Eizo 2100W User Manual

NOTE  
Please be careful not to scratch the LCD panel or the cabinet with the panel protector during installation. Also  
please do not remove the panel protector often. It may scratch or result in damage to the LCD panel.  
The panel protector has a non-glare treatment side and a glossy side. Use preferable side.  
When using LCD monitor with optional panel protector, it is preferable to avoid using downwards. In this  
condition, the panel protector might become bend or slip out from the monitor.  
Installation  
Before installation, please remove dust and stains from the LCD panel.  
1.  
2.  
3.  
Stopper  
Lever  
1. Set the panel protector into the grooves of the panel frame; the lower first (1), then the upper  
(2).  
2. With the enclosed tool (Lever) set the tabs of the panel protector into the side grooves (4 tabs).  
Put the lever on the tabs of the panel protector and move it toward the LCD panel to install. Position the protector  
into the LCD panel tightly without leaving an opening.  
For the recommendation, please use the stoppers to prevent the panel protector from bending or  
slipping out from the monitor.  
3. Before installation the stoppers, please remove dust and stains from the cabinet of the monitor.  
Follow these steps to install the stoppers.  
1. Remove the protection paper from the stoppers.  
2. Position the stoppers to the tab of the panel protector and install them on the cabinet of the monitor.  
Removing  
Release the stoppers from the cabinet. Put the lever on the tabs of panel protector and move it toward the  
cabinet to remove.  
Cleaning  
NOTE  
Please be sure to keep the panel protector immobilized while cleaning it. Otherwise it may scratch the surface of  
the LCD panel. To hold the panel protector by hand, use a soft cloth to avoid dust or finger prints.  
Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or other strong  
solvents, as these may cause damage to the cabinet or panel.  
It is recommended to use EIZO cleaning kit "ScreenCleaner" (option) to clean the panel.  
The panel surface can be cleaned with a soft cloth such as cotton or lens paper.  
If necessary stubborn stains can be removed by moistening part of the cloth with water to enhance its  
cleaning power.  
Specification  
Surface treatment  
Coating strength  
Light transmission  
Dimension/ Weight  
Non-glare side: non glare hard coating / Glossy side: hard coating  
2H  
More than 90 %  
FP-2100W: 456.5 mm (W) × 286.6 mm (H) × 1.0 mm (D) / approx. 158 g  
FP-2400W: 521.1 mm (W) × 327.3 mm (H) × 1.0 mm (D) / approx. 210 g  
Lever (for Panel Protector), Stoppers x 4, User’s Manual  
Accessories  
Copyright© 2006 EIZO NANAO CORPORATION All rights reserved.  
00N0L252A1  

Hauppauge HD PVR High Definition Video Recorder for Windows 1212 User Manual
GE ZHU36RSMSS User Manual
GE TC28031 Series User Manual
Dell Daily Deal E1909W User Manual
Crestron electronic Crestron Electronics Computer Hardware 2 Series Control Processor User Manual
Compaq C160 User Manual
Belkin F8E846 BNDL DB User Manual
Atlantis Land A05 17AM C06 User Manual
ALCATEL Mobile Phones F200 User Manual
Aiphone Corded Headset AI HS100 User Manual