INSTALL INSTRUCTIONS
C-VS-2400-CHGR & C-VS-2400-CHGR-1
2006 – 2007 DODGE CHARGER and MAGNUM
2008 DODGE CHARGER and MAGNUM
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, 10mm, 8mm
Screwdriver set
T-20 Torx bit
HARDWARE:
ITEM QTY
DESCRIPTION
PART#
1
2
3
3
4
5
6
7
8
9
10
11
12
1
1
2
2
1
1
1
6
2
4
4
4
4
2
2
2
1
1
1
Console housing assembly
Front support bracket
Side trim panels - 2006 – 2007 Charger
Side trim panels - 2008 Charger
Front floor bracket
Sensor guard
Rear floor panel
#10 x ½” machine screws
#10 keps nuts
C-VS-2400-CHGR-H
CM001593
CM001598-D and P
CM002164 and CM002165
CM001595
CM001638
CM001642
GSM33118
GSM30028
GSM31003
GSM31005
GSM31999
GSM30016
GSM33060-1
GSM31014
GSM30201
GSM20017-1
C-HK
C-HK-1
#10 flat washers
¼” flat washer
¼” x ½” carriage bolt
¼” Nylock nut
¼” x ¾” self threading bolt
¼” x 1” fender washer
6mm hex nut
1-1/16” diameter plug
Hardware Kit
Torx Hardware Kit
2
7, 9
10, 11, 12
3
4
1
7, 9
5 - Not shown, approximate location
6
Place console housing assembly,
continuing to align with OEM
floor nut serts (Item 1)
Position sensor guard to align
with OEM floor nut serts
(Item 5)
Position rear-floor panel, continue to
align with OEM floor nut serts
(Item 6)
Attach main console housing to
previously installed floor bracket
using ¼” carriage bolts and nylock
nuts. Use a scribe or awl to help align
(7/16” socket, awl)
Using OEM rear bolts or ¼” x ¾” self
threading bolts, loosely attach main
console housing, sensor guard, and
rear cover panel to floor
Tighten all hardware
(7/16”, 8mm, 10mm socket)
(8mm or 7/16” socket)
2006 - 07
2008
Attach side trim panels using #10 x ½”
Wire and mount
equipment controls
machine screw & washer
(Phillips screwdriver) (Item 3)
C-VS-2400-CHGR_INST_12-07
3
|