A T International E5813B User Manual

Quick start guide  
E5812B/E5813B/E5814B/  
E1812B/E1813B/E1814B  
5.8 GHz cordless telephone/  
answering system with  
caller ID/call waiting  
Telephone base installation  
1. Plug the small end of the larger  
power adapter into the power jack at  
the bottom of the telephone base.  
2. Plug the end of the telephone line  
cord into the telephone jack at the  
bottom of the telephone base.  
3. Route cords through  
slots.  
DSL filter  
(Optional for DSL users, see  
number four in the note  
section, below.)  
4. Plug the large end of  
the larger power adapter  
into an electrical outlet  
not controlled by a wall  
switch.  
Telephone line cord  
5. Plug the other end of the telephone  
line cord into a telephone jack.  
8. You may be able to  
make or receive short  
calls. For best perform-  
ance, place the handset  
in the telephone base  
to charge for at least 16  
hours before first use.  
6. Plug the small end of  
the smaller power adapter  
into the jack on the under-  
side of the charger, then  
route the cord through the  
slot as shown.  
7. Plug the large  
end of the smaller  
power adapter into  
an electrical outlet  
not controlled by a  
wall switch.  
NOTES:  
1. Use only the power adapter supplied with this product or equivalent. To order a replace-  
or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.  
2. Be sure to use an electrical outlet not controlled by a wall switch.  
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.  
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and  
you are experiencing interference during telephone conversations and/or your caller ID features  
are not functioning properly, install a DSL filter to the telephone line between the telephone base  
and the telephone wall jack. Contact your DSL service provider for a DSL filter.  
Quick reference guide  
Cordless handset  
DIR /VOLUME+  
CID/-VOLUME  
While in a menu, press to scoll up.  
When in idle mode, press to dis-  
play directory entries. While enter-  
ing names, press to advance the  
cursor. During a call, press DIR to  
increase listening volume.  
While in a menu, press to scoll  
down. When in idle mode, press  
to display call summary entries.  
While entering names or num-  
bers, press to move the cursor to  
the left. During a call, press CID  
to decrease listening volume.  
OFF/CLEAR  
PHONE/FLASH  
During a call, press to hang up.  
While using menus, press to  
cancel an operation, or exit the  
menu.  
Press to make or answer a call.  
During a call, press to receive  
an incoming call if call waiting is  
activated.  
CHAN/DELETE  
MENU/SEL/TRANSFER  
When on a call, press CHAN/DELETE  
to scan for a clearer channel when  
there is static or interference on  
the line. When in caller ID mode,  
press to delete the displayed call-  
er ID entry, or press and hold to  
delete all caller ID entries.  
Press to display a menu or to con-  
firm a command. During a call,  
press to transfer a call between  
handsets.  
MUTE  
While on a call, press to mute  
microphone. Press again to resume.  
SPEAKER  
REDIAL/PAUSE  
Press to activate handset speak-  
erphone. Press again to resume  
normal handset use.  
While in idle mode, press to display  
last number called. While dialing or  
entering numbers to the directory,  
press to insert a four-second dial-  
ing pause.  
Feature menu  
DIRECTORY  
Feature menu  
Using menus  
DIRECTORY  
SPEED DIAL  
RINGER  
DATE/TIME  
DIAL MODE  
LANGUAGE  
Press CID or DIR  
menu items.  
to scroll through  
Press MENU/SEL to select or modify a  
highlighted item.  
Press  
OFF/CLEAR to cancel an oper-  
ation, or exit the menu display.  
NOTE: For more information, please refer to the user's manual.  
Quick reference guide  
Telephone base  
CHARGE/IN USE  
Flashes when one of the  
handsets is in use.  
Flashes when the answer-  
ing system is answering an  
incoming call.  
HANDSET LOCATOR  
Flashes quickly while an  
incoming call is ringing.  
Press to make the handsets  
beep when there is no hand-  
set on the telephone base.  
On steady when the hand-  
set is properly positioned to  
charge in the telephone base.  
SETUP  
ANNC.  
Press to review or change  
answering system options.  
Press to review or record  
announcement; press  
again to quit.  
MESSAGE COUNTER  
Number of messages (or  
during playback, message  
number currently playing).  
RECORD  
Press to record a memo  
or after pressing ANNC.  
to record an outgoing  
announcement.  
CLOCK  
Press to review or set clock.  
DELETE  
Press to delete message  
currently playing; press and  
hold to delete all old mes-  
sages.  
ANSWER ON  
Press to turn answering  
system on or off.  
REPEAT  
VOLUME  
Press to repeat message;  
press twice to play previous  
message.  
Press to adjust playback  
volume.  
SKIP  
PLAY/STOP  
Press to skip message.  
Press to start or stop mes-  
sage playback.  
NOTE: For more information, please refer to the user's manual.  
© 2007 Advanced American Telephones. All rights reserved.  
AT&T and the AT&T logo are trademarks of AT&T Knowledge Ventures,  
licensed to Advanced American Telephones. Printed in China. Issue 5 AT&T 06/07.  
96-006296-030-100  

Hamilton Beach 840113300 User Manual
Fagor America 3FIA 95GLST X User Manual
EVGA P55 SLI User Manual
Electrolux SG 424 User Manual
Electrolux EHD 6005 P User Manual
ELAN Home Systems U102110 07 User Manual
D Link Cardbus PC card DFE 690TXD User Manual
DFI ES300 User Manual
Asus Desktop Motherboard P8Z77VLEPLUS User Manual
AOC LM760S User Manual