Havis Shields Angled Series Consoles C AS MMP User Manual

C-AS-MMP ANGLED SERIES CONSOLES  
INSTALLATION INSTRUCTIONS  
FOR MODELS C-AS-1025, 1325, 1525 & 1725  
TOOLS REQUIRED:  
Standard and Metric Socket Set with 6” Extension  
Standard and Metric Wrench Set  
Torx driver #T15 and #T20  
HARDWARE:  
QTY: DESCRIPTION:  
PART #:  
12  
4
4
#8 X 3/8 Black Torx Screw  
¼-20 X ½” Pem Stud  
¼” Lock Washer  
CM86508  
GSM32220  
GSM31026  
GSM30005  
4
¼-20 Hex Nut  
PARTS SUPPLIED  
1
1
1
CM93569 – Monitor Platform Frame  
CM93628 – Support Plate  
Pair of Wire Panels  
C-AS-MMP  
C-AS-MMP-CV  
C-AS-MMP-IMP  
Monitor Mounting Platform  
& Wire Panels Crown Vic  
Monitor Mounting Platform  
& Wire Panels Impala  
Monitor Mounting Platform  
INSTALLATION: (Refer to pictures on page 2)  
1. Turn console over and remove (2) #8 X 3/8” Black torx screws on bottom of console.  
2. Place support plate on bottom of console as shown and replace (2) #8 X 3/8” Black torx screws.  
3. Turn console back over and place (4) ¼-20 X ½” pem studs on bottom of support plate and insert  
(4) ¼” lock washers and (4) ¼” Hex nuts over studs on inside of console housing, then tighten.  
4. Place monitor platform on front side of console and secure with (6) #8 X 3/8” Black torx screws.  
5. Place wire panels on front sides of console and secure with (6) #8 X 3/8” Black torx screws.  
6. Console is ready for mounting in car.  

Brother MFC 8680DN User Manual
Bunn TDS5 User Manual
Carrier 40RMS008 034 User Manual
CK Electric Part C3000 User Manual
Danby DAC7006DE User Manual
Exide S47 0079 User Manual
Garmin ARTISAN 725 User Manual
Graco MetroLite 1761213 User Manual
Heat Controller Inc Air Conditioner REG 183A User Manual
HP Hewlett Packard WORKCENTRE 228 User Manual