Snapper Lawn Mower SLT23460 7800342 User Manual

SET-UP INSTRUCTIONS & PRE-OPERATION CHECKLIST for SNAPPER  
19” STEEL DECK WALK BEHIND MOWERS  
INTRODUCTION: The SNAPPER 19” Walk Behind Mowers are shipped almost fully assembled and require  
minimal set-up. Complete each of the following steps carefully. Review and complete each item as instructed  
on the Pre-Operation checklist. The Snapper Product Registration card must be filled out and sent to Customer  
Service department at Snapper when completed.  
STEP 1: Remove machine from shipping carton. Machine  
is shipped in carton with handles disconnected. Remove  
and discard cardboard from between all handles. Raise  
upper handle until it is seated in both lower handles.  
Securely tighten handle T-Knobs on both sides. Position  
handles and secure with nuts and bolts to the lower deck  
brackets. Tighten nuts and bolts securely. See Figure 1.  
STEP 4: Handle height is adjustable for different height of  
operators. Loosen the two nuts on the inside of each of  
the lower handles. See Figure 2. Move the handle up or  
down to the desired height. Retighten all nuts securely  
after adjustment.  
NOTE: Handles are mounted on the inside of the deck  
brackets. Insert bolts so that the nuts will be towards the  
inside of the brackets. See Figure 2.  
UPPER  
ROPE  
HANDLE  
GUIDE  
BLADE  
CONTROL BAIL  
LOWER HANDLE  
NUTS  
T-KNOBS  
RECOIL ROPE  
LOWER  
HANDLE  
LOWER  
BRACKETS  
FIGURE 2  
STEP 5: CHECKLIST: Complete all items on the Pre-  
Operation Checklist as instructed.  
FIGURE 1  
IMPORTANT: DO NOT tip machine with carburetor or  
spark plug down. Oil from crankcase will saturate the air  
filter and cause the engine to be hard to start or not start  
at all. If contamination does occur, the air filter will have to  
be replaced.  
STEP 2: Tip mower back against the upper handle to gain  
access to cutting blade. Remove foam shipping block  
from cutting blade. This must be removed before starting  
the engine.  
STEP 3: Route recoil rope up to rope guide on upper  
handle. Move blade control bail up to handle. Pull recoil  
handle to extend rope past guide. Insert rope into guide.  
INSTRUCTION NO. 7-5114 (I.R. 6/21/02)  
1

Craftsman Lawn Mower 291376500 User Guide
Cub Cadet Lawn Mower 22HP Z Force 48 User Guide
Exmark Lawn Mower TT20KCE User Guide
Ford Lawn Mower 58064 User Guide
Land Pride Lawn Mower DRG04 User Guide
Sears Lawn Mower 91725271 User Guide
Snapper Lawn Aerator 2636 User Manual
Snapper Lawn Aerator 4559 User Guide
Snapper Lawn Mower BC25H User Manual
Snapper Lawn Mower Steel Deck Commercial Walk Behind Mowers User Manual