MODEL NO. iP217UK
TRAVEL SPEAKER FOR iPOD
OWNER'S MANUAL
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
Download from Www.Somanuals.com. All Manuals Search And Download.
SAFETY INSTRUCTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL.
DANGEROUS VOLTAGE:
INFORMATION:
This equipment has been tested and
The lightning flash with arrowhead
symbol, within an equilateral trian-
gle is intended to alert the user to
the presence of uninsulated dan-
gerous voltage within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
ATTENTION:
The exclamation point within an
equilateral triangle is intended to
alert the user to the presence of
important operating and mainte-
nance (servicing) instructions in
the literature accompanying the
appliance.
FCC WARNING:
This equipment may generate or use
radio frequency energy. Changes or
modifications to this equipment may
cause harmful interference unless the
modifications are expressly approved in
the instruction manual. The user could
lose the authority to operate this
equipment if an unauthorized change or
modification is made.
* Reorient or relocate the receiving
antenna.
* Increase the separation between the
equipment and receiver.
* Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
* Consult the dealer or an experienced
radio/TV technician for help.
SURGE PROTECTORS:
It is recommended to use a surge
protector for AC connection. Lightning
and power surges ARE NOT covered
under warranty for this product.
Download from Www.Somanuals.com. All Manuals Search And Download.
1
SAFETY INSTRUCTIONS
Before using the unit, be sure to read all operat-
on a bed, sofa, rug or other similar surface. This
product should never be placed near or over a
radiator or heat source. This product should not
be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is
provided or the manufacturer's instructions have
been adhered to.
ing instructions carefully . Please note that these
are general precautions and may not pertain to
your unit. For example, this unit may not have
the capability to be connected to an outdoor
antenna.
1. READ INSTRUCTIONS
All the safety and operating instructions should
be read before the product is operated.
2. RETAIN INSTRUCTIONS
The safety and operating instructions should be
retained for future reference.
3. HEED WARNINGS
All warnings on the product and in the operating
instructions should be adhered to.
4. FOLLOW INSTRUCTIONS
10. POWER SOURCES
This product should be operated only from the
type of power source indicated on the marking
label. If you are not sure of the type of power
supply to your home, consult your appliance
dealer or local power company. For products
intended to operate from battery power, or other
sources, refer to the operating instructions.
11. POWER-CORD PROTECTION
Power-supply cords should be routed so that
they are not likely to be walked on or pinched by
items placed upon or against them, paying par-
ticular attention to cords at plugs, convenience
receptacles, and the point where they exit from
the appliance.
All operating and use instructions should be fol-
lowed.
5. CLEANING
Unplug this product from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol
cleaners. Use a dry cloth for cleaning.
6. ATTACHMENTS
12. LIGHTNING
To protect your product from a lightning storm,
or when it is left unattended and unused for long
periods of time, unplug it from the wall outlet
and disconnect the antenna or cable system.
This will prevent damage to the product due to
lightning and power-line surges.
Do not use attachments not recommended by
the product's manufacturer as they may cause
hazards.
7. WATER AND MOISTURE
Do not use this product near water–for example:
near a bathtub, washbowl, kitchen sink or laun-
dry tub; in a wet basement; or near a swimming
pool.
13. POWER LINES
An outside antenna system should not be locat-
ed in the vicinity of overhead power lines or
other electric light or power circuits, or where it
can fall into such power lines or circuits. When
installing an outside antenna system, extreme
care should be taken to keep from touching
such power lines or circuits as contact with them
might be fatal.
8. ACCESSORIES
Do not place this product on an unstable cart,
stand, tripod, bracket or table.
The product may fall, causing
PORTABLE CART WARNING
(symbol provided by RETAC)
serious injury and serious dam-
age to the product. Use only
with a cart, stand, tripod, brack-
14. OVERLOADING
et or table recommended by the
Do not overload wall outlets and extension cords
as this can result in a risk of fire or electric
shock.
manufacturer or sold with the
product. Any mounting of the product should fol-
low the manufacturer’s instructions, and should
use a mounting accessory recommended by the
manufacturer.
15. OBJECT AND LIQUID ENTRY
Never push objects of any kind into this product
through openings as they may touch dangerous
8A. An appliance and cart combination should be
moved with care. Quick stops, excessive force
and uneven surfaces may cause the appliance
and cart combination to overturn.
9. VENTILATION
Slots and openings in the cabinet and in the
back or bottom are provided for ventilation, to
ensure reliable operation of the product and to
protect it from overheating. These openings
must not be blocked or covered. The openings
should never be blocked by placing the product
Download from Www.Somanuals.com. All Manuals Search And Download.
2
SAFETY INSTRUCTIONS
voltage points or short out parts that could result in
fire or electric shock. Never spill or spray any type
of liquid on the product.
21. DAMAGE REQUIRING SERVICE
Unplug the product from the wall outlet and refer
servicing to qualified service personnel under
the following conditions:
16. OUTDOOR ANTENNA GROUNDING
If an outside antenna is connected to the prod-
uct, be sure the antenna system is grounded so
as to provide some protection against voltage
surges and built-up static charges. Section 810
of the National Electric Code, ANSI/NFPA 70,
provides information with respect to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna dis-
charge product, size of grounding conductors,
location of antenna discharge product, connec-
tion to grounding electrodes and requirements
for grounding electrodes.
a. When the power-supply cord or plug is
damaged.
b. If liquid has been spilled or objects have
fallen into the product.
c. If the product has been exposed to rain or
water.
d. If the product does not operate normally by
following the operating instructions. Adjust
only those controls that are covered by the
operating instructions, as an adjustment of
other controls may result in damage and will
often require extensive work by a qualified
technician to restore the product to its
normal operation.
e. If the product has been dropped or the
cabinet has been damaged.
