum Bracket
1) 3/8-16x 1” Hex Head Bolt
4) 3/8 Split Locking Washer
1) 3/8-16x 1 1/2” Hex Head Bolt
1) 3/8 x 1 1/4” Fender Washer
1) 3/8 Flat Washer
1) Square U-Bolt (with washers and, nuts) 4) 1/4x 1” Button Head Allen Bolt
4) 1/4-20 Lock Nut
1) 1/2x 1” Custom Aluminum Spacer
s P e C I F I C a t I o n s
Subwoofer Enclosure Type: Acoustic Suspension (sealed)
Driver Type: M10W5
Nominal Impedance: 4 Ohms
Continuous Power Handling: 250 Watts (RMS)
s t e P 1 0
Run the wire from each of the kick panels to the amplifier
location, slide the kick panels into place using the opposite
method from what was done to remove the OEM kick pan-
els. Position the housings so that the screw holes along the
frame rail line up with the holes in the enclosure. Using the
OEM hardware, attach each enclosure to the frame rails of
the vehicle.
Kickpanel Enclosure Type: Infinite Baffle
Driver Type: M770-CCX
Nominal Impedance: 4 Ohms
Continuous Power Handling: 100 Watts (RMS)
P o W e R R e C o m m e n d a t I o n
JL Audio recommends using a high quality amplifier such as the JL Audio M4500. The diagram below shows the
recommended crossover and input settings for the M4500 when being used to power your Stealthbox®.
s t e P 1 1
Along the inner edge of each speaker housing there are
two screw holes that will need to have pilot holes drilled
and then have the supplied 1/4x 1” Button Head Allen Bolts
installed through the flanges and the floor, under the floor
there should be a fender washer against the floor and, a
1/4-20 Locknut installed to secure the speaker housings to
the floor of the vehicle.
The JL Audio M4500 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
s t e P 1 2
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®! Go out in the woods and get
dirty!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
(954) 443-1100
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011278 ©10-15-2008
•
Printed in USA
•
©2008 JL Audio, Inc.
•
U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
Page 3 • JL Audio, Inc 2008
Download from Www.Somanuals.com. All Manuals Search And Download.
|