Griffin Technology RoadTrip User Manual

PACKAGE CONTENTS  
1. Protection Pad  
2. iPod holder / belt clip  
3. Clip holder for iPod mini  
4. RoadTrip body  
5. FM Transmitter module  
6. Power Plug  
7. Sleeve adapter  
clip holder in to the RoadTrip body (4).  
POWER PLUG INSTALLATION (4, 6, 7)  
Insert the power plug (6) into the RoadTrip body and gently  
twist clockwise until it clicks into place.  
3
8
4
RoadTrip  
4
1
QUICK START MANUAL  
8
8. Extension  
9. LED  
10. USB/Audio Cable  
9
6
7
6
7
2
10  
For cases where there are clearance problems, use the included  
extension (8). Insert the extension into the RoadTrip (4) by  
gently twisting clockwise until it clicks into place. Then connect  
the power plug (6) to the extension. Your RoadTrip is now ready  
to use.  
5
USING THE ASSEMBLED CHARGER  
1. Plug the assembled unit into your vehicle’s cigarette  
lighter/power outlet. The LED (9) will show green to  
indicate connection to power.  
2. Insert your iPod into the RoadTrip (see Preparing the iPod).  
The LED will change to red when charging is in progress. When  
the iPod battery is fully charged, the LED will change to green.  
3. If your vehicle’s cigarette lighter/power outlet is  
too large for the power plug connection, use the  
included sleeve adapter (7).  
PREPARING THE IPOD (pieces 1, 2, 3, 4)  
Full-size iPod - attach the included belt clip / holder (2) to the  
iPod. The slender models (10, 15, 20 GB) may feel loose in the  
holder. To make a snug fit, attach the Protection Pad (1) to the  
inside of the iPod holder. Slide the belt clip into the RoadTrip  
body (4).You will not need the clip holder (3).  
iPod mini - attach the belt clip that came with your iPod mini.  
The belt clip will slide into the clip holder (3). Next, slide the  
4.Your iPod will now charge as long as  
Tuning  
USING THE FM DIGITAL TRANSMITTER (first time use)  
First, connect the FM Transmitter to the RoadTrip (4).  
Press the Quick Key (c) on the FM Transmitter (5). The display  
will show the letters OK for 3-5 seconds.  
TROUBLESHOOTING  
If your RoadTrip stops functioning:  
• Check to see if the fuse in the power plug is broken.  
If it is, simply replace the fuse. They can be found  
at your local electronics store.  
To increase or decrease channels quickly, press the  
Quick Key and either Frequency key.  
Holding down either Frequency key slightly longer  
will change the frequency faster.  
• If the fuse is good, check the power source.  
5. Play a song on your iPod, and adjust the radio’s volume.  
The Transmitter will memorize the last frequency you use,  
and will be set to that frequency when you connect again.  
FM Digital Transmitter  
a. Frequency Down  
b. Frequency Up  
c. Quick Key  
Griffin Technology Tech Support  
support@griffintechnology.com  
615-399-7000 (M-F 9-6 CST)  
d
To turn off the FM Transmitter  
Press and hold the Quick Key for 2-3 seconds.  
The display will show four dashes and then power off.  
d. Display  
a
b
c
TECHNICAL SPECIFICATIONS  
• Charges the iPod  
• Compatible with 3rd generation iPod and iPod mini.  
• Extension Power Plug available for easy reach in any car  
• LCD Digital Display on FM Transmitter  
• Input Voltage: DC+12V ~ +16V.  
1. The display will then show the pre-set radio frequency.  
From now on, the display will show the last used frequency  
when you connect it to power.  
Though the FM Transmitter does not draw much  
power, it should be turned off when not in use.  
2. Insert your iPod into the RoadTrip (see Preparing the iPod).  
• Current: 2A (max)  
USING ROADTRIP AS A DESKTOP FM TRANSMITTER  
RoadTrip can be used as a stand-alone transmitter for any  
desktop or laptop computer. Use it to send music from your  
laptop to your home stereo or even wireless FM headphones.  
• Output RF range: 88.1 MHz ~ 107.9 MHz.  
• Radio Frequency Adjustment: 0.1MHz / Per step.  
• Radio Frequency Response: 50 Hz ~ 15 KHz  
3. Turn on your radio, reduce the volume to 10-20%, and tune  
the radio to a frequency that’s not being used. The ideal  
frequency will have nothing but static – no music or  
talk – and it’s even better if the surrounding frequencies  
are unused also.  
To use the RoadTrip with your computer simply disconnect the  
FM Transmitter module (5) from the RoadTrip body (4).  
Connect the USB/Audio cable (10) to the module and then to  
the USB port and headphone jack on your computer. You can  
then tune the RoadTrip to broadcast to any empty FM frequency  
on your stereo - just as you would in the car.  
4. Adjust the Transmitter to the same frequency you selected on  
your radio. When the Transmitter and the radio are set to the  
same frequency, the radio will mute and you won’t hear static.  
© 2004 Griffin Technology  

Alpine Type R SWR 1043D User Manual
Cuisinart SBC 1000 User Manual
Datexx 6518206 User Manual
Directed Audio 2300X User Manual
FujiFilm FinePix F610 User Manual
Havis Shields S UMM PLA LX1 User Manual
Hitachi DZ BD70 User Manual
HP (Hewlett Packard) PhotoSmart User Manual
Ikelite Canon 6090 User Manual
JVC Car Video System KW AVX838 User Manual