Questions?
Quick Setup Guide
Do not return to the store. We can help.
Call Customer Service Toll-Free 1-800-317-7833
Or visit our website www.snapper.com
Self-Propelled Mower Model SPV22675HWFC
Unpack the mower
Remove the mower from the carton. Remove all packing materials from the mower.
Add oil and fuel
Move the mower outside to a flat, level surface.
B
1
5
A
•
•
•
•
Locate and identify the items included with the mower.
Remove the oil fill cap (A, Figure 3). Add the entire contents of the
supplied oil container to the engine. Replace the oil fill cap.
Failure to read and follow instructions in the
operator's manual could result in death and/or
bodily injury.
Figure 3
IMPORTANT Mower is shipped without oil in engine.
Failure to add oil will result in engine damage.
Read the manuals
Carefully read all the manuals supplied with the mower. They contain important safety, operating, and
maintenance information.
2
•
•
•
Remove the fuel fill cap (B). Following the three-step instructions on the
FreshStartTM card, snap the fuel preserver cartridge into the bottom of
the fuel fill cap.
DANGER
Fuel stabilizer is a hazardous chemical.
IF SWALLOWED, call a physician immediately.
Fuel stabilizer contains:
Unfold the handle
Turn the knobs (A, Figure 1) on either side
of the lower handle 1/4 turn to retract the
locking pins.
Add clean, fresh, UNLEADED fuel with a minimum of 87 octane, leaving
one inch of space from the top of the tank for fuel expansion.
3
2,6-di-tert-butylphenol (128-39-2) and
aliphatic petroleum distillate (64742-47-8).
•
•
IMPORTANT Fuel tank holds less than 1/2 gallon.
IMPORTANT DO NOT mix oil with fuel.
B
Raise the lower handle, aligning it with one
of the three sets of holes in the handle
bracket (most users will prefer the middle
position).
•
Replace the fuel fill cap, and wipe up any spills.
Running engines give off carbon monoxide, an
odorless, colorless, poison gas. Breathing carbon
monoxide can cause nausea, fainting, or death.
SPV22675HWFC Overview
Operate this product ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate this product inside any building or
enclosure, even if windows and doors are open.
A
Bail Control
•
•
Turn the knobs to release the locking pins
and secure the lower handle.
Loosen, but do not remove, the upper
knobs (B) on the handle. Remove the
cardboard slats.
Start the mower
6
A
•
Move the cutting height adjust levers (A, Figure 4) to the desired
A
•
Raise the upper handle to the operating
position, and tighten the upper knobs.
cutting height.
Recoil Rope
Drive
Lever
Handle
•
•
•
•
Set the mower to mulch, discharge or bag. (See 3-in-1 instructions below.)
Hold the bail control (A, Figure 5) against the drive handle.
Pull the recoil rope handle (B) until the engine starts.
Figure 4
Figure 1
Fuel Fill Cap
To engage the drive system, slowly pull the drive lever (C) back. To
increase ground speed, slowly pull the drive lever farther back. To
decrease ground speed, slowly release the drive lever.
Oil Fill and
Dipstick
Set up the recoil rope handle
Hold the bail control against the handle,
and pull the recoil rope handle out to the rope
guide (A, Figure 2) on the handle. Hook the recoil rope
into the rope guide (it might be a tight fit).
4
•
•
To disengage the drive system, release the drive lever.
To stop the engine and blade, release the bail control.
•
Mulching
Cover
A
B
A
C
Figure 5
Figure 2
Cutting Height Adjust Lever
3-in-1: Convert from mulching to bagging to side-discharge:
(At Each Wheel)
A
1 For mulching:
2 To convert to bagging:
3 To convert to side-discharge:
A
Items that you will need
•
Leave the mulching cover
(Figure 6) in place.
•
Lift the rear door (A, Figure 7).
•
Lift the mulching cover (A, Figure 9).
Unleaded Fuel (minimum 87 octane)
Utility Knife
•
Holding the rear door open, attach the
grass catcher (B) to the rear of the mower.
•
Install the side discharge deflector (B) onto
the mower deck. Make sure the upper tabs (A,
Figure 10) of the deflector are hooked behind
the mulching cover rod, and the deck tabs
stick up through the locking slots (B).
B
B
FreshStartTM Fuel
Preserver Cartridge
•
•
Make sure the hooks (A, Figure 8) on
either side of the catcher frame hook
onto the rear door rod (B).
Figure 7
Figure 9
Items Included
Side Discharge
Deflector
A
Figure 6
•
Release the mulching cover (it will lay
on top of the side discharge deflector).
A
Release the rear door (it will lay on top of
the grass catcher).
B
B
SAE30W
Oil
Operator’s
Manual
Figure 8
Figure 10
Grass Catcher
© Briggs & Stratton Corporation
Form No. 7101691 (Rev. ‘-’, 4/7/2008)
TP 1099-5390---WB-N
We reserve the right to improve our products and make changes in specifications, designs, and standard equipment without notice and without incurring obligation.
|