Epson Stylus CX6600 User Manual

Start Here  
®
Epson Stylus CX6600  
1
1
Unpack  
Make sure you have all the parts shown here. If any parts are missing,  
contact Epson® as described on the back of this sheet.  
Epson Stylus CX6600  
Software  
CD-ROM  
Quick Guide  
Paper support  
Ink cartridges  
Feeder guard  
2
3
Remove all the blue packing tape from the printer.  
Caution: Do not remove the yellow sticker until instructed.  
Lift up the scanner.  
4
Peel off the tape from the ink cartridge holder.  
5
Close the scanner section.  
2
1
Attach the Parts  
Insert the paper support into the slots behind the printer, as shown.  
2
Lower the feeder guard into the slots behind the scanner lid.  
(Insert the hinges on the feeder guard into the corresponding  
slots on the printer.)  
3
1
Plug In and Turn On  
Plug the Stylus CX into a grounded electrical outlet.  
2
Press and hold the On button until the green lights come on.  
On button  
4
Install Ink Cartridges  
Wait until you see “Initial Charge” displayed on the LCD screen.  
Lift up the scanner.  
1
2
3
Shake the package of ink cartridges four or five times.  
Then remove the cartridges from the package.  
Don’t touch the green part  
Caution: You must install all the cartridges and leave them installed  
for all types of printing. To avoid damaging the Stylus CX, never  
move the print head by hand.  
4
5
6
Open the ink cartridge cover.  
Place each cartridge, one at a time, in its holder.  
Press down on each cartridge until it clicks into place.  
continue  
7
Close the ink cartridge cover, then close the scanner.  
The Stylus CX begins charging the ink delivery system.  
Charging takes about 2 minutes. The Stylus CX makes various  
sounds and “Charging . . .” appears on the LCD screen. Don’t turn  
it off while “Charging . . .” appears, or you’ll waste ink.  
5
1
Load Paper  
Extend the output tray.  
2
Slide the edge guide to the left.  
3
Place a stack of paper against the right side of the sheet feeder,  
but don’t push it in. Slide the edge guide against the paper.  
Turn over  
6
Install Software and  
Connect to Your Computer  
The software works with Windows® 98SE, Me, 2000, and XP, and Macintosh®  
OS 9.1.x to 9.2.x and 10.2.x to 10.3.x. Follow the steps below (for Windows),  
or the steps in the next column (for Macintosh).  
Note: There is a Security Lock program on your software CD-ROM that lets  
you prevent unauthorized use of your CX6600. See the Quick Guide for  
instructions on installing and using it.  
Windows  
1
Make sure the Stylus CX is not  
connected to your computer,  
then turn on your computer.  
Note: If you see several New  
Hardware Wizard screens, click  
Cancel for each of these screens and  
disconnect your Stylus CX. You can’t  
install your software that way.  
2
3
Insert your Stylus CX software CD-ROM in your CD-ROM or DVD drive.  
Wait until you see this screen,  
then click Install.  
Note: If you don’t see this screen,  
do the following:  
For Windows XP: click Start >  
My Computer. Then double-click  
the Epson CD-ROM icon.  
For Windows 98/Me/2000: double-click  
My Computer.  
Then double-click theEpson CD-ROM icon.  
4
5
Read the license agreement, then click Agree. Several messages  
display on your screen.  
When you see this screen, make sure  
your Stylus CX is turned on, then lift  
up the scanner.  
6
Remove the yellow  
sticker and plug the  
square end of the USB  
cable into the USB port  
on your Stylus CX.  
Then route the cable in  
the slot as shown.  
Caution: Make sure the USB cable fits securely into the slot. The USB  
connector may snap if the cable is not routed correctly in the slot and  
the scanner is closed with force.  
7
8
Close the scanner carefully.  
Plug the flat end of the  
cable into any available  
USB port on your  
computer.  
9
Click Next and follow the  
instructions on the screen to install  
more software.  
