NOTE:
Please read all instructions
carefully before using this
product
Table of Contents
Safety Notice
COMPETITOR BENCH
CB-280
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
CB-280
Retain This
Manual for
Reference
07-1704
IMPEX FITNESS PRODUCTS
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
OWNER'S
MANUAL
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT leave
children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine near water
or outdoors.
5. Keep hands and feet away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear robes or
other clothing that could become caught in the machine. Running or aerobic shoes are
also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO NOT use
attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or physician in
attendance.
10. Before using the machine to exercise, always do stretching exercises to properly warm
up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE
OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES
NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE
SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE PACK
3
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches
NOTE: It is strongly recommended two or more people assembling this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the two Rear Upright Beams (#1) by a Cross Brace (#2) in the Mid-span.
Secure them with two M8 x 2 ½” Carriage Bolts (#20), one Bracket (#10), two ∅ 5/8”
Washers (#26), and two M8 Aircraft Nuts (#24) on each end of the Cross Brace.
B.) Insert the Backrest Adjustment Bar (#11) through a selected hole to obtain desired
incline of Backrest.
DIAGRAM 1
4
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the Main Seat Support (#3) to the Cross Brace (#2). Secure it with four M8 x 2
3/8” Hex Bolts (#18), one Bracket (#10), four Ø 5/8” Washers (#26), and four M8
Aircraft Nuts (#24). DO NOT tighten the Nuts and Bolts yet.
B.) Attach the Front Support (#5) to the Main Seat Support (#3). Secure the first hole to
the Main Seat Support with one M8 x 1 5/8” Carriage Bolt (#28), one Ø 5/8” Washer
(#26), and one M8 Aircraft Nut (#24). DO NOT tighten the Nut and Bolt yet.
C.) Attach one end of the Diagonal Support (#4) to the second hole on the Main Seat
Support. Align the holes and secure them together with one M8 x 1 ¾” Carriage Bolt
(#29), one Ø 5/8” Washer (#26), and one M8 Aircraft Nut (#24). Attach the other end
of the Diagonal Support to the Front Support (#5). Secure it with one M8 x ½” Hex Bolt
(#30) and Ø 5/8” Washer (#26).
D.) Securely tighten all Nuts and Bolts previously installed.
DIAGRAM 2
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#6) to the Front Support (#5). Secure it with one M10 x 2
3/8” Hex Bolt (#21), two Ø ¾” Washers (#31), and one M10 Aircraft Nut (#27). Do not
over tighten the Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert two Foam Tubes (#13) halfway through the holes on the Leg Developer. Push
four Foam Rolls (#12) onto the Tubes from both sides.
C.) Place a Spring Clip (#39) onto the weight post on the Leg Developer.
DIAGRAM 3
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the hole-side of the Backrest Supports (#7) onto both ends of the pivot on the Main
Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#11).
B.) Place the Backrest Board (#8) onto the Backrest Supports. Secure it with four M6 x 1 5/8”
Hex Bolts (#23) and Ø ½” Washers (#25).
C.) Place the Seat Pad (#9) onto the Main Seat Support. Secure it with four M6 x 5/8” Hex
Bolts (#22) and Ø ½” Washers (#25).
DIAGRAM 4
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 5 (See Diagram 5)
A.) Attach the Arm Curl Pad (#34) to the Arm Curl Stand (#42). Secure it with
two M8 x ¾” Hex Bolts (#33) and Ø 5/8” Washers (#26).
B.) Insert the Arm Curl Stand into the top opening on the Front Support and
secure it with a Lock Knob (#32).
DIAGRAM 5
8
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 6 (See Diagram 6)
A.) Slide the 25lb (#36), 15lb (#37), and 10lb (#38) Weight Plates onto the Weight Bar
(#35). Note: Plates must be installed in pairs, one on each side.
B.) Attach two Spring Clips (#39) onto the Weight Bar.
DIAGRAM 6
9
Download from Www.Somanuals.com. All Manuals Search And Download.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
DESCRIPTION
QUANTITY
1
2
3
4
5
6
7
8
Rear Upright Beam
Cross Brace
Main Seat Support
Diagonal Support
Front Support
2
1
1
1
1
1
2
1
1
3
1
4
2
4
7
1
2
4
4
4
1
4
4
10
8
13
1
1
1
1
2
1
2
1
1
2
2
2
5
1
1
1
Leg Developer
Backrest Support
Backrest Board
Seat
Bracket
Backrest Adjustment Bar
Foam Roll
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
Foam Tube
Ø ¾” Round End Cap
Ø 1” Round End Cap
Rubber Bumper
1 ½” Square End Cap
M8 x 2 3/8” Hex Bolt
1” Square End Cap
M8 x 2 ½”Hex Bolt
M10 x 2 3/8” Hex Bolt
M6 x 5/8” Hex Bolt
M6 x 1 5/8” Hex Bolt
M8 Aircraft Nut
Ø ½” Washer
Ø 5/8” Washer
M10 Aircraft Nut
M8 x 1 5/8” Carriage Bolt
M8 x 1 ¾” Carriage Bolt
M8 x ½” Hex Bolt
Ø ¾” Washer
Lock Knob
M8 x ¾” Hex Bolt
Arm Curl Pad
48” Weight Bar
25lb Weight Plate
15lb Weight Plate
10lb Weight Plate
Spring Clip
Sliding Sleeve
48” Curl Bar
Arm Curl Stand
11
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase.
This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited
to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights for products return to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused
by or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided
by an IMPEX authorized service center or for products used for commercial or rental purposes. No other
warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the
above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line www.impex-fitness.com
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
12
Download from Www.Somanuals.com. All Manuals Search And Download.
|