Sony Clock Radio ICF CD513 User Manual

3-220-318-21 (1)  
Pre ca u t io n s  
Ow n e rs Re co rd  
IMPORTANT SAFEGUARDS  
Operate the unit on the power source  
specified in the “Specifications.”  
The model number and the serial number are  
located on the top.  
For your protection, please read these safety instructions completely before operating the  
appliance, and keep this manual for future reference.  
Record the serial number in the space provided  
below. Refer to them whenever you call upon  
your Sony dealer regarding this product.  
To disconnect the power cord (mains lead),  
pull it out by the plug, not the cord.  
Do not leave the unit in a location near a heat  
source such as a radiator or airduct, or in a  
place subject to direct sunlight, excessive dust,  
mechanical vibration, or shock.  
Carefully observe all warnings, precautions and instructions on the appliance and described in  
the operating instructions supplied with the appliance by Sony.  
Model No. ICF-CD513  
Serial No.  
INSTALLATION  
Allow adequate air circulation to prevent  
internal heat build-up. Do not place the unit  
on a surface (a rug, a blanket, etc.) or near  
materials (a curtain) which might block the  
ventilation holes.  
Should any solid object or liquid fall into the  
unit, unplug the unit and have it checked by a  
qualified personnel before operating it any  
further.  
Wa t e r a n d Mo ist u re  
Do not install the appliance near water: for example, near a bathtub, washbowl, kitchen sink,  
laundry tub, in a wet basement, or near a swimming pool.  
WARNING  
FM/AM CD Kitchen  
Clock Radio  
He a t  
To p re ve n t fire o r sh o ck  
h a za rd , d o n o t e xp o se t h e  
u n it t o ra in o r m o ist u re .  
Do not install the appliance near sources of heat such as radiators, heat registers, stoves, or  
other appliances that produce heat.  
Ve n t ila t io n  
To clean the casing, use a soft cloth dampened  
with a mild detergent solution.  
Slots and openings in the cabinet and in the back or bottom are provided for necessary ventilation.  
To ensure reliable and safe operation of the appliance, and to protect it from overheating, these  
slots and openings must never be blocked or covered.  
Do not place the appliance on a bed, sofa, rug or other similar surface which may block the slots  
and openings.  
If you have any questions or problems  
concerning your unit, please consult your  
nearest Sony dealer.  
Operating Instructions  
Do not install the appliance in a confined space, such as a bookcase or built-in cabinet, unless  
proper ventilation is provided.  
Tro u b le sh o o t in g  
Ca rt s a n d St a n d s  
Should any problem occur with the unit, make  
the following checks to determine whether or not  
servicing is required. If the problem persists,  
consult the nearest Sony dealer.  
Do not install the appliance on an unstable table, shelf, cart or stand. Use only a cart or stand  
recommended by Sony.  
An appliance and cart combination should be moved with care. Quick stops, excessive force, and  
uneven surfaces may cause the appliance and cart combination to overturn.  
The clock does not show the correct time.  
This symbol is intended to alert the user  
to the presence of uninsulated  
“dangerous voltage” within the  
products enclosure that may be of  
sufficient magnitude to constitute a risk  
of electric shock to persons.  
Has an electrical power outage lasting more  
than one minute occurred?  
Wa ll o r Ce ilin g Mo u n t in g  
If your appliance can be mounted to a wall or ceiling, mount it only as recommended by Sony.  
The CD player does not operate.  
Did you close the CD lid?  
USE  
Po w e r So u rce  
Did you place the disc correctly?  
The disc should be placed with the labeled  
side up.  
Dusty or defective disc—Clean the disc with  
an optional cleaning cloth. Wipe the disc from  
the center out.  
Take out the CD and leave the CD  
compartment open for about an hour to get  
rid of moisture condensation.  
This symbol is intended to alert the user  
to the presence of important operating  
and maintenance (servicing) instruc-  
tions in the literature accompanying the  
appliance.  
Connect the appliance to a power supply only of the type described in the operating instructions  
or as marked on the appliance.  
Gro u n d in g o r Po la riza t io n  
Do not defeat the grounding or polarization feature of the AC power cord. If your AC receptacle  
will not accept the power cord plug, contact your electrician to install a proper AC receptacle.  
The graphical symbols are on the top of the  
enclosure.  
Sporadic loss of sound in CD operation.  
AC Re ce p t a cle  
INFORMATION  
Dusty or defective disc—Clean or replace the  
disc.  
This equipment has been tested and found to  
comply with the limits for a Class B digital  
device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable  
protection against harmful interference in a  
residential installation. This equipment  
generates, uses, and can radiate radio frequency  
energy and, if not installed and used in  
accordance with the instructions, may cause  
harmful interference to radio communications.  
However, there is no guarantee that interference  
will not occur in a particular installation. If this  
equipment does cause harmful interference to  
radio or television reception, which can be  
determined by turning the equipment off and on,  
the user is encouraged to try to correct the  
interference by one or more of the following  
measures:  
Check to make sure that the AC receptacle holds the power cord plug firmly and securely. If the  
power cord plug is loose, contact your electrician to replace the defective and unsafe AC  
receptacle.  
Volume too high—Reduce the volume.  
Strong vibration.  
Dream Machine is a trademark of Sony Corporation.  
Po w e r-Co rd Pro t e ct io n  
Route the power cord so that it is not likely to be walked on or pinched by having objects placed  
on it, paying particular attention to the plugs, receptacles, and the point where the cord exits from  
the appliance.  
