NOTE:
Please read all instructions
carefully before using this
product
Table of Contents
Safety Notice
MARCY® CLASSIC
INVERSION TABLE
IVT-451
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
IVT-451
Retain This
Manual for
Reference
100114
OWNER'S
MANUAL
IMPEX® INC.
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT leave
children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine near water
or outdoors.
5. Keep hands and feet away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear robes or
other clothing that could become caught in the machine. Running or aerobic shoes are
also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO NOT use
attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or physician in
attendance.
10. Before using the machine to exercise, always do stretching exercises to properly warm
up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is needed during exercise. Do not use this product alone.
13. This machine is designed and intended for home and consumer use only, not for
commercial use.
14. Make sure the Foot Lock securely locks both feet.
15. When doing inversion exercises, please hold onto the Handles with both hands.
CARE AND MAINTENANCE
1. Lubricate moving parts with WD-40 or light oil periodically.
2. Inspect and tighten all parts before using the machine.
3. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
4. Maximum user’s weight: 300 lbs.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE
OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES
NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE
SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING LABEL PLACEMENT
The Warning Labels shown here have been placed on the Rear Support Frame. If the labels are missing or
illegible, please call customer service at 1-800-999-8899 for replacement. Apply the labels in location shown.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE IDENTIFIER
NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not fasten the Nuts and Bolts until instructed to do so.
B.) Attach Front Support Frame (#1) to Rear Support Frame (#2). Secure them together
with one M10 x 1” Allen Bolt (#34), two Ø ¾” Washers (#45), and one M10 aircraft Nut
(#43) on each end.
C.)Attach a Ø ¾” Rubber Spacer (#24) to the lower hole on Rear Support Frame. Attach
one Short Horizontal Support (#3) to the Spacer. Align the holes. Secure the Short
Horizontal Support, Spacer, and Rear Support Frame together with one M8 x 2 5/8”
Allen Bolt (#37), one Ø 5/8” Washer (#46), and one M8 Aircraft Nut (#43). Repeat the
same procedure to install the Right Long Horizontal Support (#4) to Front Support
Frame.
D.)Connect the Short and Long Horizontal Support together with one M6 x ½” Allen Bolt
(#33), one Ø ½” Washer (#47), and one M6 Aircraft Nut (#44).
E.) Repeat Procedure C & D to install the other side.
F.) Press down the Short and Long Horizontal Support completely to stabilize the Front
and Rear Support Frame.
G.)Securely fasten all Nuts and Bolts installed.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
DIAGRAM 1
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the two Pivot Brackets (#12) to the Backrest Frame (#7) from each side.
B.) Lift the Backrest Frame and insert the two Pivot Brackets into the open slot on Rear
Support Frame (#2). Make sure the groves on the Pivot are attached on the slots
completely and the Pivots can swing smoothly.
C.)Cover the two open slots on the Rear Support Frame with Left & Right Swivel Cover
(#30 & #31).
DIAGRAM 2
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Left Handle (#8) to Front Support Frame (#1). Secure it with one M8 x ¾”
Allen Bolt (#35), one Ø 5/8” Washer (#46), and one M8 Aircraft Nut (#43).
B.) Attach the Left Handle to the Rear Support Frame (#2). Secure it with one M8 x 1 ¾”
Allen Bolt (#36), one Ø 5/8” Washer (#46), and one M8 Aircraft Nut (#43).
C.)Slide one Plastic Barricade (#38) onto opening edge on the Rear Support Frame (#2)
to prevent fingers from being caught in the opening.
D.)Repeat Procedures A & B to install the Right Handle (#9).
DIAGRAM 3
8
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Pull up the Foot Adjustment Lock Pin (#23). Insert the Foot Lock Frame (#13) into the
Adjustment Fame (#11). Push down the Pin to securely lock the Foot Lock Frame in
position.
B.) Insert the Foot Support (#6) into the bottom of Adjustment Frame. Secure it with one M8 x
1 5/8” Allen Bolt (#40), one Ø 5/8” Washer (#46), and one M8 Aircraft Nut (#43).
C.)Insert the Foam Tube (#10) halfway through the hole on Adjustment Frame. Push two
Foam Rolls (#17) onto the Tube from both ends.
D.)Push two Curved Foam Rolls (#16) onto the tube on Foot Lock Frame (#13) from both
ends.
DIAGRAM 4
9
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 5 (See Diagram 5)
A.) Pull out the Backrest Adjustment Lock Pin (#22). Insert the Adjustment
Frame (#11) into the opening on the vertical frame on the back of Backrest
Frame (#7). Push back the Pin into the selected hole on Adjustment
Frame. The holes are scaled from 5’3” to 6’6”. User can select the
hole by user’s body height for better fitment while performing the
inversion exercises.
B.) Insert the Ring Lock Pin (#21) through the hole on the vertical frame and
hole on Adjustment Frame to securely lock the Adjustment Frame.
C.)Attach hook on Inversion Adjustment Belt (#15) to Front Support Frame
(#1) and to the vertical frame on Backrest Frame. Adjust the length of the
Belt to adjust the extension of inversion.
D.)Attach one side of U-shaped Lock Pin (#14) on front of Adjustment Frame,
insert the other side into hole on Front Support Frame and secure with one
M8 Aircraft Nut to lock Inversion Table for usage.
E.) When using the Inversion Table, remove the side of U-shaped Lock Pin off
from Adjustment Frame.
DIAGRAM 5
10
Download from Www.Somanuals.com. All Manuals Search And Download.
EXPLODED DIAGRAM
11
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
1
2
3
4
5
6
7
8
DESCRIPTION
QUANTITY
Front Support Frame
Rear Support Frame
Short Horizontal Support
Right Long Horizontal Support
Left Long Horizontal Support
Foot Support
Backrest Frame
Left Handle
Right Handle
Foam Tube
1
1
2
1
1
1
1
1
1
1
1
2
1
1
1
2
2
2
1
4
1
1
1
4
1
2
4
2
1
1
1
2
2
2
2
2
4
2
1
1
1
2
10
3
4
9
3
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
Adjustment Frame
Pivot Bracket
Foot Lock Frame
U-shaped Lock Pin
Inversion Adjustment Belt
Curved Foam Roll
Foam Roll
Hook
Backrest
Ø 1 ¼” End Cap
Ring Lock Pin
Backrest Adjustment Lock Pin
Foot Adjustment Lock Pin
Ø ¾” Rubber Spacer
Rubber Bumper
Handle Grip
Foam Roll End Cap
¾” x 2 3/8” End Cap
1” Square End Cap
Left Swivel Cover
Right Swivel Cover
Ø 1 ¼” End Cap
M6 x ½” Allen Bolt
M10 x 1” Allen Bolt
M8 x ¾” Allen Bolt
M8 x 1 ¾” Allen Bolt
M8 x 2 5/8” Allen Bolt
Plastic Barricade
M6 x 1 5/8” Allen Bolt
M8 x 1 5/8” Allen Bolt
M6 x 5/8” Philips Screw
M10 Aircraft Nut
M8 Aircraft Nut
M6 Aircraft Nut
Ø ¾” Washer
Ø 5/8” Washer
Ø ½” Washer
12
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX® INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material,
under normal use and service conditions, for a period of two years on the Frame from the date of
purchase.
This warranty extends only to the original purchaser.
IMPEX's obligation under this
Warranty is limited to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights for products return to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused
by or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided
by an IMPEX authorized service center or for products used for commercial or rental purposes. No
other warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to
you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set
forth herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly,
the above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line www.impex-fitness.com
IMPEX® INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
13
Download from Www.Somanuals.com. All Manuals Search And Download.
|