Note:
The normal function of the product may be disturbed by interference and shows error message, just
reconnect the power source for resume normal operation.
USING ON HOUSE CURRENT
COMPACT DISC PLAYER
•
If the unit you purchased does not include an AC power adaptor, please use a 6V 350mA AC power
adaptor. Plus pole “ ” to the centre pin of the 3.5 mm socket.
When the unit is not used, be sure to disconnect the AC power adaptor.
OPERATING INSTRUCTIONS
ON INSTALLATION
Never install the unit where it would be subject to:
Before using the unit, please read this manual thoroughly and retain it for future reference.
-
-
-
-
-
-
heat sources such as radiators or airducts.
direct sunlight.
excessive dust.
moisture or rain.
mechanical vibration or shock.
uneven surface.
FUNCTION OF CONTROLS
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO
RAIN OR MOISTURE.
Opening the CD tray.
To insert or remove a disc.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
PLAY/PAUSE
•
•
Do not place any heavy object on top of the unit.
Press “
Press “
” to begin play.
When the unit is used with an AC power adaptor, do not wrap the unit in a cloth, blanket, etc. If
you do so, the temperature inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit or serious accidents.
CAUTION
” during play to pause.
To release pause, press “
” again.
The use of optical instruments with this product will increase eye hazard.
•
•
If the unit is brought directly from a cold to a warm location, or is placed in a very damp room,
moisture may condense on the lens inside the unit. Should this occur, the unit will not operate.
In this case, remove the disc and leave the unit in a warm place for several hours until
the moisture evaporates.
STOP
INFORMATION (FOR THE CUSTOMERS IN USA)
Press once for disc playing stops.
Press twice for power off.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, If not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
For the unit to operate at its best, it should not be subject to temperatures below 5oC (41o F) or
above 35o C (95o F).
Track search and fast forward / fast reverse
SKIP -
Press “
To locate the beginning of the current selection or previous selections.
Keep “ ” depressed:
” lightly / repeatedly:
NOTES ON HEADPHONES / EARPHONES
Do not use headphones / earphones while driving, cycling, or operating any motorized vehicle, it may
create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your
headsets at high volume while walking, especially at pedestrian crossings. You should exercise caution
or discontinue use in potentially hazardous situations.
Avoid using headphones / earphones at high volume. Hearing experts advise against continuous, loud
and extended play. If you experience a ringing in your ears, reduce volume or discontinue use.
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate
to the people around you.
To go back at high speed(search).
-
-
-
-
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connecttheequipmentintoanoutletthatisonacircuitdifferentfromtheonethereceiverisconnected.
Consult the dealer or an experienced radio / TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void
your authority to operate this equipment.
SKIP +
Press “
To locate the beginning of next selection / selections.
Keep “ ” depressed:
” lightly / repeatedly:
To go ahead at high speed (search).
If you have any questions or problems concerning your unit, please consult your nearest dealer.
NOTES:
PROG
MODE
Program
FOR THE CUSTOMERS IN THE UNITED KINGDOM AND / EUROPEAN COUNTRIES
•
•
•
This unit can play Audio Discs including CD-Recordables and CD-Rewriteables. Do not try to play
CD-ROMs, CD-ls, CDVs, or computer CDs.
The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-
R/RW recorders because of differences in recording platforms.
Do not attach any seal or label to either side(the recordable side or the labled side) of a CD-R/RW
disc. It may cause malfunction.
Playing the selections in the desired order.
This compact disc player is classified as a CLASS 1 LASER
product.
The CLASS LASER PRODUCT label is located on the bottom
exterior.
Button for selecting the various play mode.
Mains socket
•
•
Do not use irregular shape CDs(example: heart-shaped, octagonal ones). It may result in malfunction.
When a CD-RW is loaded, it takes about 15 seconds before it can be play-back.
PHONES
PHONES jack
For connecting the headphones / earphones.
FOR THE CUSTOMERS IN CANADA
This apparatus complies with the Class B limits for
radio noise emissions set out in radio interference
regulations.
VOLUME
Adjust the volume level.
CAUTION
POWER SOURCES
INVISIBLE LASER RADIATION
WHEN OPEN AND INTER.
LOCKS DEFEATED.
USING WITH BATTERIES
This product contains a low power laser device.
AVOID EXPOSURE TO BEAM.
Insert two size AA batteries (LR6 or MN1500 alkaline) according to the “ ” and “ ” marks correctly
aligned.
PRECAUTIONS
NOTES ON BATTERIES
•
•
•
Insert batteries with correct polarity.
ON SAFETY
Do not use old batteries together with new ones or different types of batteries together.
If the electrolyte inside the battery should leak, wipe the contaminated parts in the battery compartment
with a cloth and replace the old batteries with new ones.
As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble
the casing. Refer servicing to qualified personnel only.
Do not put any foreign objects in the safety slot inside the disc compartment. If you do so, the laser beam
may come out when the lid is opened.
Do not put any foreign objects in the DC IN 6V (external power input) jack. Should any solid objects or
liquid fall into the unit, disconnect the power supply and have the unit checked by qualified personnel
before operating it any further.
•
•
When the unit is not used for a long period of time, remove the batteries.
Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM)
batteries.
NOTES ON “
”
•
•
During playback (batteries are in use), “
When the battery voltage level is low, “
continues in this period.
” is off.
ON OPERATION
” will flash for approx. 10 ~15 minutes, playback still
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded with
high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of
the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged
when the peak level of the sound is played. The lens on the disc table should be kept clean. Do not touch
the lens or poke at it. If you do so, the lens may be damaged and the unit will not operate properly.
•
•
Playback would automatically come to a stop when the batteries have no more power. Do not repeatedly
press “
“
” button as the unit may operate incorrectly. Replace all the batteries with new ones.
” will not be on when an AC adaptor is used.
DM8100_9H_wRW wo Rech GB-010.pmd
1
3/29/2004, 3:57 PM
|