Internal Rechargeable Lithium-ion Battery
Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other
protective material should be placed between it and the furniture.
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such
as Benzene, thinner or similar materials can damage the surface of the unit.
Model : iK8
Portable Rechargeable Stereo
Speakers for Your Kindle Fire®
This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect
your battery may be dead, try charging it several times. If the battery does not recharge, please contact
us for repair information.
•
•
®
WARNING/DISPOSAL OF UNIT
Please do NOT attempt to change the battery yourself. If the battery has died and you do not want us to replace your
battery, you should follow the disposal instructions below:
•
•
•
Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.
Always dispose of used batteries/electronics in accordance with the prevailing community regulations that apply to the
disposal of batteries/electronics. If there are no local regulations concerning battery/electronics disposal, please dispose
of the device in a waste bin for electronic devices.
•
Many electronics retailers now recycle batteries and other electronic components at no charge. Check to see which
ones in your area do so.
A Consumer Guide to Product Safety
CAUTION
The battery used in this device may present a risk of fire, explosion or chemical burn if mistreated
•
•
Never use or charge the battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other
electrolytic substance.
When used in the directed manner, this unit has been designed and manufactured to ensure your
personal safety. However, improper use can result in potential electrical shock or fire hazards. Please
read all safety and operating instructions carefully before installation and use, and keep these instructions
handy for future reference. Take special note of all warnings listed in these instructions and on the unit.
•
Always confirm that the temperature is 5°C – 35° C (41° - 95° Fahrenheit) before you charge the battery. Leakage or
deterioration of the battery may occur if this warning is not heeded.
•
•
Never expose the battery to any liquid.
Never expose the battery to excessive heat such as direct sunlight or fire. Never use the battery pack in an unventilated
vehicle where excessive internal temperatures may be encountered.
•
Always keep the battery out of the reach of infants and small children.
1. Water and Moisture – The unit should not be used near water. For example: near a bathtub,
washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.
2. Ventilation – The unit should be situated so that its location or position does not interfere with
its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface
that may block ventilation openings. Also, it should not be placed in a built-in installation, such as
a bookcase or cabinet, which may impede the flow of air through the ventilation openings.
3. Heat – The unit should be situated away from heat sources such as radiators, heat registers,
stoves or other appliances (including amplifiers) that produce heat.
Limited 1 Year Warranty Information
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from
defects in workmanship and materials, under normal use and conditions, for a period of 1 Year from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.
Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI
Technologies will repair or, at its discretion, replace this product without charge (except for a $10.00 charge for handling, packing, return
UPS/postage, and insurance). This decision is subject to verification of the defect or malfunction upon delivery of this product to the
Factory Service Center listed below. The product must include proof of purchase, including date of purchase. The fee for service without
proof of purchase is $20.00.
4. Power Sources – The unit should be connected to a power supply only of the type described
in the operating instructions or as marked on the appliance.
FCC Information
This device complies with Part 15 of the FCC Rules, operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them. It is always best to have a clear
area from where the cable exits the unit to where it is plugged into an AC socket.
6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of
this manual for cleaning instructions.
Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted or defective
batteries are the most common cause of problems encountered.
If service is still required:
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for
7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not
spilled into any openings or vents located on the product.
1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within the warranty period.
3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($20.00 without proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center listed below.
compliance could void the user’s authority to operate the equipment.
8. Attachments – Do not use attachments not recommended by the product manufacturer.
9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect
the antenna or cable system during a lightning storm or when it is left unattended and unused for
long periods of time. This will prevent damage to the product due to lightning and power-line
surges.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
Consumer Repair Department
SDI Technologies Inc.1330 Goodyear Drive El Paso, TX 79936-6420
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles
as this can result in a risk of fire or electric shock.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which
have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized
persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape cassettes
(if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
11. Damage Requiring Service – The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
C. the unit has been exposed to rain.
• Reorient or relocate the receiving antenna.
This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original
purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members
or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive
damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions
may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
D. the unit has been dropped or the enclosure damaged.
• Increase the separation between the equipment and receiver.
E. the unit exhibits a marked change in performance or does not operate normally.
12. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a
month or longer, the power cable should be unplugged from the unit to prevent damage or
corrosion.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually
binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI Technologies
product.
13. Servicing – The user should not attempt to service the unit beyond those methods described in
the user’s operating instructions. Service methods not covered in the operating instructions should
be referred to qualified service personnel.
© 2012 SDI Technologies, Inc. All rights reserved
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
or call 1-800-288-2792 Toll Free
iK8-051512-A
Printed in China
or call 1-800-288-2792 Toll Free
Download from Www.Somanuals.com. All Manuals Search And Download.
Setup
The unit includes a travel case that doubles as a stand for your Kindle Fire®
or other tablet or device. Reverse these steps to repack for travel.
Press here to open
To use as a stand:
a. Press in on center of the case where indicated to release the lid from the
base.
b. Remove speakers. Remove cables from compartment in top of case.
c. Place base of case upside down on flat, stable surface with tab facing
forward.
d. Slide the top (iHome brand badge facing upwards) onto the tab on the
bottom/stand.
Step c/d
Step b
Step a
Step e
e. Place Kindle Fire into groove. For best stability, position Kindle Fire/tablet in
landscape mode.
Connect the iK8
Power/Charging Indicator LED
• The mini USB plugs are marked L (left) and R (right). Connect the proper
mini-USB plug to the input jack on each speaker.
• Connect the stereo 3.5mm audio plug to the headphone jack or line-out of
any audio device.
• Slide the Power Switch of each speaker to the ON position. The blue
Power/Charging Indicator LED on the speaker will come on.
• Press play on your audio device and adjust its volume to listen to audio.
• When you are through listening, turn each speaker OFF to save battery life.
Note: the larger USB plug is used for charging only, not for audio. Please refer
to next section for charging instructions
Charging the iK8
The iK8 is powered by a rechargeable battery in each speaker. When the
blue power light dims, or if you start to notice sound distortion at higher
volumes, it's time to recharge the batteries.
• Connect the larger USB plug to a powered USB port, such as that on a
computer. The Power/Charging Indicator LED on the speaker will turn red
while charging and turn blue when fully charged.
USB Connection
Power Switch
mobile phone
PSP
PC
iPod
MP3/MP4
Laptop
USB 2.0
Kindle
fire
Charging the iK8
Kindle Fire® is a registered trademark of Amazon Technologies, Inc.
Note: you can continue to listen to the speakers while they are charging
Connect To Audio Source
Download from Www.Somanuals.com. All Manuals Search And Download.
|