Bryant 701A User Manual

User Information Manual  
701A  
702A  
SINGLE-PACKAGED  
ELECTRIC COOLING UNITS  
Cancels: OM01-59  
OM01-62  
1- 03  
NOTE TO INSTALLER  
This manual should be left with the equipment owner.  
FOR YOUR SAFETY  
Do not store or use gasoline or other flammable vapors and liquids  
in the vicinity of this or any other appliance.  
WARNING: Do not use this unit if any part has been  
under water. Immediately call a qualified service techni-  
cian to inspect the unit and to replace any part of the  
control system which has been under water. Failure to  
follow this warning could result in electrical shock, fire,  
personal injury, or death.  
WARNING: Before performing recommended mainte-  
nance, be sure the main power switch to unit is turned off.  
Electric shock could cause personal injury or death.  
TO START UNIT  
Fig. 1—Unit 701A and 702A  
I. TURN ON THE ELECTRICAL POWER SUPPLY TO  
UNIT.  
WARNING:  
1. TURN OFF ELECTRICAL POWER TO YOUR UNIT  
BEFORE SERVICING OR PERFORMING MAIN-  
TENANCE.  
II. SELECT TEMPERATURE AND SET SYSTEM SWITCH  
TO DESIRED MODE.  
2. When removing access panels or performing mainte-  
nance functions inside your unit, be aware of sharp  
sheet metal parts and screws. Although special care is  
taken to reduce sharp edges to a minimum, be ex-  
tremely careful when handling parts or reaching into  
the unit.  
TO SHUT UNIT OFF  
If unit is being shut down because of a malfunction, call your  
dealer as soon as possible.  
I. SET TEMPERATURE SWITCH TO OFF.  
II. TURN OFF THE ELECTRICAL POWER SUPPLY TO  
UNIT.  
A. Air Filters  
Air filter(s) should be checked at least every 3 or 4 weeks and  
changed or cleaned whenever it becomes dirty. Dirty filters  
produce excessive stress on the blower motor and can cause the  
motor to overheat and shut down. Table 1 indicates the correct  
filter size for your unit. Refer to Fig. 2 to access the filter(s).  
ROUTINE MAINTENANCE  
All routine maintenance should be handled by skilled, experienced  
personnel. Your dealer can help you establish a standard proce-  
dure.  
For your safety, keep the unit area clear and free of combustible  
materials, gasoline, and other flammable liquids and vapors.  
To replace or inspect filter(s) (or accessory filter rack when  
supplied):  
To assure proper functioning of the unit, flow of condenser air  
must not be obstructed from reaching the unit. Clearance of at least  
48 in. is required from top of unit and on sides except the power  
entry side (42 in. clearance) and the duct side (12 in. minimum  
clearance).  
1. Remove the filter access panel using a 5/16-in. nut driver.  
2. Remove the filter(s) by pulling the filter(s) out of the unit.  
If the filter(s) is dirty, clean or replace with new one.  
When installing the new filter(s), note the direction of the airflow  
arrows on the filter frame.  
If you have difficulty in locating your air filter(s), or if you have  
questions concerning proper filter maintenance, contact your  
dealer for instructions. When replacing filters, always use the same  
size and type of filter that was supplied originally by the installer.  
MAINTENANCE AND CARE FOR THE EQUIPMENT  
OWNER  
Before proceeding with those things you might want to maintain  
yourself, please carefully consider the following:  
—1—  
WARRANTY CERTIFICATES  
( ) If your unit still fails to operate, call your servicing dealer for  
troubleshooting and repairs. Specify the model and serial numbers  
of your unit. (Record them in this manual in the space provided.)  
If the dealer knows exactly which unit you have, he may be able  
to offer suggestions over the phone, or save valuable time through  
knowledgeable preparation for the service call.  
Unit 701A and 702A have limited warranties. Certificates are  
located at the back of this book. Be sure to read the warranty  
carefully to determine the coverage for your unit.  
BEFORE YOU CALL FOR SERVICE, CHECK FOR SEV-  
ERAL EASILY-SOLVED PROBLEMS  
If insufficient heating or cooling is suspected:  
IN CASE OF TROUBLE  
( ) Check for sufficient airflow. Check the air filter for dirt. Check  
for blocked return-air or supply-air grilles. Be sure they are open  
and unobstructed. If these checks do not reveal the cause, call your  
servicing dealer.  
If after performing the above and unit performance is still  
unsatisfactory, shut off the unit and call your dealer.  
Dealer’s Name..................................................................................  
Telephone .........................................................................................  
Unit Model .......................................................................................  
Unit Serial Number..........................................................................  
If your unit is not operating at all, check the following list for easy  
solutions:  
( ) Check to be sure that your thermostat temperature selector is set  
below the indoor temperature during the cooling season. Be sure  
the system switch is in the COOL position and not in the OFF  
position.  
—3—  
© 2003 Bryant Heating & Cooling Systems 7310 W. Morris St. Indianapolis, IN 46231  
Printed in U.S.A.  
OM01-62  
Catalog No. 5370-104  
4—  

Brother Printer MFC J432W User Manual
Carrier 39LA User Manual
Carrier 48VL A User Manual
Carrier KH_233P User Manual
Cornelius S2828 User Manual
Friedrich ZONEAIRE P09B User Manual
GE LCB AJCQ 10 User Manual
HandHeld Entertainment Barcode Reader 4600G User Manual
Heat Controller Inc Air Conditioner DMH18DB 1 User Manual
Honda Automobiles Car engines GX640 User Manual