Invacare Indoor Furnishings 9610 1 User Manual

Installation of Rectangular Pan Holder and Pan  
Assembly,Installation and Operating Instructions  
MODEL Nos. 9640-4, 9640-1, 9630-4, 9630-1, 9620-4, 9620-1, 9610-4 and 9610-1  
4. Slide the remaining bracket up and over the remaining  
SAVE THESE INSTRUCTIONS  
NOTE: Check all parts for shipping damage before using.  
In case of damage, DO NOT use the equipment. Contact  
your Dealer/Carrier for further instruction.  
portion of the existing pail hanger. Open end of pan  
holder should face to the rear of the commode.  
5. Ensure that it is properly situated onto existing pail  
hanger.6. InstallNEWrectangularpanontotheNEW  
pan holder from the rear of the commode by sliding  
the back end of the lipped top of the rectangular pan  
onto the NEW pan holder rails and push it forward.  
SAFETY SUMMARY  
Thefollowingrecommendationsaremadeforthesafe  
andproperinstallationanduseoftheRectangularPan  
Holder and Pan:  
7. To remove pan and pan holder, reverse STEPS 3-6.  
GENERAL WARNING  
Existing Pail  
Hanger  
DO NOTinstalloruse thisequipmentwithoutfirstread-  
ing and understanding this instruction sheet. If you  
are una ble to understa nd the Warnings, Cautions  
and Instructions, contact a healthcare professional,  
dealer or technical personnel before a ttempting to  
install this equipment - otherwise, injury or damage  
may occur.  
Before using the commode: Always test to see that  
all parts of the commode are secure. Make certain  
ALL screws, nuts a nd/or bolts a re tight a t a ll times.  
Install Pan Holder  
Users with limited physica l ca pa bilities should be  
supervised ora ssisted when utilizing the commode.  
The a pplica ble commodes listed ha ve a weight  
limitation of 300 lbs. (135 kg.). The Extra Wide Com-  
mode ha s a weight limita tion of 450 lbs. (202.5 kg.).  
INSTALLATION WARNING  
AfterANYadjustments, repairorservice and BEFORE  
use, ma ke sure tha t a ll a tta c hing ha rdwa re is  
tighte ne d se c urely.  
Existing Pail  
Hanger  
Install Pan to  
Pan Holder from  
Rear of Commode.  
INSTALLING RECTANGULAR PAN  
HOLDER AND PAN ONTO EXISTING  
STANDARD COMMODE PAIL  
HANGER (FIGURE 1)  
Back Rail of Commode  
1. Remove original commode lid from commode by  
grasping and pulling straight up.  
2. Remove existing commode seat by grasping and  
pulling straight up.  
FIGURE 1 - INSTALLING RECTANGULAR PAN  
HOLDER AND PAN ONTO EXISTING  
3. Install the rectangular pan holder onto existing  
commode pail hanger framework by placing bracket  
of one side over the existing pail hanger.  
STANDARD COMMODE PAIL HANGER  
INVACARE CORPORATION  
899 Cleveland St. l Elyria, Oh. 44036-2125 l Customer Service - Toll Free (800) 333-6900  
Form No. 97-105  
P/N 1069323  
Printed in USA  
Download from Www.Somanuals.com. All Manuals Search And Download.  

John Deere Water Pump AC CP2GH User Manual
Jumpking Fitness Equipment Jump Pod User Manual
JVC Digital Camera GR D70 User Manual
JVC Speaker System CA FSX1 User Manual
JVC Stereo System UX P30 User Manual
JVC VCR HR A630EK User Manual
Kenwood Universal Remote RC R0801 User Manual
Kicker Car Stereo System ZX3504 User Manual
King Canada Drill KC 13C FC User Manual
KitchenAid Cooktop KECC567KBL03 User Manual