GS605AV_IG_08Dec09.fm Page 1 Tuesday, December 8, 2009 7:53 PM
4. Connect the power adapter cord into the back of the switch and then plug the adapter
into a power source (such as a wall socket or power strip).
Install the Switch and Connect the
Other Devices
)NSTALLATION 'UIDE
5. Check the LEDs to confirm that the switch is connected correctly.
5-Port Home Theater & Gaming Network Switch GS605AV
•
•
The Power LED is lit.
1. Place the switch on a flat surface.
Estimated installation time: 5-10 minutes
Each port on the back has associated with it a bicolor LED on the front.
2. For each device, insert one end of an Ethernet cable into the port in the device and
insert the other end into one of the Ethernet ports on the switch. If you have more
devices to connect than the number of ports on the switch, connect the devices to
another switch or hub and then connect that switch or hub to this switch.
–
–
–
Green: 1000 Mbps link
Amber: 10 Mbps or 100 Mbps link
Blinking: Activity
Package Contents
The package includes:
3. If you add devices using another switch or hub, make sure the QoS category of the
devices match the GS605AV port used by the switch or hub.
Note: If any light does not operate as indicated, go to the Troubleshooting section.
•
5-Port Home Theater & Gaming
Network Switch GS605AV
•
•
•
Power adapter
Installation Guide (this document)
Warranty/Support information card
Modem
Prepare to Install the Switch
Decide where you want to place the switch. Find a flat horizontal surface such as a table,
desk or shelf.
Power On/Off
High Priority
Medium Priority
Low Priority
Broadband
Router
Below is a possible GS605AV configuration. Connect either port 1 or 2 (yellow port) to
the LAN port of your router. Connect your latency sensitive device (IP phone) to port 5
(dark green port).
GS605AV
Make sure the selected location is:
•
•
Not in direct sunlight or near a heater or heating vent.
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on
all sides of the switch.
•
Well ventilated (especially if it is in a closet).
Note: The switch is not designed to be stacked on top of other devices.
Depending on the speed of your network devices, you need a Category 3 (10 Mbps),
Category 5 (100 Mbps), or Category 5e (1000 Mbps) Ethernet cable with RJ-45
connectors for each device you want to connect to the switch. Each Ethernet cable must be
less than 328 feet (100 meters).
High priority port: dark green
Medium priority ports: light green
Low priority ports: yellow
r
Note: The GS605AV will optimize audio/video streaming prioritization if it can recognize
the pattern. If the GS605AV cannot recognize the pattern, you still can use port-based QoS
to manually configure priority for your devices.
Download from Www.Somanuals.com. All Manuals Search And Download.
|