Boston Acoustics Speaker 65LF User Manual

The Boston Acoustics ProSeries 6.5LF Woofer is a powerful 61/2-inch driver specifically designed to handle low-  
frequency and mid-bass signals down to the subwoofer crossover point. The circuit described here allows the  
6.5LF to added on to existing full-range speaker systems to augment output below 300Hz.  
This crossover is easily built using very few components. It is very useful in systems with limited mid-bass output  
in the front stage, or systems where the mid-bass output is coming from the rear of the car and additional mid-  
bass output is desired in the front of the vehicle. As you can see from the frequency output curve on the right,  
there is no low-frequency cutoff in this crossover. Instead, it is preferable to use a two-way electronic crossover  
between the 6.5LF woofers and the subwoofer in the system. In applications where no subwoofer is present, this  
crossover also allows the 6.5LF to be the primary deep-bass driver in the system.  
+5dB  
0dB  
-5dB  
-10dB  
-15dB  
-20dB  
20Hz  
100Hz  
1kHz  
10kHz  
20kHz  
Crossover output  
Woofer Installation  
When installing the 6.5LF Woofer, it is important to ensure a complete seal between the front and back of the  
woofer. A very small air leak anywhere near the woofer can dramatically reduce low frequency output and nega-  
tively affect the frequency response of the driver. Additionally, it is very important to securely mount the woofer on  
a rigid baffle. Any energy that moves or vibrates the baffle is energy that is not accurately reproducing sound. The  
woofer cone should be nearly coplanar with the baffle board. Spacing the woofer off from the baffle or recessing  
the woofer too far into a cavity can introduce anomalies in the frequency response of the driver.  
The 6.5LF Woofer is designed for infinite baffle applications. In most installations it will be mounted in the door of  
the vehicle without a separate enclosure. If it is necessary to build an enclosure to house the woofer, the enclosure  
should be relatively large. For a 61/2-inch woofer, a 1/4-cubic foot or larger enclosure is sufficient. When construct-  
ing an enclosure, be sure that the airspace inside is completely sealed from the outside air.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Belkin Surge Protector F9A1033 12 User Manual
Black Box Computer Accessories NBDEP 12 User Manual
Bosch Appliances Radio LE10 User Manual
Bose Bluetooth Headset 10 User Manual
Boston Acoustics Speaker MM 220 User Manual
Cabletron Systems Switch 9A100 User Manual
Casio Digital Camera EX Z30 EX Z40 User Manual
Casio Digital Camera QV 2000UX Ir User Manual
Christie Digital Systems Projector P35GPS AT User Manual
Cisco Systems Camcorder Mino2HD User Manual