EF-S18-135mm f/3.5-5.6 IS
ENG
Download from Www.Somanuals.com. All Manuals Search And Download.
Instruction
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes or
modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. Tse limits are designed to provide reasonable protection
againshmful interference in a residential installation. This
ment generates, uses and can radiate radio frequency
y and, if not installed and used in accordance with the
inructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
a Safety Precautions
• Do not look at the sun or a bright light source
through the lens or camera. Doing so could
result in loss of vision. Looking at the sun directly
through the lens is especially hazardous.
• Whether it is attached to the camera or not, do
not leave the lens under the sun without the
lens cap attached. This is to prevent the lens from
concentrating the sun’s rays, which could cause a
fire.
Handling Cautions
• If the lens is taken from a cold environment i
a warm one, condensation may develoon th
lens surface and internal parts. To prevnt
condensation in this case, first put the lens ito n
airtight plastic bag before taking it from a cold to
warm environment. Then take out the lens after it
has warmed gradually. Do the same when taking
the lens from a warm environment into a cold one.
• Do not leave the lens in excessive heat such as in
a car in direct sunlight. High temperatures can
cause the lens to malfunction.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
This Class B digital apparatus complies with Canadian ICES-003.
ENG-2
Download from Www.Somanuals.com. All Manuals Search And Download.
Nomenclature
Focus mode switch (→ 4)
Zoom position index (→ 5)
Hood mount (→ 5)
Filter mounting
thread (→ 8)
Focusing ring (→ 4)
Zoom ring (→ 5)
Contacts
(→ 4)
Image stabilizer switch (→ 6)
Lens mount index (→ 4)
For detailed information, reference page numbers are provided in parentheses (→ **).
ENG-3
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting and Detaching the Lens
Setting the Focus Mode
1
2
See your camera’s instructions for details on
mounting and detaching the lens.
To shoot in autofocus (AF) mode, set the focus
mode witch to AF.
¡After detaching the lens, place the lens with the
rear end up to prevent the lens surface and
electrical contacts from getting scratched.
¡If the contacts get soiled, scratched, or ave
fingerprints on them, corrosion or faulty
connections can result. The camera and lens
may not operate properly.
use nly manual focusing (MF), set the focus
de switch to MF, and focus by turning the
focusing ring.
¡Do not touch the rotating parts of the lens while
autofocus is active.
¡Do not adjust focus manually when the focus
mode switch is set to AF.
¡If the contacts get soiled or have fingerprints on
them, clean them with a soft cloth.
¡If you remove the lens, cover it with the dust
cap. To attach it properly, align the lens mount
index and the ¢ index of the dust cap as shown
in the diagram, and turn clockwise. To remove
it, reverse the order.
ENG-4
Download from Www.Somanuals.com. All Manuals Search And Download.
Hood (Sold Separately)
Zooming
3
4
The EW-73B hood can keep unwanted light out
of the lens, and also protects the lens from rain,
snow, and dust.
To attach the hood, align the hood’s attachme
position mark with the red dot on the front of t
lens, then turn the hood as shown by tharrow
until the lens' red dot is aligned with the oods
stop position mark.
To zoom, turn the lens’ zoom ring.
minmum focusing distance differs at
derent focal lengths.
18mm: 0.49 m / 1.6 ft.
50mm: 0.47 m / 1.5 ft.
135mm: 0.45 m / 1.5 ft.
Shooting magnification
18mm: 0.05×
50mm: 0.12×
135mm: 0.21×
The hood can be reverse-mounted on the lens
for storage.
¡Part of the picture may be blocked if the hood is
not attached properly.
¡When attaching or detaching the hood, grasp
the base of the hood to turn it. To prevent
deformation, do not grasp the rim of the hood to
turn it.
Be sure to finish zooming before focusing.
Changing the zoom ring after focusing can affect
the focus.
ENG-5
Download from Www.Somanuals.com. All Manuals Search And Download.
Image Stabilizer
5
You can use the image stabilizer in AF or MF
mode.
¡The Image Stabilizer cannot compensate for a
blurred shot caused by a subject that moved.
¡The Image Stabilizer may not be fully effective if
you shoot from a violently shaking vehicle or
other transportation.
This function provides optimal image stabilization
depending on shooting conditions (such as
shooting still subjects and following shots).
