IVM 4
SPC 4 - ESSENTIALS
© AKG Acoustics 2008
Download from Www.Somanuals.com. All Manuals Search And Download.
SPC 4: SETUP
Headline
Cascaded SPC 4 Setup:
Single-stage cascaded SPC 4
Power only the SPC 4!
(Power for SST not needed)
Use the PSU4000 to power IVM
and WMS Systems!
NOTE: AKG recommends to use one SPC 4 / one antenna per 4 channels SST 4!
Contact your local AKG dealer before using a single-stage cascaded SPC 4!
Download from Www.Somanuals.com. All Manuals Search And Download.
SPC 4: Multichannel Conditions
Headline
RF Power Level at SST 4
10mW
20mw
50mW 100mW
No. of channels
1
2
3
4
5
NOTE: AKG recommends to use only single SPC 4 setups!
6
7
8
9
10
11
12
13
14
15
16
... Possible
... Please contact your local AKG dealer
... Not possible
Download from Www.Somanuals.com. All Manuals Search And Download.
5
SPC 4: KEEP IN MIND!
ꢀ Use only passive AKG antennas with SPC 4: SRA2W or RA4000W
ꢀ Use short cable lengths between SPC 4 and antenna: Maximum is 10m for a RG58 cable
ꢀ Set SST 4 RF output power according to slide: ‘SPC 4 Multichannel Conditions’
ꢀ All connected SST 4 transmitters should operate in the same frequency band
ꢀ LED Status
ꢁ Green: System is working fine
ꢁ Red: The antenna combiner has overheated or no AKG antenna is connected. The
internal amplifier shuts down in both cases.
ꢀ The SPC4 has two power supply jacks
ꢁ One to power the SPC 4: labeled DC ONLY- 12V/1.4A - SPC4
ꢁ One to power all connected SST 4: labeled DC ONLY – 12V/2A – SST Power Supply
ꢀ If you are NOT using the PSU 4000
ꢁ Power the SPC 4 with the CU 4000 power supply (AC-CU4000, 1.4A)
ꢁ Power all connected SST 4 separately with the provided power supply (AC12, 500mA)
Download from Www.Somanuals.com. All Manuals Search And Download.
|