Canon Eos 70d 18 135 Is Stm Lens Kit 8469B016 User Manual

EF-S18-135mm f/3.5-5.6 IS STM  
ENG  
Instructions  
Handling Cautions  
Safety Precautions  
If the lens is taken from a cold environment into a  
warm one, condensation may develop on the lens  
surface and internal parts. To prevent condensation  
in this case, first put the lens into an airtight plastic bag  
before taking it from a cold to warm environment. Then  
take out the lens after it has warmed gradually. Do the  
same when taking the lens from a warm environment  
into a cold one.  
Do not look at the sun or a bright light source  
through the lens or camera. Doing so could result in  
loss of vision. Looking at the sun directly through the  
lens is especially hazardous.  
Whether it is attached to the camera or not, do not  
leave the lens under the sun without the lens cap  
attached. Thito prevent the lens from concentrating  
the sun’s rayshich could cause a fire.  
Do not leave the lens in excessive heat such as in a car  
in direct sunlight. High temperatures can cause the  
lens to malfunction.  
ions usin this instruction  
arning to pent lens or camera malfunction  
or damage.  
Supplementary notes on using the lens and  
aking pictures.  
ENG-2  
Safety Precautions  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions: (1) This  
device may not cause harmful interference, and (2) this  
device must accept any interference received, including  
interference that may cause undesired operation.  
Do not make any changes or modifications to the equipment  
unless otherwise specified in the instructions. If such  
changes or modifications should be made, you could be  
required to stop operation of the equipment.  
This Class B digital apparatus complies with Canadian ICES-  
003.  
This equipment has been tested and found to comply with  
the limits for a class B digital device, pursuant to part 15  
of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a  
residential installation. This equipment generates,
can radiate radio frequency energy and, if not ins
used in accordance with the instructions, may ca
interference to radio communications
However, there is no guarantee thnterfeence w
occur in a particular installation. If s equipment do
cause harmful interference to raditelevision recepti
which can be determined by turning e equipmoff and  
on, the user is encouraged to try to cect the irference  
by one or more of the following measur
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and  
receiver.  
• Consult the dealer or an experienced radio/TV technician  
for help.  
ENG-3  
Shooting Precautions  
The EF-S18-135mm f/3.5-5.6 IS STM utilizes a stepping motor that drives the focus lens. The motor  
also controls the focus lens during zooming.  
1. When the camera is OFF  
The motor does not operate while the camera is OFF or when the camera is OFF due to the use of the auto power  
off function. Therefore, users must be aware of the following points.  
Manual focus adjustments are not possible.  
During zooming, delayed focus will occur.  
2. When the lens is in sleep mode  
If not operated for a certain period of time, this lens will eode in oto save power. Sleep mode  
differs from when the camera is OFF due to the use of the off functiIn this state, the motor will not  
operate even if the camera is ON. Therefore, ust be f the following points.  
Manual focus adjustments are not possible
During zooming, delayed focus will occur.  
To exit sleep mode, press the sbutto
3. During initial reset  
When the camera is ON or whehe camera is turnN by pressing the shutter button halfway down when the  
camera is OFF due to the use of e auto por off function*1, the lens performs an initial reset of the focus lens.  
Although the image in the viewfir will pear out of focus during the initial reset, this does not mean that the  
lens has malfunctioned.  
Although the shutter can be released during the initial reset, users must wait approximately 1 second*2 after the  
initial reset has completed before shooting.  
*1: Applicable to the following EF-S lens compatible digital SLR cameras:  
EOS 7D, EOS 60D, EOS 50D, EOS 40D, EOS 30D, EOS 20D, EOS 20Da, EOS REBEL T3i/600D, EOS REBEL  
T2i/550D, EOS REBEL T1i/500D, EOS REBEL XSi/450D, EOS REBEL T3/1100D, EOS REBEL XS/1000D, EOS  
DIGITAL REBEL XTi/400D DIGITAL, EOS DIGITAL REBEL XT/350D DIGITAL, EOS DIGITAL REBEL/300D DIGITAL  
*2: The initial reset time varies depending on camera being used.  