¡The Image Stabilizer consumes more power
than normal shooting, so fewer shots can be
taken if you use the function.
¡Wen shooting a still subject, it compensates for
camra shake in all directions.
¡It compensates for vertical camera shake during
following shots in a horizontal direction, and
compensates for horizontal camera shake
during following shots in a vertical direction.
¡Using a tripod also stabilizes the image.
However, depending on the kind of tripod and
shooting conditions, sometimes it may be better
to turn off the Image Stabilizer function.
Set the STABILIZER switch to
¡If you are not going to use the image
stabilizer function, set the switch to
1
.
When you press the shutter button
¡The stabilizer is equally effective for hand-held
photography and photography with a monopod.
2halfway, the Image Stabilizer will
start operating.
¡
The image stabilizer function also operates when the
lens is used with an Extension Tube EF12 ll or EF25 ll.
If you set the camera’s Custom Function to change the
assigned button to operate the AF, the Image Stabilizer will
operate when you press the newly assigned AF button.
¡Make sure the image in the viewfinder is
stable, then press the shutter button the
rest of the way down to take the picture.
¡
ENG-6
Download from Www.Somanuals.com. All Manuals Search And Download.
Image Stabilizer
The image stabilizer in this lens is effective for hand-held shots under the following
conditions.
¡In semi-darkened areas such as indoors or
outdoors at night.
¡When panning subjects in motion.
¡In locations where flash photography is
prohibited, such as art museums and theater
stages.
¡In situations where your footing is uncertain.
¡In situations where fast shutter settings cannot
be used.
ENG-7
Download from Www.Somanuals.com. All Manuals Search And Download.
Filters (Sold Separately)
Extension Tubes (Sold Separately)
6
7
You can attach filters to the filter mounting
thread on the front of the lens.
You can attach Extension Tube EF12 II or EF25
II for magnified shots. The shooting distance and
magnification are shown below.
¡Only one filter may be attached.
¡If you need a polarizing filter, use the Canon
Circular Polarizing Filter PL-C B (67mm).
¡To adjust the polarizing filter, first remove the
lens hood.
Camera-to-Subject
Magnification
Distance (mm)
Near
304
252
Far
Incompatible
1551 0.38×
Incompatible
806 0.59×
Near
Far
18mm
135mm
18mm
EF12 II
EF25
0.09×
0.21×
35mm
Manual focusing is recommended for accurate
focusing.
ENG-8
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
8
Focal Length/Aperture
Lens Construction
Minimum Aperture
Angle of View
18 – 135 mm f/3.5 – 5.6
12 groups, 16 elements
f/22 – 36*1
Diagonal: 74° 20’ – 11° 30’
Horizontal: 64° 30’ – 9° 30’
0.45 m/1.5 ft. (at 135mm)*2
0.21× (at 135 mm)
327 × 503 mm/12.9 × 19.8 inch (at 0.49 m/1.6 ft.) –
75 × 112 mm/3.0 × 4.4 inch (a0.45 m/1.5 ft.)
67 mm/2.6 inch
Vertical: 45° 30’ – 6° 20’
Min. Focusing Distance
Max. Magnification
Field of View
Filter Diameter
Max. Diameter and Length
Weight
Hood
75.4 × 101 mm/3× 4inch
455 g/16.0 oz
EW-73B Sold setely)
E-67/E-67 II
Lens Cap
Case
LP1116 (Sold separately)
*1 Applies to 1/3-stop increments. With 1/2-stop increments, it will be f/22-38.
*2 The minimum focusing distance differs at different focal lengths.
¡Equivalent to 29-216 mm in the 35mm film format.
¡The lens length is measured from the mount surface to the front end of the lens. Add 21.5 mm to include the E-67
lens cap and dust cap, and 24.2 mm for the E-67 II.
¡The size and weight listed are for the lens only, except as indicated.
¡The EF1.4X II/EF2X II extenders cannot be used with this lens. There are no compatible close-up lenses.
¡Aperture settings are specified on the camera. The camera automatically compensates for variations in the
aperture setting when the camera is zoomed in or out.
¡All data listed is measured according to Canon standards.
¡Product specifications and appearance are subject to change without notice.
ENG-9
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
0812Ni © CANON INC. 2009
CT1-8565-007
|