MODEL G8731/G8732/
G8733
TOW DRAW BAR
INSTRUCTIONS
hitch receiver shaft
Ball hitch
Mounting
hole
1. This tow draw bar was designed to
mount into a 2" x 2" square hitch
receiver. NEvER use this product for
any purpose it was not designed for.
2. Know your load and tongue weight!
NEvER exceed the gross load towing
capacity or the tongue weight capacity
of the hitch receiver or draw bar.
hitch pin hole
tongue
3. When mounting the draw bar, only use
an approved hitch pin with a safety clip
properly installed through the hitch
receiver and draw bar.
figure 1. Model g8731/g8732/g8733
identification (shown in "lower" position).
Specifications
4. ALWAyS attach load-appropriate safe-
ty chains to the load and through the
hitch receiver chain loops.
Maximum load towing Capacity ......... 5000 lbs.
Maximum tongue Weight Capacity........ 500 lbs.
required hitch receiver size ......square 2" x 2"
required hitch pin ....5⁄8" diameter w/safety Clip
distance Between Center of hitch receiver shaft
& tongue:
— Model g8731.........................................2"
— Model g8732 ........................................4"
— Model g8733 ........................................6"
Ball hitch Mounting hole diameter .................. 1"
hitch receiver Construction................. 3⁄16" steel
5. ALWAyS thoroughly inspect each com-
ponent of the towing assembly for
damage or any unsafe condition before
attaching a load. If you are in doubt
about the safe operation of any of these
towing devices, DO NOT use them.
6. If you do not have experience towing
loads with your vehicle, WE STRONGLy
RECOMMEND that you read books or
get professional help before towing
any load. Grizzly will not be held liable
for accidents caused by lack of training
or failure to follow safe towing prac-
tices.
3
tongue Construction ............... Welded ⁄4" steel
Weight:
— Model g8731....................................7 lbs.
— Model g8732 ...................................9 lbs.
— Model g8733 ..............................13.5 lbs.
Copyright © oCtoBEr, 2008 By grizzly industrial, inC.
WARNING: NO pORTION Of ThIS MANUAL MAy BE REpRODUCED IN ANy ShApE
OR fORM WIThOUT ThE WRITTEN AppROvAL Of GRIzzLy INDUSTRIAL, INC.
#ts11147 printEd in China
|