Illumination of the display on the remote
control
When using the player on the AC power
adaptor or car battery, the display is always
illuminated. (Light of the display goes out when
you press p and the CD stops.)
When you use the player on the rechargeable
batteries or alkaline batteries, the display is
illuminated for about 5 seconds when you press
any operation button. But, when using the
optical digital connecting cord, the display is not
illuminated. When you press the LIGHT button
on the remote control, the display is illuminated
for about 5 seconds.
You can turn off the illumination of the display
by first removing the rechargeable batteries or
alkaline batteries; then while pressing the PLAY
MODE button, reinsert the batteries.
To u se t h e re m o t e co n t ro l
The lever marked with =-^-+ is the
jog lever. When you press or slide the lever,
operation starts.
zOt h e r Op e ra t io n s
3-864-764-21 (1)
Usin g o t h e r fu n ct io n s
Pla yin g o n ly t h e t ra cks
yo u w a n t (INTRO PGM Pla y)
Pla yin g t ra cks in t h e o rd e r
yo u w a n t (RMS p la y)
Pla yin g t ra cks re p e a t e d ly
(Re p e a t Pla y)
To m in im ize skip p in g (ESP2)
Playing a CD right
away!
The ESP (Electronic Shock Protection)
function minimize skipping by using a buffer
memory that stores music data and plays it
back in the event of a shock.
You can choose and play your favorite tracks
by scanning through the beginning of each
You can program up to 22 tracks to play in
any order you choose.
^
track in a CD.
You can play tracks repeatedly in normal,
INTRO PGM, shuffle or RMS (Random Music
Sensor) play modes. Repeat all the tracks,
only one track or the specified part within the
same track.
^
The new ESP2 (ESP Squared) system uses a
new DSP (Digital Signal Processor) which can
read and store music data more efficiently
and with superior sound quality, providing a
level of continuous skip protection not found
in traditional buffer memory units. This
decreases the frequency of sound skipping
and the need to utilize the buffer memory.
Use this function when listening in a car or
while walking.*
+
=
+
p
=
p
Slide
Slide
If you want to play a CD right now, choose to use your player on house
current. Other choices are the following three: rechargeable battery, dry
batteries (see “Power Sources” on the reverse side) and car battery.
^
Press
Co m p a ct Disc
+
=
p
To
Do this
P MODE
RPT/ENT
Co m p a ct Pla ye r
P MODE
RPT/ENT
Pause
Press the jog lever
toward ^.
Notes on handling CDs
• To keep the CD clean, handle it by its edge.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
1
2
During play, press P MODE repeatedly
until “RMS*” flashes.
* Although ESP2 provides excellent protection
against skipping, it will not prevent skipping
while jogging or running.
1
During play, press P MODE repeatedly
until “INTRO PGM” flashes.
Resume play after
pause
1
Press the jog lever
toward ^.
Flashing
Connect
Operating Instructions
Flashing
P MODE RPT/ENT
to a wall
outlet
Find the beginning
of the current track
(AMS*)
Slide the jog lever
toward = once.**
To re p e a t a ll t h e t ra cks
Press RPT/ ENT (REPEAT/ ENTER on the
player) during play.
Ab o u t a re a co d e
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
For accessories supplied with your player, check the area code of your model
and refer to “Supplied accessories” toward the end of this manual.
When using
earphones
The “
” indication appears.
Find the beginning
of previous tracks
(AMS)
Slide the jog lever
*RMS = Random Music Sensor
2
3
Press the jog lever toward ^ to start
scanning.
The player plays about the first 15
seconds of each track and “INTRO PGM”
flashes faster.
toward
=
ESP
repeatedly.**
Slide the jog lever toward = or + to
choose a track.
Press ESP.
The ESP indication appears.
Find the beginning
of the next track
(AMS)
Slide the jog lever
toward + once.**
The track number and the playing order
appear.
AC power adaptor
Not these ways
To cancel repeat play, press RPT/ ENT again.
Track number
Flashing
Press RPT/ ENT while the track you want
is playing. To skip the track, slide the jog
lever toward + or just wait for the next
track.
Find the beginning
of succeeding
tracks (AMS)
Slide the jog lever
Earphones
or
Headphones*
To re p e a t a sin g le t ra ck
1 Press RPT/ ENT while the track you want
to repeat is playing.
toward
+
To release the ESP function, press ESP again.
repeatedly.**
The “
” indication appears.
Go forward
quickly
After you have gone through the CD,
“INTRO PGM” stops flashing and the tracks
you have chosen play automatically.
Notes
Slide and hold the
jog lever toward
+.**
Playing order
• Playing may stop when the player gets a strong
shock even with the ESP function on.
• You may hear a noise or sound skip when:
— listening to a dirty or scratched CD,
— listening to an audio test CD or,
— the player receives continuous shock.
• Sound may drop for a while if you press ESP
during play.
3
4
Press RPT/ ENT to program the track.
Go backwards
quickly
Slide and hold the
jog lever toward
=.**
To finish programing before going through
the whole CD, press the jog lever toward ^.
The selected tracks will be played.
Repeat steps 2 and 3 to program the
remaining tracks.
2 Press P (play) MODE (PLAY MODE on the
player) repeatedly until “1” appears.
DC IN 4.5 V
*AMS = Automatic Music Sensor
**These operations are possible during both play
and pause.
If you press p, the program will be erased.
To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
D-E707
D-E775
* U2 model
5
Press the jog lever toward ^.
“RMS” stops flashing and the tracks you
have chosen play in the order you
specified.
• When you use an optical digital connecting
cord, the ESP function will be disabled.
supplied with
2/REMOTE
headphones
To e n jo y m o re p o w e rfu l b a ss so u n d
(So u n d fu n ct io n )
You can enjoy a powerful bass-boosted sound.
