HP Hewlett Packard Hewlett Packard All in One Printer PSC1100P User Manual

Unpack the device  
Turn on the computer  
Windows users START HERE  
Begin software installation  
1
2
3
4
a
b
This side of the poster is for Windows users only.  
Turn on your computer and wait for  
the Windows PC desktop to appear.  
Insert the Windows HP PSC CD and follow the onscreen instructions.  
a
Follow the steps on this poster in order.  
If nothing appears on your computer screen after you insert the CD, see the Troubleshooting  
Information chapter in the Reference Guide.  
Windows PC  
Close any open programs.  
Do not connect the USB cable until the software  
prompts you to do so.  
When you see the Set Up Your Device Now screen, leave your computer and proceed to step 5 on  
this poster. Do not connect the USB cable yet.  
b
Windows PC desktop  
a
b
Windows 98,  
2000, ME, XP  
Attach the front panel cover  
Load plain white paper  
Connect the power cords  
c
5
6
7
a
b
a
Remove the adhesive backing from the front panel cover.  
a
c
b
b Raise the lid of the HP PSC. Place the front panel cover into the recess and  
stick it into place.  
The HP PSC will not work until you attach the front panel cover!  
a
b
a
b
Open the print-carriage access door  
Turn on the device  
Connect the USB cable  
8
9
10  
Make sure that you see the Set Up Your Device Now  
screen on your computer, then connect the USB  
cable. Do not connect the USB cable to a keyboard  
or a non-powered USB hub.  
Press the On/Resume  
Lower the print-carriage  
access door. The print  
carriage slides to the  
middle.  
button to turn on the  
HP PSC. Wait for it to  
finish initializing.  
Insert and align the print cartridges  
Finish software installation  
12  
11  
Hardware setup is now complete. Return to your computer.  
Tri-color  
Black  
Click Next on the screen with the green checkmark. Depending on your  
system, it may take 20 minutes or more to finish installing the software.  
a
c
e
b
d
When you restart your computer and the Congratulations screen appears,  
you are ready to use your HP PSC. If you encounter problems during setup,  
see the Reference Guide.  
Remove the bright pink tape from  
the print cartridges. Do not touch  
the gold-colored contacts or  
retape the cartridges.  
Hold the black print cartridge with the large HP label and  
the raised markings on top. Slide the cartridge at a slight  
angle into the right side of the print carriage.  
Hold the color print cartridge with the large HP label and the raised  
markings on top. Slide the cartridge at a slight angle into the left side  
of the print carriage.  
Close the print-carriage access door. Within a few minutes, a  
print cartridge alignment page prints.  
Press the Scan button.  
After the On light stops blinking,  
alignment is complete. Discard or  
recycle the alignment page.  
Place the top of the alignment page face down in the left  
front corner of the glass. Close the lid.  
Press firmly until the print cartridge snaps into place.  
Press firmly until the print cartridge snaps into place. Make sure that  
both print cartridges are secure.  

Briggs Stratton Automobile Parts 280000 User Manual
Canon Wireless Photo All In One 8331B021 User Manual
Clarion NONE FOUND SRH292HX User Manual
Cornelius Post Mix Valves UFB 1 User Manual
Epson All in One Printer CX11NF User Manual
Fujitsu ASYA24LCC User Manual
Graco Baby Accessories PD261471A User Manual
HoMedics MASSEUR IN A BOXTM RMM 300H 3GB User Manual
HP Hewlett Packard Hewlett Packard Barcode Reader HP 44715A User Manual
HP Hewlett Packard PHOTOSMART 2700 User Manual