Sp e cifica t io n s  
CD player section  
ICF-CD513  
Sony Corporation 2000 Printed in Thailand  
System: Compact disc digital audio system  
Wh e n n o t in u se  
Laser diode properties: Material: GaAlAs  
Wavelength: 780 nm  
Unplug the power cord of the appliance from the outlet when left unused for a long period of  
time.  
To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord.  
Emission duration: Continuous  
Laser output: Less than 44.6 µW  
(This output is the value measured at a  
distance of about 200 mm from the objective  
lens surface on the optical pick-up block with  
7mm aperture.)  
Fo re ig n Ob je ct s  
Be careful that foreign objects and liquids do not enter the enclosure through openings.  
Cle a n in g  
—Reorient or relocate the receiving antenna.  
—Increase the separation between the  
equipment and receiver.  
—Connect the equipment into an outlet on a  
circuit different from that to which the  
receiver is connected.  
+1  
Frequency response: 20-20 000 Hz –1.5 dB  
Clean the appliance only as recommended by Sony.  
Wow and flutter: Below measurable limit  
ANTENNAS  
Ou t d o o r An t e n n a Gro u n d in g  
Radio section  
Frequency range:  
FM: 87.5-108 MHz  
AM: 530-1 710 kHz  
—Consult the dealer or an experienced radio/  
TV technician for help.  
If an outdoor antenna or cable system is installed, follow the precautions below.  
An outdoor antenna system should not be located in the vicinity of overhead power lines or other  
electric light or power circuits, or where it can come in contact with such power lines or circuits.  
WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE  
TAKEN TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT  
WITH THEM IS ALMOST INVARIABLY FATAL.  
You are cautioned that any changes or  
modifications not expressly approved in this  
manual could void your authority to operate  
this equipment.  
Channel step:  
FM: 0.1 MHz (fixed)  
AM: 10 kHz (fixed)  
CAUTION  
The use of optical instruments with this  
product will increase eye hazard.  
Be sure the antenna system is grounded so as to provide some protection against voltage surges  
and built-up static charges. Section 810 of the National Electrical Code provides information with  
respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to  
an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit,  
connection to grounding electrodes, and requirements for the grounding electrode.  
General  
Time display:  
12-hour system  
Speaker:  
66 mm (2 58 inches) dia, 4 Ω  
Be fo re Yo u Be g in  
Pow er outputs:  
Thank you for choosing the Sony CD kitchen  
clock radio! It will give you many hours of  
reliable service and listening pleasure.  
Before operating the unit, please read these  
instructions thoroughly and retain them for  
future reference.  
An t e n n a Gro u n d in g Acco rd in g t o t h e Na t io n a l  
Ele ct rica l Co d e  
1.2W + 1.2W (at 10% harmonic distortion)  
Pow er requirements:  
120 V AC, 60 Hz  
Dimensions:  
Approx. 365 × 106 × 281 mm(w/ h/ d)  
(Approx. 14 38 × 4 14 × 11 18 inches) incl.  
projecting parts and controls  
Antenna Lead-in Wire  
Fe a t u re s  
Mass:  
Approx. 2.9 kg (6 lb 6 oz)  
Built-in CD player with Shuffle/ Repeat  
function.  
Supplied accessories:  
PLL (Phase Locked Loop) Synthesized Tuner  
with 15 memory presets for easy one button  
tuning.  
Antenna Discharge Unit  
Ground Clamps  
Mounting screws (4), Template (1),  
Spacers (4), Cord clamp (1)  
(NEC* Section 810-20)  
Powerful bass with MEGABASS sound  
system.  
Single alarm function - which can be used as  
timer.  
Summer time (daylight saving time)  
calculation.  
Grounding Conductors  
(NEC* Section 810-21)  
Design and specifications are subject to change  
without notice.  
Electric Service  
Equipment  
Ground Clamps  
Notes on AM channel step  
The AM channel step differs depending on the  
areas.  
The channel step of this unit is factory-set to  
10 kHz.  
Power Service Grounding  
Electrode System  
(NEC* Art 250 Part H)  
NEC National Electrical Code—  
SERVICE  
Area  
Channel step  
10 kHz  
Unplug the appliance from the wall outlet and consult qualified service personnel when:  
-the power cord or the plug has been damaged.  
-a solid object or liquid has fallen into the cabinet.  
North and South  
American countries  
Other countries  
9 kHz  
-the appliance has been exposed to rain or moisture.  
-the appliance does not appear to operate normally or exhibits a marked change in performance.  
-the appliance has been dropped, or the enclosure damaged.  
Do not attempt to service the appliance beyond that described in the operating instructions. For  
all other servicing refer to qualified service personnel only.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Smooth Fitness Elliptical Trainer E7000P User Manual
SMSC Switch LAN9311 User Manual
Sony CRT Television Model KP 41S4U User Manual
Sony Headphones MDRZX100 User Manual
Sony Home Theater System DAV BC250 User Manual
Speco Technologies Digital Camera HTD8FFI HTB11FFI HT7248FFI User Manual
Stanley Black Decker Power Hammer BR50 User Manual
Sterling Plumbing Outdoor Shower 72141110 User Manual
Suburban Mfg Oxygen Equipment 12155 00 DRDRAA User Manual
SVAT Electronics Security Camera UC1301 User Manual