Eng_9222_2475_21.qxd 2002.3.22 2:06 PM Page 1
Minoltaring 11, D-30855 Langenhagen, Germany
Senator-Helmken-Strasse 1, D-28197 Bremen, Germany
365 Route de Saint-Germain, F-78420 Carrieres-Sur-Seine, France
7 Tanners Drive, Blakelands, Milton Keynes, MK14 5BU, England
Amalienstrasse 59-61, A-1131 Wien, Austria
Zonnebaan 39, P.O. Box 6000, NL-3600 HA Maarssen, The Netherlands
Prins Boudewijnlaan 1, B-2550 Kontich, Belgium
Riedstrasse 6, CH-8953 Dietikon, Switzerland
Albygatan 114, S-171 54 Solna, Sweden
Niittykatu 6 PL 37, SF-02201 Espoo, Finland
Av. do Brasil 33-A, P-1700 Lisboa, Portugal
101 Williams Drive, Ramsey, New Jersey 07446, U.S.A.
11150 Hope Street Cypress, CA 90630, U.S.A.
369 Britannia Road East, Mississauga, Ontario L4Z 2H5, Canada
230-3771 Jacombs Road, Richmond, B.C. V6V 2L9, Canada
Room 208, 2/F, Eastern Center, 1065 King’s Road, Quarry Bay, Hong Kong
10, Teban Gardens Crescent, Singapore 608923
E INSTRUCTION MANUAL
368 Minolta Road, Songjiang, Shanghai, China
©2002 Minolta Co., Ltd. under the Berne Convention and Universal
Copyright Convention
9222-2475-21 AK-A201
Printed in China
Thank you for purchasing this Minolta camera. Before using your new
camera, please take the time to read through this instruction manual. It
contains important information on the proper use and care of the cam-
era.
*Keep these surfaces clean. Please read the care
and storage section in this manual.
FRONT
1. Remote-control receiver*
(Quartz-date model only)
2. AF windows*
Read and understand all warnings and cautions before using this
product.
3. Meter window*
4. Viewfinder window*
5. Red-eye reduction/
Self-timer lamp
6. Flash*
7. Tripod socket
8. Lens*
9. Battery-chamber door
10. Strap eyelets
Using batteries improperly can cause them to leak harmful solutions,
overheat, or explode which may damage property or cause personal
injury. Do not ignore the following warnings.
• Only use the batteries specified in this instruction manual.
• Do not install the batteries with the polarity (+/–) reversed.
• Do not use batteries which show wear or damage.
• Do not expose batteries to fire, high temperatures, water, or
moisture.
• Do not attempt to recharge, short, or disassemble batteries.
• Do not store batteries near or in metallic products.
• Do not mix batteries of different types, brands, or ages.
• Do not use leaking batteries. If fluid from the batteries enters your
eye, immediately rinse the eye with plenty of fresh water and
contact a doctor. If fluid from the batteries makes contact with your
skin or clothing, wash the area thoroughly with water.
• Tape over battery contacts to avoid short-circuiting during disposal;
always follow local regulations for battery disposal.
11. Data panel
12. Mode button
13. Main switch
14. Shutter-release button
15. Manual-rewind button
16. Zoom lever
BACK
17. Film window
18. Viewfinder*
19. Indicator lamp
20. Data back
(Quartz-date model only)
21. Back cover
22. Back-cover release
• Do not disassemble this product. Electric shock may cause injury if
a high voltage circuit inside the product is touched.
• Immediately remove the batteries and discontinue use if the
camera is dropped or subjected to an impact in which the interior,
especially the flash unit, is exposed. The flash has a high voltage
circuit which may cause an electric shock resulting in injury. The
continued use of a damaged product or part may cause injuries.
• Keep batteries or small parts that could be swallowed away from
infants. Contact a doctor immediately if an object is swallowed.
• Store this product out of reach of children. Be careful when around
children, not to harm them with the product or parts.
• Do not fire the flash directly into the eyes. It may damage eyesight.
• Do not fire the flash at vehicle operators. It may cause a distraction
or temporary blindness which may lead to an accident.
• Do not look directly at the sun or strong light sources through the
viewfinder. It may damage your eyesight or cause blindness.
