Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other
protective material should be placed between it and the furniture.
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such
as Benzene, thinner or similar materials can damage the surface of the unit.
Limited 1 Year Warranty Information
Model iHM89
Portable
Rechargeable Mini Speakers
•
•
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to
be free from defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date
of original purchase.
•
Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally
purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during
the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except for a $10.00
charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification of the defect or
malfunction upon delivery of this product to the Factory Service Center listed below. The product must include proof of
purchase, including date of purchase. The fee for service without proof of purchase is $20.00.
A Consumer Guide to Product Safety
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or
defective batteries are the most common cause of problems encountered.
If service is still required:
When used in the directed manner, this unit has been designed and manufactured to ensure your
personal safety. However, improper use can result in potential electrical shock or fire hazards. Please
read all safety and operating instructions carefully before installation and use, and keep these instructions
handy for future reference. Take special note of all warnings listed in these instructions and on the unit.
1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the
warranty period.
1. Water and Moisture – The unit should not be used near water. For example: near a bathtub,
washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.
2. Ventilation – The unit should be situated so that its location or position does not interfere with
its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface
that may block ventilation openings. Also, it should not be placed in a built-in installation, such as
a bookcase or cabinet, which may impede the flow of air through the ventilation openings.
3. Heat – The unit should be situated away from heat sources such as radiators, heat registers,
stoves or other appliances (including amplifiers) that produce heat.
3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($20.00 without
proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center listed below.
This device complies with Part 15 of the FCC Rules, operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Consumer Repair Department
SDI Technologies Inc.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
4. Power Sources – The unit should be connected to a power supply only of the type described
in the operating instructions or as marked on the appliance.
1330 Goodyear Drive
El Paso, TX 79936-6420
5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them. It is always best to have a clear
area from where the cable exits the unit to where it is plugged into an AC socket.
6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of
this manual for cleaning instructions.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i)
products which have been damaged by negligence or willful actions, misuse or accident, or which have been modified or
repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to
digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service
Center and its return to the owner.
7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not
spilled into any openings or vents located on the product.
8. Attachments – Do not use attachments not recommended by the product manufacturer.
9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect
the antenna or cable system during a lightning storm or when it is left unattended and unused for
long periods of time. This will prevent damage to the product due to lightning and power-line
surges.
This warranty is valid only in the United States of America and does not extend to owners of the product other than to the
original purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers, directors,
shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost
profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of
consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
IMPORTANT
Read before proceeding
Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is
contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of
your SDI Technologies product.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
If you have any question regarding the operation or use of this product, please visit www.ihomeaudio.com
to view answers to frequently asked questions.
E. the unit exhibits a marked change in performance or does not operate normally.
12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a
month or longer, the power cable should be unplugged from the unit to prevent damage or
corrosion.
© 2012 SDI Technologies, Inc. All rights reserved
For Models That Use Lithium Batteries:
• Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high temperatures &
not handled appropriately
13. Servicing – The user should not attempt to service the unit beyond those methods described in
the user’s operating instructions. Service methods not covered in the operating instructions should
be referred to qualified service personnel.
or call 1-800-288-2792 Toll Free
• Do not place loose batteries in a pocket, purse, or other container containing metal objects, do not mix with used or other battery
types, or store with hazardous or combustible materials.
or call 1-800-288-2792 Toll Free
• Store in cool, dry, ventilated area.
Download from Www.Somanuals.com. All Manuals Search And Download.
iHM89-053012-A
Printed in China
• Follow applicable laws and regulations for transport and disposal.
Using the iHM89
2-in-1 Charging/Audio Cable
included
Press down gently on each speaker to power it ON or OFF.
The speakers have magnetic bases. They can be joined
together for storage or for convenient travel with the included
travel pouch. To separate the speakers gently pull them apart.
Connecting the iHM89
The speakers and micro-USB plugs are marked L (left) and R
(right). When connecting, make sure to connect the L plug to
the L speaker and the R plug to the R speaker for proper
stereo sound. NOTE: A special battery-saving feature
prevents the speakers from powering on unless the
micro-USB plugs are connected. Check your USB
connections before using.
Connect speakers together
for storage or travel
• Connect a micro-USB plug to the input jack on each speaker
as instructed above.
• Connect the stereo 3.5mm audio plug to the headphone jack
or line-out of any audio device.
USB Connection
Power/Charging Indicator
LED
• Press down on each speaker to turn it ON. The blue Power
indicator light will come on. (Pressing down again will turn
the speaker OFF).
• Press play on your audio device and adjust its volume to
listen to audio.
Note: the larger USB plug is used for charging only, not
for audio. Please refer to next section for charging
instructions.
Charging the iHM89
Power ON
Position
Power OFF
Position
The iHM89 is powered by a rechargeable battery in each
speaker. When the blue power light dims, or if you start to
notice sound distortion at higher volumes, it's time to recharge
the batteries.
• Connect the larger USB plug to a powered USB port, such as
that on a computer. The indicator light on the speaker will
turn to red while charging and turn blue when fully charged.
Note: you can continue to listen to the speakers while
they are charging
NOTE: This product has magnets in the base of each
speaker. To avoid interference or possible damage, do not
place speakers directly on electronic devices such as
computers or monitors.
mobile phone
PSP
iPod
MP3/MP4
USB 2.0
PC
Laptop
Charging the iHM89
Connect To Audio Source
Download from Www.Somanuals.com. All Manuals Search And Download.
|