Revolabs Single Channel Wireless Microphone System- Tandberg Edge
75/85/95 MXP Setup Guide
NOTES AND CAUTIONS:
This setup guide will guide you through the step needed to properly connect a Revolabs
Single Channel System to a Tandberg Edge 75/85/95 MXP video codec.
1. Connecting the Cables
2. Configuring the Edge MXP Video Codec
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Tandberg 880 MXP video codec
3. QTY 1 07-STEMIC-PPP Line-to-Mic Interface Cable*
* OPTIONAL FROM REVOLABS
NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE
TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008
Download from Www.Somanuals.com. All Manuals Search And Download.
Configuring the Edge 75/85/95 MXP Video Codec
CONFIGURING THE AUDIO MENUS OF THE EDGE MXP VIDEO CODEC
1.
2.
3.
Go to AUDIO SETTINGS
Select INPUTS
Confirm that MIC 1 is ON
4.
5.
Adjust the audio Input Type Level if necessary (recommend +8dB)
Speak into the Revolabs microphones that are connected to MIC 1.
The audio meter should peak at about 5dB for normal speech.
Download from Www.Somanuals.com. All Manuals Search And Download.
6.
7.
Return to previous menu and select ECHO CONTROL
Enable MIC 1 Echo Canceller (ON)
8.
9.
Return to previous menu and select AUDIO LEVELING (AGC)
Turn MIC Audio Leveling (AGC) OFF
Download from Www.Somanuals.com. All Manuals Search And Download.
|