ADDONICS TECHNOLOGIES
Model: RT5835HMEU
I.
Installing drive into the RAID Tower V
Step 1
Set A (4-drive HPM)
Use a Philips screwdriver to secure the 3.5”
SATA hard drive to the drive tray
Step 2
Slide the tray into the Disk Array drive bay.
Note: It is recommended to fill up the RAID
Tower V with SATA drives from right to left
and top to bottom. This is to help in identifying
which drives connect to which ports for easier
Set B
(4-drive HPM)
troubleshooting.
II. Connecting the power cable and RAID Tower V to the
computer
a. Connect the power cord provided from the wall outlet to the back of
the RAID Tower.
b. Make sure the power is off (power LED light should be off).
Set A (4-drive HPM)
Set B (4-drive HPM)
c. Connect either the provided USB or eSATA cable from the back of
the RAID Tower to the computer. We recommend connecting the
eSATA port for best performance if this port is available on your
computer.
Photo identifying SATA port s on HPM
LED pins
SATA
RAID
setting
button
Port 3
SATA
Port 1
USB port
Pin 1
RAID config
rotary switch
SATA
SATA
Port 2
Port 4
eSATA port
Power Switch
Power Connector
III. Power on/off control
Turn on the power to the RAID Tower Mini by pressing the power
button on the front. The power LED light should lit indicating the power
is on.
IV. Setting RAID on the HPM
1. Attach the SATA hard drives (up to 4) to the SATA ports on the
Hardware Port Multiplier (HPM) using SATA cables. It is
recommended to connect drives to the SATA ports 1 to 4
successively.
2. Set the Rotary switch to the RAID mode required.
3. Push the RAID setting button with a ballpoint pen tip while the HPM
is turned off.
Power LED
Power Switch
HPM 1 (Top disk array)
(LED 1) HPM Health
Use a ballpoint pen
tip to press the
RAID Setting Button
(LED 2) eSATA Status
(LED 3) USB Status
4. While holding the RAID setting button, turn on the HPM and SATA
hard drives and continue to hold button for at least 5 seconds.
HPM 2 (Bottom disk array)
(LED 1) HPM Health
(LED 2) eSATA Status
(LED 3) USB Status
Note:
The onboard LED's for the eSATA and USB will start blinking
while holding down the raid setting button. Once the raid
setting button is released, the PM Health LED will blink 4-6
times.
If the PM Health LED stops blinking, the raid set is set
correctly. If the PM Health LED lights up as solid green, it is a
bad setup. You need to repeat setting up the raid again.
Download from Www.Somanuals.com. All Manuals Search And Download.
|