MODEL H6190
INDUSTRIAL AIR
SCREWDRIVER
INSTRUCTION SHEET
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
Figure 1. Model H6190.
This Industrial Air Screwdriver MUST have 3-4
drops of oil directly dropped into the air fitting
before each use as shown in Figure 2.
Introduction
This Air Screwdriver features 1,200 RPM free
speed, 3–16 in/lbs maximum torque, 90 PSI, 4
CFM average air consumption, ⁄4" NPT air inlet
1
and includes two double ended No. 2 Phillips
head drivers and male quick connect fitting.
Inventory
A. Industrial Air Screwdriver ........................... 1
1
B.
⁄4" NPT Air Fitting....................................... 1
C. Phillips Head Drivers.................................. 2
Figure 2. Lubricating directly into air fitting.
Operation
Screw the ⁄4" NPT Air Fitting on the air inlet of
the screwdriver. Pull the knurled collar back into
the screwdriver body and insert the Phillips head
driver into the socket. Twist the adjustment dial to
set the torque to your desired setting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
1
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8257 PRINTED IN TAIWAN
Download from Www.Somanuals.com. All Manuals Search And Download.
|