NOTE:
Please read all instructions
carefully before using this
product
Table of Contents
Safety Notice
COMPETITOR
WEIGHT BENCH
CB-180
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
CB-180
Retain This
Manual for
Reference
06-13-06
IMPEX INC.
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
OWNER'S
MANUAL
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire
manual before you assemble or operate your machine. In particular, note the following
safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT leave
children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine near
water or outdoors.
5. Keep hands and feet away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear robes or
other clothing that could become caught in the machine. Running or aerobic shoes
are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO NOT use
attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or physician
in attendance.
10. Before using the machine to exercise, always do stretching exercises to properly
warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
13. Maximum user’s weight capacity 200 lbs.
14. Maximum weight capacity on Leg Developer 80 lbs.
15. Maximum weight capacity on Uprights 200 lbs.
CARE AND MAINTENANCE
1. Inspect and tighten all parts before using the machine.
2. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE
AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT.
IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING LABEL REPLACEMENT
The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible,
please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE PACK
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches.
NOTE: It is strongly recommended two or more people assembling this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Attach the Left & Right Upright Beams (#1 & 2) onto the Lower Upright Beams (#3).
B.) Connect the Left & Right Upright Beams by a Cross Brace (#4) in the Mid-span.
Secure them with two M8 x 2 1/8” Hex Bolts (#18), one Bracket (#16), four ∅ 5/8”
Washers (#24), and two M8 Aircraft Nuts (#26) on each end of the Cross Brace.
C.) Place the Backrest Adjustment Bar (#13) onto selected slot on the Upright Beams
to obtain desired incline of Backrest.
DIAGRAM 1
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Insert the Main Support Frame (#5) into the Seat Support Frame (#6). Secure them
with two M8 x 2 1/8” Hex Bolts (#18), two Brackets (#16), four Ø 5/8” Washers (#24),
and two M8 Aircraft Nuts (#26).
B.) Attach the Main Support Frame (#5) to the Cross Brace (#4). Secure it with two M8 X
2 1/8” Hex Bolts (#18), one Bracket (#16), four Ø 5/8” Washers (#24), and two M8
Aircraft Nuts (#26).
C.) Attach the Seat Support Frame (#6) to the Leg Developer Holder (#7). Secure it with
two M8 x 2 1/8” Hex Bolts (#18), one Bracket (#16), four Ø 5/8” Washers (#24), and
two M8 Aircraft Nuts (#26).
D.) Place the Seat Pad (#12) onto the Seat Support Frame (#6). Secure it with two M6 x
5/8” Hex Bolts (#21) and two Ø ½” Washers (#25).
DIAGRAM 2
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Insert the two Upper Backrest Supports (#8) into two Lower Backrest Supports (#9).
Secure them with two M6 x 1 3/8” Hex Bolts (#20), four Ø ½” Washers (#25), and
two M6 Aircraft Nuts (#28).
B.) Attach the side-holes on the Lower Backrest Supports (#9) to each end of the pivot
on the Seat Support Frame (#6). Align the holes and insert a M10 x 6 7/8” Axle
(#17) through the holes. Secure it with two Ø ¾” Washers (#23) and M10 Aircraft
Nuts (#27). Do not over tighten the Nuts. Make sure the Backrest Supports are
able to swivel.
C.) Place the Lower Backrest Board (#10) onto the Backrest Supports. Secure it with
four M6 x 1 3/8” Hex Bolts (#20) and Ø ½” Washers (#25).
D.) Place the Upper Backrest Board (#11) onto the Backrest Supports. Secure it with
two M6 x 1 3/8” Hex Bolts (#20) and Ø ½” Washers (#25).
DIAGRAM 3
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#29) to the Leg Developer Holder (#7). Secure it with one
M10 x 2 1/8” Hex Bolt (#19), two Ø ¾” Washers (#23), and one M10 Aircraft Nut (#27).
Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.
B.) Insert the Weight Post (#31) into the Leg Developer. Secure it with one M8 x 1 ¾” Hex
Bolt (#22), two Ø 5/8” Washers (#24), and one M8 Aircraft Nut (#26).
C.) Insert the Foam Tube (#30) halfway through the holes on the Leg Developer. Attach two
Foam Rolls (#32) onto the Tube from both ends.
DIAGRAM 4
8
Download from Www.Somanuals.com. All Manuals Search And Download.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
DESCRIPTION
QUANTITY
1
2
3
4
Left Upright Beam
Right Upright Beam
Lower Upright Beam
Cross Brace
1
1
2
1
5
6
7
8
Main Support Frame
Seat Support Frame
Leg Developer Holder
Upper Backrest Support
Lower Backrest Support
Lower Backrest Board
Upper Backrest Board
Seat Pad
Backrest Adjustment Bar
1 ½” Square End Cap
1” Square End Cap
Bracket
M10 x 6 7/8” Axle
M8 x 2 1/8” Hex Bolt
M10 x 2 1/8” Hex Bolt
M6 x 1 3/8” Hex Bolt
M6 x 5/8” Hex Bolt
M8 x 1 ¾” Hex Bolt
Ø ¾” Washer
Ø 5/8” Washer
Ø ½” Washer
M8 Aircraft Nut
M10 Aircraft Nut
M6 Aircraft Nut
Leg Developer
Foam Tube
Weight Post
Foam Roll
1
1
1
2
2
1
1
1
1
1
4
6
1
10
1
8
2
1
4
22
12
11
3
2
1
1
1
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
2
1
2
2
Ø 1” End Cap
Ø ¾” End Cap
1 ¼” Square End Cap
Rubber Bumper
1
10
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase.
This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited
to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights for products return to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused
by or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided
by an IMPEX authorized service center or for products used for commercial or rental purposes. No other
warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the
above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line www.impex-fitness.com
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
11
Download from Www.Somanuals.com. All Manuals Search And Download.
|