Note: It will take several minutes to install the software.  
Don’t cancel the installation.  
10 At the completion screen, print a test page, if desired. When done,  
click Next to install additional software.  
11 Follow the instructions on the screen to install additional software.  
When done, click Exit.  
12 When you see the Product Registration screen, register your Stylus CX  
as instructed, then remove the CD-ROM and restart your computer.  
Now you’re ready to copy, scan, and print. See the Quick Guide or your  
on-screen CX6600 Reference Guide for instructions.  
Macintosh  
1
Insert your Stylus CX software CD-ROM into your CD-ROM  
or DVD drive.  
2
Double-click the  
CD-ROM icon, if necessary. Then  
double-click the Epson installer  
Epson  
icon. You see this screen:  
3
4
Click Install.  
Read the license agreement, then  
click Agree.  
Note: If you’re installing on Macintosh OS X, enter your  
administrator name and password, if necessary.  
5
6
For Macintosh OS X: Continue with the following steps.  
For Macintosh OS 9: Follow any on-screen instructions,  
then continue with step 9.  
Click Install at the EPSON Scan  
Installer screen to install the  
scanner portion of your software.  
7
8
When the software finishes installing,  
you see this screen. Click Quit.  
Follow the on-screen instructions to  
install additional software.  
Note: Click Quit when each part finishes installing.  
9
When installation is complete, you see the Additional Software screen.  
Follow the instructions on the screen to install the software. When  
done, click Exit.  
10 When you see the Product Registration  
screen, register your Stylus CX as  
instructed, then remove the CD-ROM  
and restart your Macintosh.  
11 Make sure your Stylus CX is turned on,  
then lift up the scanner.  
12 Remove the yellow  
sticker and plug the  
square end of the USB  
cable into the USB port  
on your Stylus CX. Then  
route the cable in the slot  
as shown.  
Caution: Make sure the USB cable fits securely into the slot. The USB  
connector may snap if the cable is not routed correctly in the slot and  
the scanner is closed with force.  
13 Close the scanner carefully.  
14 Plug the flat end  
of the cable into  
any available USB  
port on your  
Macintosh.  
Follow the instructions below to add the Stylus CX to the  
Print Center or Printer Setup Utility (for OS X) or the Chooser (for OS 9).  
®
Selecting the Stylus CX for Mac OS X  
1
Open the OS X Applications folder, then open the Utilities folder and  
start Print Center or the Printer Setup Utility.  
If you see this screen, click Add.  
2
3
4
On the Printer List screen, click the  
Add button.  
On the next screen, select EPSON USB from  
the pop-up menu.  
Click Stylus CX6600.  
Note: If the CX6600 doesn't appear, make  
sure it is turned on and securely connected  
to your Macintosh.  
5
6
Click the Add button. You see the Stylus CX6600 in the Printer List.  
Quit Print Center or the Printer Setup Utility. Now you’re ready to copy,  
scan, and print. See the Quick Guide or your on-screen CX6600  
Reference Guide for instructions.  
7
If you use Classic Mode applications, install the software on OS 9 also.  
Selecting the Stylus CX for Mac OS 9  
1
2
Open the Chooser from the Apple® menu.  
Select CX6600 Series, then select  
your USB port and turn on  
background printing.  
3
Close the Chooser. Now you’re  
ready to copy, scan, and print. See  
the Quick Guide or your on-screen  
CX6600 Reference Guide for  
instructions.  
Any Problems?  
If the red ! error light is on, check the message on the Stylus CX. Try  
turning the Stylus CX off and then back on to clear the error. If your  
problem is listed here, try these suggestions. For more information, see  
your Quick Guide, software Help, or on-screen CX6600 Reference Guide.  
The Found New Hardware  
Wizard appears on  
your screen.  
Click Cancel and follow the steps in  
section 6. Disconnect the Stylus CX  
before installing the software.  
You see an error message  
when you try to print  
or scan.  