ENG-4  
Nomenclature  
Focus mode switch (6)  
Hood mount (7)  
Zoom position index (7)  
Zoom ring lock lever (8)  
Filter Mounting Thread  
(11)  
Focusing ring (6)  
Zoong (7)  
Contacts (6)  
Image stabswh (9)  
Lens mount index (6)  
For detailed information, reference page numbers are provided in parentheses (**).  
ENG-5  
Mounting and  
Detaching the Lens  
Setting the Focus  
Mode  
1
2
See your camera’s instructions for details on  
mounting and detaching the lens.  
Tin autofocus (AF) mode, set the focus  
moswitch to AF.  
To uonly manual focusing (MF), set the focus  
mode witch to MF, and focus by turning the  
ocusing ring.  
After detaching the lens, place the lens
the rear end up to prevent the lens sur
contacts from getting scratched.  
If the contacts get soiled, atchd, or h
fingerprints on them, corron or faulty  
connections can result. Thcamera and lens  
may not operate properly.  
After autofocusing in ONE SHOT AF mode, focus  
manually by pressing the shutter button halfway  
and turning the focusing ring.  
If the contacts get soiled or hfingeints on  
them, clean them with a soft clot
If you remove the lens, cover it with the dust  
cap. To attach it properly, align the lens mount  
index and the index of the dust cap as shown  
in the diagram, and turn clockwise. To remove it,  
reverse the order.  
Quickly rotating the focusing ring may result in  
delayed focus.  
Manual focus adjustments are not possible when  
the camera is OFF.  
ENG-6  
Hood (sold separately)  
Zooming  
3
4
The EW-73B hood cuts out unwanted light and  
protects the front of the lens from rain, snow,  
and dust.  
To attach the hood, align the hood’s att
position mark with the red dot on the fro
lens, then turn the hood as swn y th
until the lens’ red dot is aligd with the h
stop position mark.  
, turn thens’ zoom ring.  
e sure to finish zooming before focusing.  
ooming after focusing can affect the focus.  
rring may temporarily occur if the zoom ring is  
quickly rotated.  
Zooming when the camera is OFF will result in  
delayed focus.  
Zooming during still image exposure will result in  
delayed focus. This causes any streaks of light  
that are captured during exposure to be blurred.  
The hood can be reverse-moted on e lens  
for storage.  
If the hood is not attached properly, vignetting  
(darkening of the perimeter of the picture) may  
occur.  
When attaching or detaching the hood, grasp the  
base of the hood to turn it. To prevent deformation,  
do not grasp the rim of the hood to turn it.  
ENG-7  
Fixing the Zoom Ring  
5
The zoom ring can be fixed to keep the lens at the shortest point. This function is convenient for  
carrying a camera on a strap because it prevents the lens from extending.  
1
Rom g to the  
w(18 m).  
2
Slide the zoom ring lock  
lever in the direction  
indicated by the arrow.  
To release the zoom ring,  
slide the zoom ring lock lever  
in the direction opposite to  
the arrow.  
The zoom ring can only be locked at maximum wide angle.  
ENG-8  
Image Stabilizer  
You can use the image stabilizer in AF or MF  
mode.  
6
The Image Stabilizer cannot compensate for a  
blurred shot caused by a subject that moved.  
The Image Stabilizer may not be fully effective  
if you shoot from a violently shaking vehicle or  
other transrtation.  
The Image abilizer consumes more power  
tharmahooting, so fewer shots can be  
taken ie the function.  
This function provides optimal image stabilization  
depending on shooting conditions (such as  
shooting still subjects and following shots).  
n shootinstill subject, it compensates for  
era shake ill directions.  
compensates for vertical camera shake during  
ollowing shots in a horizontal direction, and  
mpensates for horizontal camera shake during  
following shots in a vertical direction.  
When you use a tripod, the Image Stabilizer  
should be turned off to save battery power.  
Even with a monopod, the Image Stabilizer will  
be as effective as during hand-held shooting.  
However, depending on the shooting environment,  
the Image Stabilizer effect may be less effective.  
The image stabilizer function also operates when the  
lens is used with an Extension Tube EF12 II or EF25 II.  