If you press RPT/ ENT (REPEAT/ ENTER on the
For models supplied w ith the AC plug adaptor
If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor.
player) to display “
”, you can locate the tracks
To cancel INTRO PGM play, press P MODE
repeatedly until the play mode indication
disappears from the display.
Sony Corporation ©1998 Printed in Malaysia
If you press p, the program will be erased. To
prevent accidental erasure, set the RESUME
switch at the rear of the player to ON.
To repeat another track, slide the jog lever
toward = or + .
continuously in the following order:
• When using +: next track n next track ......
last track n first track n second track ......
• When using =: previous track n previous
track ...... first track n last track ......
For models supplied w ith the remote control
• Connect the plug of the earphones/ headphones to the remote control.
• Connect the earphones/ headphones to the remote control firmly. A loose connection may
cause noise during playback.
To cancel repeat play, press RPT/ ENT again.
To cancel RMS play, press P MODE until
“RMS” disappears from the display.
Fo r t h e cu st o m e rs in t h e USA
This equipment has been tested and found to
comply with the limits for a Class B digital
To re p e a t t h e sp e cifie d p a rt w it h in
t h e sa m e t ra ck (LOOP Pla y)
1 During play, press P MODE repeatedly
until “A˜B” flashes in the display.
We lco m e !
Pla yin g t ra cks in ra n d o m
o rd e r (Sh u ffle Pla y)
You can do the operations shown in the above
table using the buttons with the same marks on
the player.
To ch e ck t h e p ro g ra m
During programing:
Press RPT/ ENT before step 5.
During RMS play:
Press P MODE repeatedly until “RMS”
flashes, then press RPT/ ENT.
Each time you press RPT/ ENT, the track
number and the playing order appear in the
order you specified.
Thank you for purchasing the Sony
Compact Disc Compact Player.
Before operating your player, please
read this manual and retain it for
future reference.
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
SOUND
Flashing
You can play the tracks in a CD in random
order.
2
To re m o ve t h e CD
Remove the CD while pressing the pivot.
Press SOUND to select “MB (Mega Bass)” or
“GRV (Groove).” “GRV” is more effective.
Place a CD
Note
• If the sound is distorted when emphasizing
bass, turn down the volume.
Ab o u t t h is m a n u a l
The instructions in this manual are for the
D-E707 and D-E775. Before you start reading,
check your model number.
2 Press RPT/ ENT to set the point (point A)
where you want to start repeat play.
Point A is stored in the memory.
Note
To lo ck t h e b u t t o n s
You can lock your player against any
accidental operations.
You can still operate the player with the
remote control.
• If you program another track after the 22nd
track, the first track programed is cleared and
the new track is programed instead.
P MODE
Ow n e r’s Re co rd
Flashing
Light up
The model and the serial numbers are located at
the bottom. Record these numbers in the spaces
provided below. Refer to them whenever you
call upon your Sony dealer regarding this
product.
During play, press P MODE repeatedly until
“SHUF” appears.
The tracks play in random order.
Notes on controlling the volume w ith the
remote control
Set the VOL (volume) control on the remote
control to the maximum. Then adjust the volume
on the player to the level that you want to be the
maximum volume of the remote control.
Model No. __________ Serial No.__________
3 Press RPT/ ENT again to set the point
(point B) where you want to stop repeat
play.
Point B is stored in the memory, and repeat
play starts from point A.
Label side up
OPEN
WARNING
Notes on display
1Slide OPEN to open the lid.
To cancel shuffle play, press P MODE
repeatedly until the play mode indication
disappears from the display.
2Fit the CD to the pivot.
• When you press ^ (when RESUME is set to
OFF), the total number of tracks in the CD and
the total playing time appear for about 2
seconds.
• During play, the track number and the elapsed
playing time of the current track appear.
• During pause, the elapsed playing time flashes
in the display.
3Close the lid.
To p re ve n t fire o r sh o ck
h a za rd , d o n o t e xp o se
t h e u n it t o ra in o r
m o ist u re .
Light up
Note
• During shuffle play, you cannot return to
previous tracks by sliding the jog lever toward
=.
Fo r t h e cu st o m e rs in Au st ra lia
The supply cord of the AC power adaptor cannot
be replaced; if the cord is damaged, the AC
power adaptor should be discarded.
Slide HOLD in the direction of the arrow.
When you press any button, “Hold” appears in
the display and you cannot operate the player.
3
Play
• Between tracks, the time to the beginning of the
next track will appear with the “–” indication.
To a vo id e le ct rica l
sh o ck, d o n o t o p e n t h e
ca b in e t . Re fe r se rvicin g
t o q u a lifie d p e rso n n e l
o n ly.
To change points A and B, press and hold
RPT/ ENT until “A˜B” flashes in the
display, then do steps 2 and 3 again.
To unlock, slide HOLD back.
2 Adjust the volume.
To u se t h e p la ye r
Fo r t h e cu st o m e rs n o t in Po la n d
The
mark on the unit is valid only for
products marketed in Poland.
To set points A and B on other tracks, slide
the jog lever toward = or + to select
another track, then do steps 2 and 3 again.
1 Press ^.
Fo r t h e cu st o m e rs n o t in Eu ro p e
The CE mark on the unit is valid
only for products marketed in the
European Union.
Continue to the reverse side m
CAUTION
If you press p, the stored points will be
erased. To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
The use of optical instruments with this product
will increase eye hazard.
Fo r t h e cu st o m e rs n o t in Ru ssia
This mark on the unit and package
is valid only for products marketed
in Russia.
1 Press the jog
lever toward
^.
2 Adjust the volume.
To cancel repeat play, press P MODE until
“A˜B” disappears from the display.
To stop play, press p.
|