Radio Shack PLCD34 User Manual

PLCD34  
INSTRUCTION MANUAL  
OPEN  
FLIP DOWN DETACHABLE CD PLAYER  
DSP  
BD  
FLAT CLASS ROCK POP  
TRACK  
LOC  
LOUD MUTE DISC  
RPT  
RDM INT  
CH  
power  
LUD  
CLK  
CDP  
SEL  
COMPACT  
AP  
RDM  
4
INT  
3
RPT  
TOP  
UP  
DN  
DIGITAL AUDIO  
+
-
2
5
6
1
LO  
MU  
160WATTS  
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM  
AUTO-LOADING COMPACT DISC PLAYER  
AM/FM STEREO WITH DIGITAL TUNING RADIO  
INSTALLATION  
DISC PLAY:  
Cleaning discs  
Before playing, clean the disc with a clean, lint-free.  
Flip the disc in the direction of the arrow.  
DASH BOARD  
METAL MOUNTING STRAP  
HEX NUT  
SPRING WASHER  
CONSOLE  
PLAIN WASHER  
PLAIN WASHER  
SLIDE BRACKET HOUSING  
TAPPING SCREW  
HEX BOLT  
NOTE:  
Do not use so solvents such as benzine, thinners. Commercially available  
cleaners or anti static spray damage the unit.  
Insert a disc with the label surface down. Doing so may damage the unit.  
Label  
surface up  
KEY PLATE  
PLASTIC TRIM OUT  
NOTE:  
Do not try to insert another disc when one has been already inserted.  
Doing so may damage the unit.  
KEY PLATE  
Handle the disc by its edge. And to keep the disc clean, do not touch  
the surface.  
While installing the front panel,  
please mount the left side first,  
then push the right side.  
Do not stick paper or tape on the disc.  
Do not expose the disc to direct sunlight or heat sources such as hot air  
ducts. Or leave it in a car parked in direct sunlight where there can be a  
considerable rise in temperature.  
9
2
LOCATION AND FUNCTION OF CONTROLS  
SPECIFICATION  
GENERAL  
1
2
3
8
4
5
6
7
9
Power requirement..............................................................................................DC 13.8V.  
Current consumption..............................................................................................7A MAX.  
Power output.........................................................................................................40W X 4  
OPEN  
FM SECTION  
FLIP DOWN DETACHABLE CD PLAYER  
DSP  
BD  
FLAT CLASS ROCK POP  
TRACK  
LOC  
LOUD MUTE DISC  
RPT  
RDM INT  
CH  
power  
LUD  
Frequency range.....................................................................87.5MHz -108.0MHz(EUROPE).  
Frequency range...........................................................................87.5MHz -107.9MHz(USA).  
CLK  
CDP  
SEL  
COMPACT  
AP  
Usable sensitivity.........................................................................................................3uV.  
I.F Frequency........................................................................................................10.7MHz.  
RDM  
4
INT  
3
RPT  
TOP  
UP  
DN  
DIGITAL AUDIO  
+
-
2
5
6
1
LO  
MU  
AM(MW) SECTION  
Frequency range........................................................................522KHz - 1620KHz(EUROPE).  
Frequency range............................................................................. 530KHz - 1710KHz(USA).  
10 11  
12  
13 14 15  
LINE - OUT [OPTION]  
Output...............................................................................1000mV @ FM 10% THD POWER.  
Impedance............................................................................................................600 ohm.  
CD PLAYER  
1. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTONS  
Press SEL button to change the mode in the sequence of  
VOL BAS TRE BAL FAD  
System........................................................................................compact disc audio system.  
Usable disc......................................................................................................compact disc.  
Signal format.............................................................................sampling frequency 44.1KHz.  
No of quantization bits 1bit.  
Frequency characteristics...............................................................................5-40Hz < 5dB  
10K-20KHz < 5dB.  
