Barco Microscope Magnifier PDS 902 User Manual

Barco, Inc.  
Toll Free: +1 (888) 414-7226  
Fax: +1 (916) 859-2515  
Technical Support: +1 (866) 374-7878  
PDS Series  
Quick Start Guide  
Visibly yours  
Menu Display  
Adjust  
SEL  
Inputs Section  
Button States  
Use ADJUST knob,  
plus SEL and ESC  
buttons to navigate  
menus.  
Counter-clockwise: scroll down  
menu tree, or decrement values.  
Press to enter a menu,  
change or accept a  
parameter, or answer  
Yes” to a query.  
Sources 1-4: Analog  
Sources 5-8*: DVI or Analog  
Off: Input not selected  
Blinking: Input “pending” for transition  
Lit solid: Input on Program  
Clockwise: scroll up menu tree,  
or increment values.  
SDI: 3G/HD/SD-SDI  
LOGO: Full screen capture  
* (sources 7-8 not on PDS-701)  
Inputs  
PDS-902  
PROGRAM:  
NEXT:  
RGB  
SDI  
4
3
5
6
7
8
SEL  
ESC  
1
2
SDI  
LOGO  
TAKE  
FRZ  
BLACK  
Adjust  
NTSC (480i)  
Effects  
NOTE  
ESC  
FRZ  
BLACK  
TAKE  
After each  
TAKE, Program  
and pending  
Press to exit a menu  
without making changes,  
cancel an operation, or  
answer “No” to a query.  
Press to freeze or  
un-freeze current  
Program source.  
Lit solid = frozen.  
Press to pend or initiate a black transition.  
Black Auto Take mode affects function  
(User Preferences). Blinking = Pending.  
Lit solid = Black on Program.  
Press to mix the selected input  
to Program, or to execute a pending  
black transition. Use the Setup Menu  
to adjust the transition time.  
sources flip-flop.  
Factory Reset When using a PDS for the first  
time, perform a factory reset. (Chapter 4,  
“Factory Reset Menu”)  
Repeat for Each Input Repeat steps 10 and  
11 for each input that you have connected to the  
PDS.  
5
12  
13  
14  
15  
16  
Quick Setup and Operations  
Launch GUI (Optional) Connect your laptop to the  
PDS, log onto the PDS using its IP address, and  
launch the GUI. (Chapter 5, “GUI Operations”)  
Adjust System Parameters Adjust parameters  
such as transition time, display brightness, user prefs.  
(Chapter 4, “User Preference Menu,” “System Menu”)  
6
7
The following list summarizes PDS setup and  
operations. For error-free installation, always  
refer to the listed section in the User’s Guide.  
Set Output Format Set the desired output  
resolution and frame rate. (Chapter 4, “Output  
Format”)  
Save System Configuration After completing all  
system adjustments, save the system configuration.  
(Chapter 4, “Save System State”)  
Enable Test Pattern Turn on a test pattern, verify  
an image, and adjust as required. When complete,  
turn off the pattern. (Chapter 4, “Test Pattern”)  
Enable Remote Control (Optional) Connect  
Ethernet or Serial communications, and issue desired  
commands. (Appendix B, “Remote Control”)  
Connect Power Ensure that power is properly  
connected to the PDS. (Chapter 3, “Cable and  
Adapter Information”)  
8
1
2
3
4
Save Output Configuration After completing all  
output adjustments, save the output configuration.  
(Chapter 4, “Save Config”)  
Ready to Roll With all output, input and system  
configurations saved, press the desired input button,  
and press TAKE.  
Connect Inputs Connect all analog, DVI, and  
SDI input sources to the PDS. (Chapter 3, “Signal  
Installation”)  
9
Select and Adjust Input Select an input, and  
perform the necessary image adjustments. (Chapter  
4, “Input Menu”)  
Connect Outputs Connect the output(s) of the  
PDS to your projector(s) or other target devices.  
(Chapter 3, “Signal Installation”)  
10  
11  
Save Input Configuration After completing all  
adjustments for an input, save the input configuration.  
(Chapter 4, “Save Config”)  
Power On Turn on power to the PDS, your  
projector(s), and to all peripheral equipment.  
(Chapter 4, “Power-Up Initialization”)  
P/N 26-1204004-00 Rev 01  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Actiontec electronic Network Card 802UI3 User Manual
Actiontec electronic Network Router UD800TP User Manual
ADT Security Services Home Security System 3000EN User Manual
AEG Microwave Oven MCC3880E M User Manual
American DJ DJ Equipment BU 200 User Manual
AO Smith Water Heater AOSRG45700 User Manual
Atlona TV Cables AT HD30SR User Manual
Audiovox Remote Starter 128 4246A User Manual
Axis Communications Security Camera P5414 E User Manual
Beko Flat Panel Television 40WLU530HID User Manual