NOTE:
Please read all instructions
carefully before using this
product
Table of Contents
Safety Notice
Hardware Pack
Assembly Instruction
Parts List
POWERHOUSE BENCH
PHC-700
Warranty
Ordering Parts
Model
PHC 700
Retain This
Manual for
Reference
07-19-03
OWNER'S
MANUAL
IMPEX FITNESS PRODUCTS
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE
OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT.
IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE
SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE PACK
3
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Right and Left Upright Beams (#1 & 2) by a Cross Brace (#3) in the mid-
span. Align the holes and secure each end with one Bracket (#17), two M10 x 2 ¾”
Carriage Bolts (#37), two ∅ ¾” Washers (#45), and two M10 Aircraft Nuts (#43).
B.) Place Backrest Adjustment Bar (#5) between the two Upright Beams on the selected
bar holder to obtain desired incline of Backrest Board.
C.) Insert two Crutches (#4) into the top openings on the Upright Beams. Secure them with
two M18 Lock Knobs (#30) through selected holes to obtain desired height of the
Supports.
DIAGRAM 1
4
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the Main Seat Support (#6) to the Cross Brace (#3). Secure it with a Bracket
(#17), two M10 x 2 ¾” Carriage Bolts (#37), two ∅ ¾” Washers (#45), and two M10
Aircraft Nuts (#43).
B.) Attach the Front Support (#8) to the Main Seat Support (#6). Secure it with three M10 x
2 ¾” Carriage Bolts (#37), ∅ ¾” Washers (#45), and M10 Aircraft Nuts (#43).
DIAGRAM 2
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#10) to the open bracket on the Front Support (#8).
Secure it with an Axle (#44), two ∅ ¾” Washers (#45), and two M10 x ¾” Allen Bolts
(#39).
B.) Insert one Foam Tube (#16) halfway through the hole on the Front Support (#8).
Insert two Foam Tubes halfway through the holes on the Leg Developer. Push six
Foam Rolls (#23) onto the Foam Tubes. Plug six Foam Roll End Caps (#56) into the
ends.
C.) Attach the Curl Handle (#11) to the open bracket on the Leg Developer. Lock it with
a L-shape Pin (#22) for Arm Curl exercises. Remove the Pin when using the Leg
Developer.
D.) Attach a Spring Clip (#48) to the weight post on the Leg Developer.
DIAGRAM 3
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the hole-side of the Backrest Supports (#7) to both ends of the pivot on the
Main Seat Support (#6). Secure it with one M12 x 7 ¼” Hex Bolt (#38) and M12
Aircraft Nut (#42). Place the other end of Backrest Supports rest against the Backrest
Adjustment Bar.
B.) Place the Backrest Board (#19) onto the Backrest Supports (#7). Secure it with four
M6 x 1 3/8” Hex Bolts (#41) and ∅ ½” Washers (#47).
C.) Place the Seat (#18) onto the Main Seat Support (#6). Secure it with four M6 x 1
3/8” Hex Bolts (#41) and ∅ ½” Washers (#47).
D.) Attach the Arm Curl Pad (#20) to the Arm Curl Stand (#9). Secure it with two M8 x
¾” Allen Bolts (#40) and ∅ 5/8” Washers (#46).
E.) Insert the Arm Curl Stand (#9) into the top opening on the Front Support (#8).
Secure it with a Lock Knob (#30).
DIAGRAM 4
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 5 (See Diagram 5)
A.) Insert a M12 x 6 ¼” Hex Bolt (#54) through the Right Butterfly (#12). Secure the Bolt
with a M12 Regular Nut (#53). Insert the Bolt through the hole on the Right Upright
Beam (#1) and secure it with a M12 Lock Knob (#49).
B.) Attach the Butterfly Handle (#14) to the Right Butterfly (#12). Secure it with one M10 x
¾” Allen Bolt (#39) and ∅1 ¼” Washer (#55).
C.) Attach Spring Clip (#48) to weight post on the Butterfly.
D.) Repeat the Procedures A, B & C above to install the other side.
DIAGRAM 5
8
Download from Www.Somanuals.com. All Manuals Search And Download.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
DESCRIPTION
Q’ty
1
2
3
4
5
6
7
8
Right Upright Beam
Left Upright Beam
Cross Brace
1
1
1
2
1
1
2
1
1
1
1
1
1
2
1
3
3
1
1
1
2
1
6
2
3
3
2
2
2
3
2
4
1
2
2
4
9
1
4
2
8
1
9
1
11
2
8
3
2
4
4
4
2
2
2
6
Crutch
Backrest Adjustment Bar
Main Seat Support
Backrest Support
Front Support
Arm Curl Stand
Leg Developer
Curl Handle
Right Butterfly
Left Butterfly
Butterfly Handle
Curl Handle Tube
Foam Tube
Bracket
Seat
Backrest Board
Arm Curl Pad
Curl Handle Grip
L-shape Pin
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
Foam Roll
1 5/8” x 2 3/8” End Cap
∅ 1” End Cap
∅ 1” Cone-shape End Cap
Axle Bushing
Spacer
Butterfly Handle Grip
M18 Lock Knob
1” Square End Cap
2” Square End Cap
Sleeve
Inner Cap
Upright Sleeve
Philips Screw
M10 x 2 ¾” Carriage Bolt
M12 x 7 ¼” Hex Bolt
M10 x ¾” Allen Bolt
M8 x ¾” Allen Bolt
M6 x 1 3/8” Hex Bolt
M12 Aircraft Nut
M10 Aircraft Nut
Axle
∅ ¾” Washer
∅ 5/8” Washer
∅ ½” Washer
Spring Clip
M12 Lock Knob
1 ½” End Cap
∅ 5/8” Bushing
Rubber Bumper
M12 Regular Nut
M12 x 6 ¼” Hex Bolt
∅ 1 ¼” Washer
Foam Roll End Cap
10
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase. This
warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing
or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX Customer
Service Department at 1-800-999-8899. All freights on products returned to IMPEX must be prepaid by the
customer. This warranty does not extend to any product or damage to a product caused by or attributable to
freight damage, abuse, misuse, improper or abnormal usage or repairs not provided by an IMPEX authorized
service center or for products used for commercial or rental purposes. No other warranty beyond that
specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic loss,
loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other
consequential damages or whatsoever natures. Some states do not allow the exclusion or limitation of
incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the above
limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to state.
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-8899
during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
11
Download from Www.Somanuals.com. All Manuals Search And Download.
|