ANTENNA
LEAD IN
WIRE
f. When the product exhibits a distinct change
in performance this indicates a need for
service.
GROUND
CLAMP
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
22. HEAT
The product should be situated away from heat
sources such as radiators, heat registers, stoves
or other products (including amplifiers) that pro-
duce heat.
ELECTRIC
SERVICE
EQUIPMENT
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
23. NOTE TO CATV SYSTEM INSTALLER
This reminder is provided to call the CATV sys-
tem installer's attention to Article 820-40 of the
NEC that provides guidelines for proper ground-
ing and, in particular, specifies that the cable
ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable
entry as practical.
NEC - NATIONAL ELECTRICAL CODE
S2898A
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
17. SERVICING
Do not attempt to service this product yourself
as opening or removing covers may expose you
to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
18. REPLACEMENT P ARTS
When replacement parts are required, be sure
the service technician uses replacement parts
specified by the manufacturer or those that have
the same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
19. SAFETY CHECK
Upon completion of any service or repairs to this
product, ask the service technician to perform
safety checks to determine that the product is in
proper operating condition.
20. WALL OR CEILING MOUNTING
The product should be mounted to a wall or ceil-
ing only as recommended by the manufacturer.
Download from Www.Somanuals.com. All Manuals Search And Download.
3
LOCATION OF CONTROLS
6 VOLUME CONTROL
1 POWER BUTTON
2 SET BUTTON
7 MODE BUTTON
3 BATTERY COMPARTMENT
4 DC JACK
5 AUX IN
Download from Www.Somanuals.com. All Manuals Search And Download.
5
Setting the Clock and Date
1. Adjust the Power Switch to the off position.
2. Press the Mode Button twice to enter clock set mode.
3. First to select the Month by pressing the Set Button
4. Press Mode Button to confirm and select the Day by using the Set Button
5. Repeat the step to select Hour and Minutes
Playing an iPod
1. Connect an iPod to the Docking Station.
2. Adjust the Power Switch to the on position.
3. Adjust the Volume Switch to increase or decrease the volume of the unit.
4. Control the docked iPod using it’s native controls.
Connecting to an Audio Player using the Aux Input
1. Plug one end of a 3.5 mm Cable (not included) or a 3.5 mm - RCA Cable
(not included) into the AUX (Auxiliary) Input on the unit.
2. Plug the other end of the 3.5 mm Cable into the audio output/headphone
output on an Mp3 Player or Other Audio Source.
3. Set Power switch to the on position.
4. Remove any docked iPod’s from the Docking Station.
5. Audio played from the Mp3 Player or Other Audio Source will now be
heard on the unit.
NOTE: If connecting to the headphone output of an audio source, the source’s volume
controls may need to be adjusted for optimal sound
Control Definitions
1 Power Switch - Adjust the Power Switch to turn the unit off and on.
2 Set Button - Press the Set Button to set the clock.
3 Battery Compartment (Requires 4 x 1.5V UM-3 Batteries, not included)
4 DC Power Input - Connect the DC Power Input to a standard AC Outlet to
power the unit. (Requires an AC/DC adapter, included)
5 Aux Input -Use the Aux Input to connect an MP3 player or other audio source
to the unit.
6 Volume Switch - Adjust the Volume Switch to increase or decrease the volume
of the unit.
7 Mode Button - Press the Mode Button twice to enter clock set mode.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Specification
Power Requirement:
Input: DC 6V (4 x 1.5V UM-3 Batteries)
DC IN 9V
Accessary:
Instruction Manual x 1
iPod Adaptors x 6
6
Download from Www.Somanuals.com. All Manuals Search And Download.
LIMITED PRODUCT WARRANTY
Audio Product / Telecom Product / TV / DVD Product
This quality product is warranted to be free from manufacturer’s defects in material and workman-ship,
provided that the unit is used under the normal operating conditions intended by the manufacturer.
Should any problems arise with this product, it is highly recommended to visit our website at
trouble shooting tips have been posted on our website.
If your query remains unresolved, please feel free to email our support team at: [email protected] or call
our UK Customer helpline at: 0 800 032 5264
TERMS OF WARRANTY
Curtis International LTD warrants this product to be free from defects in materials and workmanship for 1
year on parts and 90 days on labor.
Nothing within this warranty shall imply that Curtis International LTD will be responsible or liable for any
damage to any items placed in this product, whether due to any defect of the product, or its use, proper or
improper.
This warranty is in addition to, and in no way impacts upon, your statutory rights.
TO OBTAIN REPLACEMENT / CREDIT / or REPAIRS UNDER THIS WARRANTY
1. The original purchaser must present a copy of the original bill of sale and this service warranty card.
2. Any alterations, abuse, misuse, battery corrosion or accidental damage voids the warranty.
3. The warranty does not cover cabinets and non essential accessories.
4. No warranty or insurance contained or set out shall apply when damage or repair is caused by power
failure; damage in transit by the consumer , or when moving the unit; improper power supply; use for
commercial or industrial purposes; service calls resulting in customer education, etc.
5. The defective product should be taken to your original supplier
6. Curtis International LTD reserves the right to repair or replace the parts which have become defective.
Please record the appropriate information indicated below on this Warranty Card and retain with
your proof of purchase.
Model No……………… Serial No……………………..
Date Purchased……………………………… Supplier / Retailer ………………………..
Download from Www.Somanuals.com. All Manuals Search And Download.
|