ZXT Roll Over Protective Structure
Assembly Instructions
ZXT54 Pro & ZXT72 Pro Zero Turn Mowers
Manual No. 357-274M
Before You Start
IMPORTANT: Your ZXT mower seat must have seat
belt mounting holes in the back rest side plates. See
Figure 1, balloon (B). If it does not, you will need to
replace your seat with one that does.
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
A detailed listing of parts for this accessory kit is
provided on page 2. Use the list as a checklist to
inventory parts received. Please contact your local Land
Pride dealer for any missing hardware.
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Initial Preparations
1. Park unit on a flat level surface. Make sure blade
engagement switch is (OFF), both control levers are
fully (OUT), park brake is (ON) and switch key is
turned (OFF) and removed.
Your Roll Over Protective Structure is exclusively
designed for your Land Pride ZXT mower. Please read
these installation instructions and your ZXT mower
Operator’s Manual thoroughly before beginning.
Especially read information relating to safety concerns.
Also included in the Operator’s Manual is important
information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some manual
sections do not apply to all accessories).
A separate Parts Manual for the Zero Turn Mower is
purchased from your nearest Land Pride dealer. Have
the model and serial number of your Zero Turn Mower
handy when placing an order.
Manual Part Numbers:
• Operator’s Manual . . . . . . . . . . . . . . . . . 357-271M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 357-271P
25974
General Information
Seat Belt Assembly (Deluxe Seat Shown)
Suspension Seat Also Includes Seat Belt Mounts (B)
Figure 1
These assembly instructions apply to the following
Accessory kits listed below:
357-273A
Folding ROPS W/Seat Belt, ZXT Series
Seat Belt Assembly
Tools required:
Refer to Figure 1
• Safety Glasses
1. Position seat belt (#1) with push button (A) on the right
hand side so that the button is facing up when folded
over onto the seat.
• Work Gloves
• Two 11/16" box end or open end wrenches
• Two 3/4" box end or open end wrenches
2. Insert 7/16"-20 x 1 1/2" bolt (#5) through 7/16" flat
washer (#4), seat belt (#1) and hole in mounting
bracket (B).
Assembly Instructions
3. Secure seat belt with 7/16" flat washer (#4) and
7/16" hex nylock nut (#3). Do not tighten nut.
!
WARNING
Do not modify the Roll Over Protective Structure in any way.
This Roll Over Protective Structure has been designed
specifically for this machine and any modifications can affect
its performance in the event of a roll over.
4. Rotate seat belt to the approximate angle shown and
tighten nylock nut to 36 ft-lbs. of torque.
5. Repeat steps 1 through 4 on the left hand side for the
buckle end of the seat belt (#2).
© Copyright 2008
Printed
3/31/08
Download from Www.Somanuals.com. All Manuals Search And Download.
1
|