If you set the camera’s Custom Function to  
change the assigned button to operate the AF,  
the Image Stabilizer will operate when you press  
the newly assigned AF button.  
1
Set the STABILIZER swch to ON.  
If you are not going to use timage silizer  
function, set the switch to OFF
2
When you press the shutter button halfway,  
the Image Stabilizer will start operating.  
Make sure the image in the viewfinder is stable,  
then press the shutter button the rest of the way  
down to take the picture.  
ENG-9  
Image Stabilizer  
The image stabilizer for this lens is effective for hand-held shots in the following conditions.  
ON  
O
OFF  
OFF  
In semi-darkened areas sh as indoo
outdoors at night.  
When panning subjects in motion.  
■ Dynamic IS Function  
In locations where flash ptography is  
prohibited, such as art musms anheater  
stages.  
In situations where your footing is uncertain.  
In situations where fast shutter settings  
cannot be used.  
The EF-S18-135mm f/3.5-5.6 IS STM is  
equipped with dynamic IS, effective when  
shooting while walking since it expands the IS  
range.  
Achieves effective IS at the wide end.  
Automatically activates when the camera is set  
to Movie Shooting.  
ENG-10  
Filters  
(sold separately)  
Extension Tubes  
(Sold Separately)  
7
8
You can attach filters to the filter mounting  
thread on the front of the lens.  
You can attach extension tube EF12 II or EF25  
II for magnified shots. The shooting distance  
and magnificatin are shown below.  
Only one filter may be attached.  
If you need a polarizing filter, use the Canon  
Circular Polarizing Filter PL-C B (67 mm).  
To adjust the polarizing filter, first remove the  
lens hood.  
FocDistance Range (mm)  
Magnification (×)  
tance Long distance Close distance Long distance  
Incompatible  
mm  
mm  
mm  
135mm  
E
30
1568  
0.43  
0.09  
Incompatible  
258  
822  
0.61  
0.21  
MF ode is recommended for accurate focusing.  
ENG-11  
Specifications  
9
Focal Length/Aperture  
Lens Construction  
Minimum Aperture  
Angle of View  
18-135mm f/3.5-5.6  
12 groups, 16 elements  
f/22-36*  
Diagonal: 74°20′ - 11°30′, Vertical: 45°30′ - 6 °20′, Horizontal: 64°30′ - 9°30′  
Min. Focusing Distance  
Max. Magnification  
Field of View  
0.39m/1.28 ft.  
0.28x (at 135 mm/5.31 inch)  
Approx. 248 x 372 - 53 x 80mm/9.76 x 12.09 x 3.15 inch (at 0.39 m/1.28 ft.)  
67mm/2.64 inch  
Filter Diameter  
Max. Diameter and Length 76.6 x 96.0mm/3.02 x 3.78
Weight  
Hood  
Approx. 480g/1
EW-73B (Sol
E-67/E-67 II  
Lens Cap  
Case  
L11Sold
* Applies to 1/3-stop incrementWith 1/2-stop init will be f/22-38.  
Equivalent to 29-216 mm he 35mfilm format.  
The lens length is measured om thmount surface to the front end of the lens. Add 21.5 mm to  
include the E-67 lens cap and ap, and 24.2 mm for the E-67 II.  
The size and weight listed are for the lens only, except as indicated.  
Extenders cannot be used with this lens. In addition, there are no close-up lenses designed for use with this lens.  
Aperture settings are specified on the camera. The camera automatically compensates for  
variations in the aperture setting when the camera is zoomed in or out.  
All data listed is measured according to Canon standards.  
Product specifications and appearance are subject to change without notice.  
ENG-12  
CT1-8582-001  
0812Ni  
© CANON INC. 2012  

Aiwa CT X421 User Manual
Attwood 4623 User Manual
Canon MVX150i User Manual
Canon VIXIA HF M52 User Manual
Casio Ea 200 Laboratory Data Collection Device EA 200 User Manual
Coustic car audio User Manual
Fluke Car Amplifier 5725A User Manual
Griffin Technology RoadTrip User Manual
JVC GET0568 003A User Manual
JVC GR DVX 407 User Manual