INSTALL INSTRUCTIONS C-TCB-28
1997-2007 DODGE DAKOTA
TELESCOPING COMPUTER BASE
TOOLS REQUIRED:
Ratcheting wrench
3/8” Metric Socket Set
T-20 torx bit
Combination wrench set
Powered Drill
Drill Bit set
3/8” Standard Socket Set
HARDWARE:
QTY DESCRIPTION
PART #
4
1
1
1
1
1
1
1
1
¼” x 1” Hex head lag bolt
5/16” Flat Washer
5/16” Nylock Nut
“Z” Bracket Support
¼” x ¾” Carriage Bolt
¼” Serrated Nut
Pole Support Assembly
Lateral Support Brace
Inner Telescoping Pole Assembly
GSM33060
GSM31006
GSM30017
CM002001
GSM32000
GSM30023
CM93071-28W
CM93146
CM93072-3
Always!
ꢀ Disconnect the vehicles’ battery. Removing seat bolts on some vehicles may give the
vehicles computer a false reading leading to warning lights on dash. This requires the
vehicles’ computer to be reset.
ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
ꢀ Use hardware provided with install kit.
ꢀ For product support, visit the Install Instructions Section of our website at
1-800-524-9900.
Loosely attach lateral support brace
to TCB base using 5/16” flat washer
and 5/16” nylock nut
Pre-drill floor of vehicle with 3/16”
drill bit. Use holes in the support
brace as a drill template
Attach support brace to floor using
¼” x 1” hex head lag bolts
Tighten 5/16” nylock nut
Insert inner telescoping pole
assembly and thread lock handle
into pole support base assembly.
Final Installation
Install C-3090-x laptop platform (sold separately)
C-TCB-28-INST-6-07
3
|