HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 506033-56
Rev. NC, 08/2011
GRANDVIEW™ BLOWER KIT
INSTALLATION INSTRUCTIONS FOR INSTALLING ThE BLOWER
ON A GRANDVIEW™ 230 WOODSTOVE
INSTALLATION INSTRUCTIONS
KIT CONTENTS
Please ensure that all these parts are included
Step 1. Remove round knockout plate on back of stove by removing the
screw on the top of the knockout with a 5/32” allen wrench. You
can then push on the top and bottom of the plate to loosen for
removal.
Step 2. Install the four supplied flat Tinnerman nuts into the four rect-
angular slots on the back of the stove. Use of a flat head screw
driver will be necessary.
1 ea. Blower w/snap switch assembly
6 ea. 10-24 Screws
4 ea. Tinnerman nuts
Grandview™ Blower Kit
Cat. No.
h8350
Model
Description
BLWR-GV-700-SS Blower
Snap Switch
TOOLS NEEDED
Flat Head Screwdriver
5/32” Allen Wrench
1/8” Allen Wrench
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact you local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installa-
tion.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN ThE INSTAL-
LATION AND OPERATION MANUAL PROVIDED WITh ThE APPLIANCE
APPLY TO ThESE INSTRUCTIONS.
Check the contents of the kits upon receipt and check for any damaged
or missing parts. If there is hidden damage, notify your freight company
or Lennox Hearth Products dealer immediately.
CAUTION: Wear gloves during installation in case of sharp
edges on the stove.
Tinnerman Nut
Figure 1
1
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Download from Www.Somanuals.com. All Manuals Search And Download.
|