NuTone Fan PFC 48II User Manual

INSTALLATION INSTRUCTIONS  
READ & SAVE THESE INSTRUCTIONS!  
Industrial Paddle Fan  
MODELS: PFC-48II & PFC-56II /SERIES  
CAUTIONS  
Photo shows  
hardware included  
with your new  
ceiling fan.  
WARNING: To reduce the risk of personal injury, do not bend the  
blade brackets when installing the brackets, balancing the blades,  
or cleaning the fan. Do not insert foreign objects in between rotating  
fan blades.  
WARNING: To reduce the risk of fire, electric shock, or personal  
injury, mount to outlet box marked “Acceptable for Fan Support” and  
use mounting hardware provided with the box.  
WARNING: To reduce the risk of fire, electric shock, do not use this  
fan with any solid-state speed control device.  
This product must be mounted and wired in compliance with all local  
and national electrical codes.  
OUTLET BOX  
MOUNTING  
BRACKET  
Before wiring the ceiling fan, turn off electric power at the circuit  
breaker or fuse box and leave off until installation is complete.  
Mount outlet box so that it will support at least 35 pounds.  
Note: the weight of the fan is as follows:  
PFC-48 14 lbs. PFC-56 20 lbs.  
UPPER CANOPY  
SPRING BUSHING  
NUT  
LOCATION  
DOWN ROD  
COTTER PIN  
BUSHING  
1. When fan is installed, you must allow a minimum of 10 feet be-  
tween floor and bottom of fan blades.  
LOCK WASHER  
2. For this model, the center of the fan must be located at least 32”  
from any vertical surface - wall, doors, partitions, etc. This allows  
minimum clearance for fan blades.  
BOLT  
SET SCREW  
LOCK BOLT  
LOWER  
CANOPY  
3. Do not mount fan below, next to or between air ducts, beams or  
any other obstructions which may interfere with the natural air flow  
pattern created by the fan.  
BLADE  
BLADE  
HOLDER  
GASKET  
4. Place fans near constantly opening doors and shipping bays to  
produce an “air shield” effect that helps keep out cold air in winter  
and dust, odors and insects in the summer.  
BLADE SUPPORT  
BRACKET  
MOTOR UNIT  
5. If desired, fans can be installed directly above heat producing  
machinery to reclaim the heated air.  
FIGURE 1  
6. For maximum air flow, fans should be located above aisles in  
warehouses and storage areas.  
SUPPLY  
GROUND  
GREEN  
GREEN  
WHITE  
BLACK  
7. Make sure fan voltage is compatible with your electrical system.  
8. FOR SLOPED CEILING INSTALLATIONS ONLY: Ball and socket  
mounting system will work on sloped ceilings up to 22° maximum  
(rise/run = 5/12).  
SUPPLY NEUTRAL  
SUPPLY HOT  
FIGURE 2  
Download from Www.Somanuals.com. All Manuals Search And Download.  

MTD Lawn Mower TMO 37463A User Manual
MTX Audio Stereo Amplifier T5508 04 User Manual
NAD DVD Player L 54 User Manual
Newcon Optik Hunting Equipment DN 463 User Manual
NordicTrack Home Gym NTS59250 User Manual
OEM Systems Speaker System RS 82B User Manual
Olympus DVR DS 2300 User Manual
Olympus Microcassette Recorder VN 7600PC User Manual
Oregon Scientific Digital Camera DS 3899 User Manual
ParaBody Home Gym 805106 User Manual