Snapper Lawn Mower S22675 User Manual

Questions?  
Quick Setup Guide  
Do not return to the store. We can help.  
Call Customer Service Toll-Free 1-800-317-7833  
Or visit our website www.snapper.com  
Push Mower Models S22675 - NS22675  
Unpack the mower  
Remove the mower from the carton. Remove all packing materials from the mower.  
Add oil and fuel  
Move the mower outside to a flat, level surface.  
B
A
1
5
Locate and identify the items included with the mower.  
Remove the oil fill cap (A, Figure 3). Add the entire contents of the  
supplied oil container to the engine. Replace the oil fill cap.  
Failure to read and follow instructions in the  
operator's manual could result in death and/or  
bodily injury.  
Figure 3  
IMPORTANT Mower is shipped without oil in engine.  
Failure to add oil will result in engine damage.  
Read the manuals  
Carefully read all the manuals supplied with the mower. They contain important safety, operating, and  
maintenance information.  
2
Remove the fuel fill cap (B). Following the three-step instructions on the  
FrestStartTM card, snap the fuel preserver cartridge into the bottom of  
the fuel fill cap.  
DANGER  
Fuel stabilizer is a hazardous chemical.  
IF SWALLOWED, call a physician immediately.  
Fuel stabilizer contains:  
Add clean, fresh, UNLEADED fuel with a minimum of 87 octane, leaving  
one inch of space from the top of the tank for fuel expansion.  
2,6-di-tert-butylphenol (128-39-2) and  
aliphatic petroleum distillate (64742-47-8).  
Unfold the handle  
Turn the knobs (A, Figure 1) on either side  
of the lower handle 1/4 turn to retract the  
locking pins.  
3
IMPORTANT Fuel tank holds less than 1/2 gallon.  
IMPORTANT DO NOT mix oil with fuel.  
IMPORTANT DO NOT use E85 fuel.  
B
Running engines give off carbon monoxide, an  
odorless, colorless, poison gas. Breathing carbon  
monoxide can cause nausea, fainting, or death.  
Replace the fuel fill cap, and wipe up any spills.  
S22675 - NS22675 Overview  
Raise the lower handle, aligning it with one  
of the three sets of holes in the handle  
bracket (most users will prefer the middle  
position).  
Operate this product ONLY outdoors.  
Keep exhaust gas from entering a confined area through  
windows, doors, ventilation intakes or other openings.  
DO NOT operate this product inside any building or  
enclosure, even if windows and doors are open.  
A
Bail Control  
Turn the knobs to release the locking pins  
and secure the lower handle.  
NOTE: The lower handle on some models  
features removable hardware in place of the  
retractable knobs.  
A
A
Recoil Rope  
Handle  
Start the mower  
Move the cutting height adjust levers (A, Figure 4) to the desired  
cutting height.  
6
Loosen, but do not remove, the upper  
knobs (B) on the handle. Remove the  
cardboard slats.  
Figure 4  
Raise the upper handle to te operating  
position, and tighten the uppknobs.  
Set the mower to mulch, discharge or bag. (See 3-in-1 instructions below.)  
Hold the bail control (A, Figure 5) against the drive handle.  
Pull the recoil rope handle (B) until the engine starts.  
Figure 1  
Fuel Fill Cap  
Oil Fill and  
Dipstick  
Set up the recoil rope handle  
4
To stop the engine and blade, release the bail control.  
B
Hold the bail control (A, Figure 2) against the handle,  
and pull the recoil rope handle out to the rope  
guide (B) on the handle. Hook the recoil rope  
into the rope guide (it might be a tight fit).  
Mulching  
Cover  
B
A
A
Figure 2  
Figure 5  
Cutting Height Adjust Lever  
(At Each Wheel)  
3-in-1: Convert from mulching to bagging to side-discharge:  
A
1 For mulching:  
2 To convert to bagging:  
3 To convert to side-discharge:  
A
Items that you will need  
Leave the mulching cover  
(Figure 6) in place.  
Lift the rear door (A, Figure 7).  
Lift the mulching cover (A, Figure 9).  
Utility Knife  
Unleaded Fuel (minimum 87 octane)  
Holding the rear door open, attach the  
grass catcher (B) to the rear of the mower.  
Install the side discharge deflector (B) onto  
the mower deck. Make sure the upper tabs (A,  
Figure 10) of the deflector are hooked behind  
the mulching cover rod, and the deck tabs  
stick up through the locking slots (B).  
B
B
FreshStartTM Fuel  
Preserver Cartridge  
Make sure the hooks (A, Figure 8) on  
either side of the catcher frame hook  
onto the rear door rod (B).  
Figure 7  
Figure 9  
Items Included  
Side Discharge  
Deflector  
A
Figure 6  
Release the mulching cover (it will lay  
on top of the side discharge deflector).  
A
Release the rear door (it will lay on top of  
the grass catcher).  
B
B
SAE30W  
Oil  
Operator’s  
Manual  
Figure 8  
Figure 10  
Grass Catcher  
© Briggs & Stratton Corporation  
We reserve the right to improve our products and make changes in specifications, designs, and standard equipment without notice and without incurring obligation.  
Form No. 7104975 (Rev. ‘-’, 11/11/2010)  

Briggs Stratton Lawn Mower SPV21E1 User Manual
Snapper Lawn Mower 3312511BE User Manual
Snapper Lawn Mower CRP216018KWV User Manual
Snapper Lawn Mower GM2515KAW User Manual
Snapper Lawn Mower P2187520BVE 7800432 User Manual
Snapper Lawn Mower V2124 User Manual
Snapper Lawn Mower Y30120 User Manual
Stiga Lawn Mower 50 4SE User Guide
Stiga Lawn Mower 107 M EL User Guide
Swisher Lawn Mower RT10544 RT80044 User Guide