Make sure your Stylus CX is connected to  
your computer, plugged into a power  
source, and turned on.  
The Stylus CX  
doesn’t work.  
Make sure you removed the tape from the ink  
cartridge holder, as described in section 1.  
Turn the Stylus CX off and then on again.  
Make sure the ink cartridges are pushed  
all the way down.  
Check the LCD screen to see if you or  
someone else set the Security Lock. See  
your Quick Guide for details.  
Make sure your Epson Stylus CX6600  
software is installed correctly.  
Any Questions?  
Here’s where to look for answers:  
Epson Stylus CX6600 Quick Guide  
On-screen Reference Guide  
Double-click the CX6600 Reference Guide icon on your  
desktop to view your Reference Guide.  
On-screen help for EPSON Smart Panel, ArcSoft PhotoImpression,  
®
®
EPSON Scan, and ABBYY FineReader Sprint  
Click the Help button or question mark that appears on the screen  
when you’re using any of these programs.  
Epson Technical Support (Stylus CX6600 and EPSON Scan)  
• World Wide Web  
• Automated Telephone Services  
To use these services, you must have a touch tone telephone and call  
(800) 922-8911. Your Epson SoundAdviceSM Express Code is 70575.  
Use this code to quickly select your product in SoundAdvice.  
To speak to a Technical Support Representative  
Dial (562) 276-4382 (U.S.) or (905) 709-3839 (Canada), 6 AM to 6 PM,  
Pacific Time, Monday through Friday. Toll or long distance charges  
may apply.  
Software Technical Support  
Software  
Telephone and Fax  
Internet and E-mail  
EPSON Smart  
Panel  
(510) 445-8616  
Fax: (510) 445-8601  
ArcSoft  
PhotoImpression  
(510) 440-9901  
8:30 AM to 5:30 PM,  
Pacific Time,  
Monday–Friday  
Fax: (510) 440-1270  
ABBYY  
(510) 226-6719  
FineReader Sprint  
Fax: (510) 226-6069  
Need Paper and Ink?  
For the best prints and copies, use genuine Epson ink and paper. You can  
buy them from your local retailer or from the Epson StoreSM at (800) 873-7766,  
(800) 463-7766 for dealer referral.  
Look for these cartridges and paper:  
T0441  
T0431  
High  
Capacity Ink  
T0442  
Cyan  
T0443  
Magenta Yellow  
Ink Ink  
Black Ink Cartridge Cartridge Cartridge  
T0444  
Standard  
Capacity  
Black Ink  
Cartridge Cartridge  
Premium Bright White Paper  
Ultra-smooth white paper perfect for everyday  
use—especially two-sided documents.  
®
DURABrite Ink Glossy Photo Paper  
Heavier weight paper for long-lasting enlargements  
and snapshots.  
Double-Sided Matte Paper  
The ideal paper for high quality printing of  
brochures, newsletters, or flyers.  
Epson and Epson Stylus are registered trademarks and EPSON Smart Panel is a trademark  
of Seiko Epson Corporation. DURABrite is a registered trademark, and Epson Store and  
SoundAdvice are service marks of Epson America, Inc.  
General Notice: Other product names used herein are for identification purposes only and may be  
trademarks of their respective owners. Epson disclaims any and all rights in those marks.  
© 2004 Epson America, Inc. 5/04  
Printed in XXXXXX XX.XX-XX  
CPD-18233  

Fisher Price T3640 User Manual
Friedrich Air Conditioner SM24 User Manual
Friedrich WS10B10A User Manual
GE General Electric Air Conditioner AST06 User Manual
Graco MetroLite 1761221 User Manual
Haier AD362AMERA User Manual
Haier Air Conditioner AP075M User Manual
Haier AS162ATNCA User Manual
Haier HSU 09HEK03 User Manual
HP Hewlett Packard HP Photosmart 5510 B111A Multifunction Printer CQ176A#1BH User Manual