• Do not expose this product to liquids or operate this product with
wet hands. If liquid enters the product, immediately remove the
batteries and discontinue use. The continued use of a product
exposed to liquids may cause damage or injury through fire or
electric shock.
23. Low-battery indicator
24. Frame counter
25. Mode indicators:
Autoflash
DATA PANEL
VIEWFINDER
Self-timer/Remote control
(
appears on the quartz-date model only)
Fill-flash
Flash cancel
Landscape/Night view
• Do not use the product near inflammable gases or liquids such as
gasoline, benzine, or paint thinner. Do not use inflammable
products such as alcohol, benzine, or paint thinner to clean the
product. The use of inflammable cleaners and solvents may cause
an explosion or fire.
• If the product emits a strange odor, heat, or smoke, discontinue
use. Immediately remove the batteries taking care not to burn
yourself, as batteries become hot with use. The continued use of a
damaged product or part may cause injuries.
26. Indicator lamp
Steady: focus confirmed
Blinks quickly: subject too close
Blinks slowly: flash charging
• The indicator lamp lights when the shutter-
release button pressed partway down.
27. Focus frame
• Take the product to a Minolta Service Facility when repairs are
required.
• Do not use or store the product in a hot or humid environment such
as the glove compartment or trunk of a car. It may damage the
product and batteries which may result in burns or injuries caused
by heat, fire, explosion, or leaking battery fluid.
• If batteries are leaking, discontinue use of the product.
• The lens retracts when the camera is turned off or the auto-power-
off function is activated. Touching the lens barrel while it is
retracting may cause injury.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not approved by the party responsible for compliance could void
the user's authority to operate the equipment. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
• Do not fire the flash while it is in contact with people or objects. The
flash unit discharges a large amount of energy which may cause
burns.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
This mark on your camera certifies that this camera meets the requirements of the EU
(European Union) concerning interference causing equipment regulations. CE stands for
conformité Européenne (European Conformity).
Download from Www.Somanuals.com. All Manuals Search And Download.
The flash will not fire. Use flash cancel when
flash photography is prohibited, natural light
is desired to illuminate the subject, or the
subject is beyond the flash range.
The camera has five modes.
Press the mode button until the
desired indicator is displayed on
the data panel.
Each time the mode button is
pressed the mode cycles as
shown. When the camera is
turned off, the mode is reset to
autoflash.
Press the mode button until flash-cancel
indicator ( ) is displayed on the data
panel. Take the picture as described in
the full-auto operation section.
• Shutter speeds may be slow. The use of a tripod
is recommended.
The flash will not fire in this mode and the
focus is set to infinity. Landscape/night view
is used for photographing outdoor scenery
during the day or at night.
The flash will automatically fire in
low light when the shutter is
released to take the picture.
The flash range depends on the film
speed and focal length in use. To
ensure proper exposure, the subject
must be within the flash range.
Press the mode button until land-
scape/night-view indicator ( ) is dis-
played on the data panel. Take the pic-
ture as described in the full-auto opera-
tion section.
• Shutter speeds may be slow. The use of a tripod
is recommended.
• Always use this mode when photographing land-
scapes through windows.
The self-timer delays release of the
shutter for approximately 10 seconds
after the shutter-release button is
pressed.
1.Place the camera on a tripod.
Press the mode button until the
self-timer indicator ( ) is dis-
played on the data panel.
2.Place the focus frame on the
subject. Press the shutter-
release button all the way down
to start the countdown.
• The self-timer indicator on the data panel
and the self-timer lamp will blink during
the countdown. The self-timer lamp glows
steadily just before the shutter releases.
• Self-timer is automatically canceled after
the shutter is released.
• To stop the self-timer, press the mode
button. To cancel the self-timer and reset
the camera, press the main switch.
The flash fires with each exposure
regardless of the amount of ambient
light. Fill-flash can be used to reduce
harsh shadows caused by strong
direct light or sunshine.
Press the mode button until the
fill-flash indicator ( ) is displayed
on the data panel. Take the pic-
ture as described in the full-auto
operation section.
Download from Www.Somanuals.com. All Manuals Search And Download.
|