1). The volume level can be adjusted at any time by pressing the audio level+ or  
- button as select mode has been initially defaulted at volume mode.  
2). The volume level is also obtained by stepping through the SEL button until  
the character VOL is displayed and then press + or - button to adjust the  
sound level.  
Signal to noise radio................................................................70dB [1KHz] [IEC - A net work].  
Number of channels..............................................................................................2 STEREO.  
Chassis dimensions.......................................................................178[W] X 50[H] X 150[D].  
3). Press and hold the + or - button to adjust the sound level.  
BASS CONTROL  
1). Press the SEL button to select the bass mode until BAS appears on the display.  
2). Press + or - to adjust the bass effect.  
USA  
EUROPE  
IMPORTANT:  
TREBLE CONTROL  
This radio is set to USA frequency by factory, if European  
frequency is required please flip the frequency step switch on  
the side of the unit.  
1). Press the SEL button to select the treble mode until TRE appears on the display.  
2). Press + or - to adjust the treble effect.  
After the switchover of the frequency switch, the frequency convert  
function will not be valid until the RESET button has been pressed.  
3
8
BALANCE CONTROL  
TROUBLE SHOOTING  
1). Press the SEL button to select the balance mode until BAL appears on LCD.  
2). Press the + button or - button to increase or decrease the sound level  
of left or right speaker.  
Before going through the check list, wiring connection, should any of the  
problem persist after check list has been made, consult your nearest service  
dealer.  
FADER CONTROL  
1). Press the SEL button to select the fader mode until FAD appears on LCD.  
2). Press the + button or - button to increase or decrease the sound level  
of front or rear speaker.  
Symptom  
No power  
Cause  
Solution  
The car ignition is not on.  
If the power supply is properly  
connected to the car accessory  
switch the ignition key to " ACC "  
2. OPEN BUTTON  
The fuse is blown  
Replace the fuse  
Press it to flip down the front panel when you want to take away.  
Press it to flip down the front panel then you can insert a disc into the  
slot or eject a disc from the slot by pressing the EJ button which located  
the back of the panel.  
Presence of CD disc inside  
the player  
Remove the disc in the player  
then put a new upward  
Disc cannot  
be loaded or  
ejected  
Inserting the disc in upside  
down  
Insert the compact disc with  
the label facing upward  
Compact disc is extremely  
dirty or defective  
Clean the disc or try to play a  
new one  
3. LOUD( LOUDNESS) BUTTON  
Press "LOUD" to enhance the bass sound effect while reduce the volume  
half level .  
Temperature inside the  
car is too high  
Cool off until the ambient  
temperature returns to normal  
Condensation  
Leave the player off for an  
hour or so, then try again  
4. DSP( DISPLAY) BUTTON  
Volume is in minimum  
Adjust volume to a desired level  
Press it to apply these function, and press it continually to switch  
between 4 preset equalizer curves: FLAT POP, CLAS, ROCK.  
And the sound quality will be accordingly changed. (FLAT IS INITIAL  
DEFAULT)  
No sound  
Wiring is not properly  
connected  
Check wiring connection  
The operation  
keys do not  
work  
The built-in microcomputer  
is not operating properly  
due to noise  
Press the RESET button  
front panel is not properly  
fix into its place  
5. CLOCK ADJUSTMENT BUTTONS  
During RADIO or CD state, press this button to change to clock function.  
Hold this button for more than 2 seconds until the time flashes on LCD,  
then you can adjust Hours and Minutes by pressing UP and DN button.  
After adjustment, press this button to resume normal play state and  
remain the adjustment.  
The installation angle  
is more than 30 degrees  
Adjust the installation angle  
to less than 30 degrees  
Sound skips  
The disc is extremely  
dirty or defective  
Clean the compact disc/try to  
play a new one  
The radio does  
not work  
the radio  
Insert the antenna cable firmly  
select a station manually  
The antenna cable is not  
connected  
the signals are too weak  
station  
6. LCD ( LIQUID CRYSTAL DISPLAY)  
automatic  
selection does  
not work  
7
4
14. AS/PS BUTTON  
Select 6 strong stations and store them in current band.  
