NOTE:
Please read all instructions
carefully before using this
product
COMPETITOR
WEIGHT BENCH
CB-181
Table of Contents
Safety Notice
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
CB-181
Retain This
Manual for
Reference
08-12-09
OWNER'S
MANUAL
IMPEX® INC.
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain
precautions apply whenever you operate a piece of exercise equipment. Be
sure to read the entire manual before you assemble or operate your machine.
In particular, note the following safety precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other
abnormal symptoms, STOP the workout at once. CONSULT A
PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the
machine near water or outdoors.
5. Keep hands and feet away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
CARE AND MAINTENANCE
1. Inspect and tighten all parts before using the machine.
2. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
3. Maximum weight on Upright Beams: 100 lbs.
4. Maximum User weight capacity: 200 lbs.
5. Maximum weight on Leg Developer: 100 lbs.
6. Maximum weight capacity (including user) : 300 lbs.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT
YOUR PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS
OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH
PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS
EQUIPMENT.
IMPEX INC. ASSUMES NO RESPONSIBILITY FOR
PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR
THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING LABEL PLACEMENT
The Warning Label shown here has been placed on the Cross Brace. If the label is missing or
illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in
location shown.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE PACK
NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required for Assembling this Machine: Two Adjustable Wrenches and Allen
Wrenches. NOTE: It is strongly recommended that two or more people assemble
this machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Connect the Right & Left Upright Beam (#1 & #2) by a Cross Brace (#3) in the Mid-span.
Secure each end of the Cross Brace with two M8 x 2 ½” Hex Bolts (#21), one 1 ¾” x 2
¾” Bracket (#10), four ∅ 5/8” Washers (#27), and two M8 Aircraft Nuts (#29).
C.) Place the Backrest Adjustment Bar (#7) onto the selected on the Upright Beams to
obtain the desired backrest incline.
DIAGRAM 1
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the Main Seat Support (#4) to the Front Post (#5). Secure it with two M10 x
2 ¼” Hex Bolts (#22), one 1 ½” x 4 ½” Bracket (#11), four Ø ¾” Washers (#26), and
two M10 Aircraft Nuts (#30).
B.) Attach the Main Seat Support to the Cross Brace (#3). Secure it with two M10 x 2
¼” Hex Bolts (#22), one 1 ½” x 4 ½” Bracket (#11), four Ø ¾” Washers (#26), and
two M10 Aircraft Nuts (#30).
C.) Securely tighten all Nuts and Bolts installed in Step-1 and Step-2.
DIAGRAM 2
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#6) to the open bracket on the Front Post (#5). Secure it
with one M8 x 2 ¾” Hex Bolt (#23), two Ø 5/8” Washers (#27), and one M8 Aircraft
Nut (#29). Do not over tighten the Nut and Bolt. Make sure the Leg Developer
can swivel freely.
B.) Place the Seat Pad (#13) onto the bracket on the Main Seat Support (#4). Secure it
with four M6 x 5/8” Allen Bolts (#24) and four Ø ½” Washers (#28).
C.) Insert the Foam Tube (#9) halfway through the hole on the Leg Developer. Push
two Foam Rolls (#14) onto the Tube from both ends.
DIAGRAM 3
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the bottom side-holes on Backrest Supports (#8) to the pivot on the Main Seat
Support (#4). Rest the other end against the Backrest Adjustment Bar (#7).
B.) Attach the Backrest Board (#12) to the Backrest Support. Secure it with four M6 x 1
½” Hex Bolts (#25) and four Ø ½” Washers (#28).
DIAGRAM 4
8
Download from Www.Somanuals.com. All Manuals Search And Download.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
1
2
3
4
5
6
7
8
DESCRIPTION
Right Upright Beam
Left Upright Beam
Cross Brace
Main Seat Support
Front Post
QUANTITY
1
1
1
1
1
1
1
2
1
2
2
1
1
2
2
3
2
2
2
2
4
4
1
4
4
8
10
8
5
4
Leg Developer
Backrest Adjustment Bar
Backrest Support
Foam Tube
1 ¾” x 2 ¾” Bracket
1 ½’ x 4 ½” Bracket
Backrest Board
Seat Pad
Foam Roll
1” End Cap
1 ½” End Cap
Ø 1” End Cap
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Ø 1” Adjustment Bar End Cap
Ø ¾” End Cap
Leg Developer Bushing
M8 x 2 ½” Hex Bolt
M10 x 2 ¼” Hex Bolt
M8 x 2 ¾” Hex Bolt
M6 x 5/8” Hex Bolt
M6 x 1 ½” Hex Bolt
Ø ¾” Washer
Ø 5/8” Washer
Ø ½” Washer
M8 Aircraft Nut
M10 Aircraft Nut
10
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX® INC.
LIMITED WARRANTY
®
IMPEX Inc. ("IMPEX ") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase.
This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited
to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights for products return to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused
by or attributable to freight damage, abuse, misuse, improper or abnormal usage. No other warranty
beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the
above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line www.impex-fitness.com
®
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
11
Download from Www.Somanuals.com. All Manuals Search And Download.
|