INSTALL INSTRUCTIONS C-VS-1800-ECO
2004-2008 FORD ECONOLINE VAN
TOOLS REQUIRED:
3/8” Standard Socket Set
3/8” Metric Socket Set
3/8” Ratcheting Wrench
Powered drill w/ drill bit set
Open-end wrench set
Screw driver set
HARDWARE & COMPONENTS:
QTY DESCRIPTION
PART #
6
4
2
4
4
1
¼-20 Nylock nut
¼” Flat washer
¼-20 x ¾” Carriage bolt
¼-20 x 1 ¼” Hex head bolt
#10 x 1” Phillips sheet metal screw
Torx Screw Hardware Kit
GSM30016
GSM31005
GSM32000
GSM33003
GSM33196
C-HK-1
Always!
ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
ꢀ Use hardware provided with install kit
INSTALL C-VS-1800-ECO:
1. Remove O.E.M. engine cover accessory package (cup holder/storage pocket).
2. Place new console housing with mount brackets against engine cover and
floor. Mark engine cover and drill four (4) - 5/16” diameter holes. Mark
outline of floor bracket.
Also remove
washers from studs
C-VS-1800-ECO_INST_9-07
6. Attach Console to Mount Brackets.
7. Finished Product
C-VS-1800-ECO_INST_9-07
|