MINIATURE
GREENHOUSE
92050
ASSEMBLY & OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright© 2004 by Harbor Freight Tools®. All rights reserved. No portion of this manual or
any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions and replacement parts please call 1-800-444-3353.
Download from Www.Somanuals.com. All Manuals Search And Download.
9. Wear gloves and avoid sharp edges when assembling.
10. Make certain that the Greenhouse is placed on a falt, level, solid surface capable of
supporting the Greenhouse.
11. Because of aluminum dust, be certain to wash your hands after handling the
Greenhouse.
12. Never allow children to play with this product. Caution: Small parts can be easily
swallowed by small children.
WARNING:This product contains or, when used, produces a chemical known to the State of
California to cause cancer and birth defects or other reproductive harm.
(California Health & Safety Code 25249.5, et seq.)
Warning:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking your Miniature Greenhouse, check to make sure the following parts are included.
If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.
Assembly/ Operation
Your Miniature Greenhouse will require complete assembly prior to use. It is important that you read
the entire manual to become familiar with the product BEFORE you assemble and use the
Greenhouse. Before assembling and operating the Greenhouse be sure that you have all parts
described in the Parts List and Assembly Diagram located on the last pages of this manual.
Note that throughout the assembly process all parts of the Greenhouse frame will be
attached using the Bolts and Nuts (11) provided. Parts have been labeled with the appropriate
part number to help with assembly. Refer to the assembly diagrams and figures for all steps. Do
not install Windows until specified in the assembly directions.
1.
Attach Back (1) to both Sides (2). Make certain that all sides are square and that edges
overlap appropriately. Insert Bolts (11) through each hole in the corner and thread on
Nuts (11)-see Figure 1 and assembly diagrams.
Figure 1-Attaching 1 to 2
Bolts and Nuts (11)
SKU 92050
For technical questions please call 1-800-444-3353.
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
2.
3.
Attach Front (3) to both Sides (2). Make certain that all sides are square and that edges
overlap appropriately. Insert Bolts (11) through each hole in the corner and thread on
Nuts (11)-see assembly diagrams.
Connect Rear (1), both Sides (2) and Front (3) (as assembled in steps 1 and 2) to
Top Frame (8)- see Figure 2. Connect (8) to (1), (2) and (3) with Bolts and Nuts (11).
Figure 2-Part (8) to Top
(8)
4.
5.
When attaching the Top Frame (8), make certain that the bolt holes at the end of the Top
Frame (8) line up underneath the bolt holes of the Rear (1) and Front (3). Make certain that
the Bolts (11) are inserted from the outside.
Set the Cross-Beams (9) so that there are three on each side of the Greenhouse. Line them
up with the corresponding holes-see Figure 3 and the Assembly Diagram.
Figure 3-Part 10 to Cross-beam (9)
9
9
(10)
6.
7.
Attach the Window Lower Support (10) to the Center Cross-Beam (9) as shown in Figure 3.
Use Nut and Bolt (11) to secure in place. The square head of the Bolt (11) will slide into
place - see Figure 3.
Attach Window (7) to Top Frame (8). Set the Plastic Panel (7) so that it is supported by the
Panel Lower Support (10) and the Top Frame (8). Test to make certain that the Small Plastic
Panel (7) moves smoothly and adjusts with no problems.
Before assembling the plastic panels, remove the protective plastic covering from each one.
8.
Place all of the plastic Side Panels (4) into the spaces on both walls of the Greenhouse. Set
the Metal Holding Clip (12) on each side to hold the plastic Side Panels in place-see Figure 4.
9.
Place seven Roof Panels (5) along the top of the Greenhouse. Place the smaller
Top Roof Panel (6) into space on top of the Greenhouse (below Window (7). Use the
Metal Holding Clip (12) on each side to hold each plastic panel in place- see Figure 4.
SKU 92050
For technical questions please call 1-800-444-3353.
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
Figure 4-Inserting Plastic Panels
Metal Holding
Clip (12)
Inspection, Maintenance and Cleaning
1.
2.
To clean, wipe with a damp cloth, using a mild detergent. Do not use cleaners that are
combustible or corrosive. Dry with a clean, non-abrasive soft cloth.
When storing: Keep the Miniature Greenhouse in a clean, dry location.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE
TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY
KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 92050
For technical questions please call 1-800-444-3353.
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts and Assembly Diagram
Note: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
SKU 92050
For technical questions please call 1-800-444-3353.
Page 6
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly Diagram(Cont’d)
SKU 92050
For technical questions please call 1-800-444-3353.
Page 7
Download from Www.Somanuals.com. All Manuals Search And Download.
|