Select a band( if needed)  
7. CD  
( CD PLAY, PAUSE) BUTTON  
button to switch to CD mode. At CD mode,  
At radio mode, press  
press it to pause the CD program and press it again to resume CD  
playback.  
Hold AS/PS button for more than 3 seconds. The news stations will replace the  
stations already stored in that band.  
Scan stations in current band  
Select a band( if needed).  
8. BAND BUTTON  
Press AS/PS button for less than 3 seconds. Radio pauses for 5 seconds  
at each station. Press AS/PS again to stop scanning when desired stations  
is reached.  
During CD mode, press it to switch to radio mode.  
During radio mode, press it to select your desired radio band and word  
which band is selected will be displayed on LCD.  
15. [TUNE/SEEK UP] BUTTON and TRACK UP BUTTON  
9. POWER BUTTON  
Press the button to turn on or off the unit.  
1). The frequency scans up by one step when pressing UP button once (50k for  
Europe,200k for USA).  
Hold it for more than 2 seconds to seek for a station of higher frequency.  
10. INFRA-RED RECEIVING WINDOW  
2). During CD mode, press UP button allow you to track forwards.  
Hold the UP button allow you to skip forwards.  
11. LOCAL/DISTANCE BUTTON  
Press it for distance reception when you are located at weak signal location,  
depress it for a stronger signal.  
[TUNE/SEEK DOWN] BUTTON and TRACK DOWN BUTTON  
1). The frequency scans down by one step when pressing DN button once(50k  
for Europe,200k for USA).  
12.PRESET STATION [ 1-6 ] / TOP, RPT, INT,RDM.  
A]. To memorize the current frequency, press and any one of the six preset  
buttons for more than 2 seconds.  
Hold it for more than 2 seconds to seek for a station of lower frequency.  
2). During CD mode, press DN button allow you to track backwards.  
Hold the DN button allow you to skip backwards.  
B]. To recall the preset memory, press one of the preset button [1-6].  
C]. TOP BUTTON  
Speaker Connection  
Press the button during playback to return to the first track of CD.  
ANTENNA PLUG  
D]. REPEAT BUTTON  
Press the button to continuously repeat same track. Press again to  
stop repeating.  
12 P  
YELLOW  
E]. INT: Preview all tracks  
MEMORY B+  
FUSED  
FILTER  
BOX  
0.5A &7A  
FUSES  
RCA LINE OUT  
RED R  
Press INT to play first ten seconds of each track on current CD. Press  
it again to stop scanning to play your desired track.  
BLACK(GND)  
WHITE L  
RED (B+)  
F]. Random button: play all tracks  
BLUE AUTO ANT  
+
Press it to play all tracks on CD in random order. Press again to stop  
random play  
+
FRONT  
GRAY  
WHITE  
FRONT  
RIGHT  
SP  
WHITE/BLACK  
GRAY/BLACK  
VIOLET  
LEFT  
SP  
+
+
GREEN  
13. MUTE BUTTON  
Press this button to eliminate the sound temporarily and press it again  
to resume normal play state.  
REAR  
REAR  
GREEN/BLACK  
VIOLET/BLACK  
NOTE:  
Make sure use a 4-ohm impedance speaker in spite of having any kinds of  
speaker system to reduce the distortion during high volume level.  
5
6

Wibur Curtis Company CAFE PC3 User Manual
Waring CU 55 User Manual
Sony D EJ925 User Manual
Siemens ST55 User Manual
Seagate Computer Drive ST760211DE User Manual
Seagate BARRACUDA ST1181677LC User Manual
Samsung SGH F480 User Manual
Samsung Cell Phone s 4 mini sprint User Manual
Radio Shack 63 1088 User Manual
Presto Coffeemaker User Manual