Havis Shields C VS 800 CV User Manual

INSTALL INSTRUCTIONS C-VS-800-CV  
VEHICLE SPECIFIC CONSOLE &  
RADIO/HVAC RELOCATION HOUSING  
1997-2008 FORD CROWN VICTORIA  
TOOLS REQUIRED:  
Ratcheting wrench  
Tin snips (if necessary)  
Standard/Metric socket set  
Screwdriver set  
Powered Drill w/ 5/16” drill bit  
HARDWARE:  
QTY DESCRIPTION  
PART #  
GSM33195  
C-HK-1  
2
1
#10 x ¾” Phillips sheet metal screws  
Torx Screw Kit  
Always!  
Disconnect the vehicles’ battery. Removing seat bolts on  
some vehicles may give the vehicles computer a false  
reading resulting in warning lights. This requires the  
vehicles’ computer to be reset.  
Read all instructions before installing any Havis-Shields  
Equipment Corp products.  
Check for obstructions (Wire, brake lines, fuel tank, etc.)  
before drilling any holes!  
Use hardware provided with install kit.  
For product support, visit the Install Instructions Section  
of our website at  
[email protected] or call 1-800-524-9900.  
Ford Crown Victoria dashboard  
Remove ashtray and power point  
housing from dash  
A flat head screwdriver is needed to  
release the tray from the slide tracks  
Note: If NOT relocating  
AM/FM radio and/or  
Notch  
HVAC controls, resume  
installation at this point  
Re-route HVAC controller and the  
AM/FM radio harness and antenna  
to the VS console  
It is necessary to notch the OEM  
ashtray/power point frame assembly if  
relocating the HVAC controls to the VS  
console. This will allow the HVAC  
vacuum hoses to reach the VS console  
Remove wire plug going to  
Ashtray/Power point frame  
assembly  
Drill out spot-welds that hold the  
power point bracket to the frame. This  
needs to be removed in order for the  
console to slide into the rail  
Power point detached from  
assembly  
Re-install ashtray frame bracket  
Slide console into ashtray  
frame slide rails  
Ashtray frame rail re-assembled  
C-VS-800-CV_INST_9-07  
3
Pre-drill OEM dash using holes in  
console as a drill template  
Holes are for screws to attach to the  
OEM dash  
View of console from inside  
Attach using #10 x ¾” sheet metal  
Final installation of console  
screws.  
Install components according to  
specific application  
Install HVAC controller into C-  
EB40-ACV-1P as shown and install  
into console above AM/FM radio  
Install AM/FM radio if necessary, as  
shown above.  
C-VS-800-CV_INST_9-07  
4

AGE07 User Manual
Canon PIXMA MP170 User Manual
Carrier 48SS024 User Manual
Cornelius Remcor 2849949200 User Manual
Danby DWC612BLP User Manual
DCS UR624 User Manual
GE AZ38H09DAD User Manual
Haier AB094FAAHA User Manual
Haier AS072AZBDA User Manual
Harbor Freight Tools 67498 User Manual