INSTALL INSTRUCTIONS C-VS-1000-TAH
VEHICLE SPECIFIC CONSOLE
2007 CHEVY/GMC SUBURBAN/TAHOE/YUKON XL/YUKON
TOOLS REQUIRED:
Ratcheting wrench
Metric/Standard Socket Set
Standard Wrench Set
Power drill w/ 1/8” drill bit (optional)
Screwdriver set
T-20 torx bit
HARDWARE:
QTY DESCRIPTION
PART #
1
4
2
2
1
OEM switch bracket
¼-20 Serrated nut
¼-20 x ¾” Hex bolt
#10 x ¾” Sheet metal screw
Torx screw hardware kit
CM001800-3
GSM30023
GSM33001
GSM33195
C-HK-1
C-VS-1000-TAH
Switch cutout filler plate
CM001800-4
OEM switch bracket
CM001800-3
Supplied lighter plugs
#4
#5
#6
Using a flat head screwdriver
concentrate pressure on or around
the trim bezels “J” clips
Remove factory trim screws to
remove the lower switch panel on
dashboard
Remove entire bezel and put aside.
#7
#8
#9
Remove factory switch box from
trim panel
Using a small flat head
screwdriver, unclip fastener
Unplug switch and set aside for
later install
#10
#11
#12
Install switch box into
C-VS-1000-TAH (if necessary)
Attach switch box to console
using T-20 torx screws. Do not
over tighten screws. This will
cause the switches to “stick” in
the ON position.
View of factory console at this time
C-VS-1000-TAH-INST-1-07
#13
#14
#15
Install lighter plugs and extend
Slide C-VS-1000-TAH, front side
Carefully drop backside of
console as shown
wires as necessary.
first, as shown above.
#16
#18
#17
Re-attach factory plug into
switch box
Be sure plug is secure and
wires are carefully routed so
not to chafe
Align rear-mounting studs into
factory console holes and attach
using ¼” Serrated nuts.
For added
support install
#10 x ¾” screws
#19
Attach middle of VS console to factory console
using ¼” x ¾” Hex bolts and serrated nuts. For
added support #10 x ¾” screws can be installed
on front side of console
Route all wiring to console. Wire,
and install control heads and
accessories (Sold separately)
C-VS-1000-TAH-INST-1-07
|