NOTE:
Please read all instructions
carefully before using this
product
MARCY® DIAMOND
WEIGHT BENCH
MD-805
Table of Contents
Safety Notice
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
MD-805
Retain This
Manual for
Reference
06-24-08
OWNER'S
MANUAL
IMPEX® INC.
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions
apply whenever you operate a piece of exercise equipment. Be sure to read the
entire manual before you assemble or operate your machine. In particular, note
the following safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT leave
children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands and feet away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running or
aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
CARE AND MAINTENANCE
1. Inspect and tighten all parts before using the machine.
2. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
3. Maximum weight capacity 600 lbs.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT
YOUR PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS
OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH
PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS
EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBILITY FOR PERSONAL
INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE
OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING LABEL REPLACEMENT
The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible,
please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE PACK
NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended two or more people assembling this
machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the Left and Right Upright Beams (#45 & #1) by a Cross Brace (#2) in the Mid-
span. Secure each end of the Cross Brace with two M10 x 3 ¾” Carriage Bolts (#33), one 5
1/8” x 2 1/8” Bracket (#32), two ∅ ¾” Washers (#41), and two M10 Aircraft Nuts (#39).
B.) Insert two Crutches (#3) into the Left and Right Upright Beams. Secure each Crutch with a
Lock Knob (#30) at selected height.
C.) Place the Backrest Adjustment Bar (#9) onto the open slots on the Upright Beams to obtain
the desired Backrest incline position.
DIAGRAM 1
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the Front Post (#5) to the Main Seat Support (#4). Secure it with five M10 x ¾”
Allen Bolts (#44) and Ø ¾” Washers (#41). DO NOT tighten the Bolts yet.
B.) Attach the Main Seat Support to the Cross Brace (#2). Secure it with two M10 x 3 1/8”
Carriage Bolts (#34), one 4 ¾” x 2” Bracket (#10), two Ø ¾” Washers (#41), and two
M10 Aircraft Nuts (#39).
C.) Securely tighten all Nuts and Bolts previously installed.
D.) Insert the Arm Curl Stand (#6) into the opening on the Front Post. Use a Lock Knob
(#30) to hold the Stand in position.
DIAGRAM 2
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#7) to the open bracket on the Front Post (#5). Secure it with
one M8 x 3 3/8” Allen Bolt (#37), two Ø 5/8” Washers (#42), and one M8 Aircraft Nut
(#40). Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to
swivel.
B.) Attach the Arm Curl Handle (#8) to the Leg Developer. Use the L-shaped Lock Pin
(#31) to secure the Handle.
C.) Remove the Arm Curl Handle when doing Leg Developer exercises.
DIAGRAM 3
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the side holes on the two Backrest Supports (#12) to the pivot on the Main Seat
Support (#4). Place the other end rest against the Backrest Adjustment Bar (#9).
B.) Attach the Backrest Board (#15) onto the Backrest Supports. Secure it with four M6 x 1 ½”
Hex Bolts (#38) and Ø ½” Washers (#43).
C.) Attach the Seat Pad (#14) to the Main Seat Support. Secure it with four M6 x 1 ¼” Hex Bolts
(#35) and Ø ½” Washers (#43).
D.) Attach the Arm Curl Pad (#16) to the Arm Curl Stand (#6). Secure it with two M8 x ¾” Allen
Bolts (#36) and Ø 5/8” Washers (#42).
DIAGRAM 4
Download from Www.Somanuals.com. All Manuals Search And Download.
8
STEP 5 (See Diagram 5)
A.) Insert two Foam Tubes (#11) halfway through the holes on the Leg Developer (#7). Push
four Foam Rolls (#13) onto the Tubes from both ends. Plug four Foam Roll End Caps
(#25) into the ends.
B.) Attach the Olympic Sleeve (#20) onto the weight post on the Leg Developer. Attach a
Spring Clip (#26) onto the Olympic Sleeve.
DIAGRAM 5
9
Download from Www.Somanuals.com. All Manuals Search And Download.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
1
2
3
4
5
6
7
8
DESCRIPTION
Right Upright Beam
Cross Brace
Crutch
Main Seat Support
Front Post
Arm Curl Stand
Leg Developer
Arm Curl Handle
Backrest Adjustment Bar
4 ¾” x 2” Bracket
Foam Tube
Backrest Support
Foam Roll
Seat Pad
Backrest Board
Arm Curl Pad
Crutch Sleeve
Arm Curl Stand Sleeve
3” Square End Cap
Olympia Sleeve
Ø 1 1/8” End cap
1” Square End Cap
Ø 1” End Cap
QUANTITY
1
1
2
1
1
1
1
1
1
1
2
2
4
1
1
1
2
1
4
1
2
2
1
2
4
1
2
3
2
3
1
2
4
2
4
2
1
4
6
1
11
4
8
5
1
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
Bushing
Foam Roll End Cap
Spring Clip
Grip
2 3/8” Square End Cap
Ø 1 ¼” Bushing
Lock Knob
L-shaped Lock Pin
5 1/8” x 2 1/8” Bracket
M10 x 3 ¾” Carriage Bolt
M10 x 3 1/8” Carriage Bolt
M6 x 1 ¼” Hex Bolt
M8 x ¾” Allen Bolt
M8 x 3 3/8” Allen Bolt
M6 x 1 ½” Allen Bolt
M10 Aircraft Nut
M8 Aircraft Nut
Ø ¾” Washer
Ø 5/8” Washer
Ø ½” Washer
M10 x ¾” Allen Bolt
Left Upright Beam
11
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX® INC.
LIMITED WARRANTY
®
IMPEX Inc. ("IMPEX ") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase. This
warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing
or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX Customer
Service Department at 1-800-999-8899. All freights for products return to IMPEX must be prepaid by the
customer. This warranty does not extend to any product or damage to a product caused by or attributable to
freight damage, abuse, misuse, improper or abnormal usage or repairs not provided by an IMPEX authorized
service center or for products used for commercial or rental purposes. No other warranty beyond that
specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic loss,
loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other
consequential damages or whatsoever natures. Some states do not allow the exclusion or limitation of
incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the above
limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to state.
®
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-8899
during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
12
Download from Www.Somanuals.com. All Manuals Search And Download.
|