HDA2000FAD/WH - Hotpoint Built-In Dishwasher
Wood Insert Cut-Out
Dimensions (in inches)
Dishwasher Dimensions (in inches)
Installation Information
(in inches)
24
25-1/8*
Countertop
90°
This wall area
Panel Thickness
3/4
Door insert
A
C
must be free of
pipes or wires
90°
23-3/8*
24"
Detail D
Electrical
Front
of
Panel
4
5
4
5
MIN.
wiring is
3" from
cabinet
4
Hot
water
line on
left
24-3/4
Access insert
B
Electrical
wiring on
right
1-1/2
1/2
34-1/2 1/4"
Underside
of countertop
to floor
6
6
34" MIN.
adj. to 35"
Plumbing and electrical
service must enter
inside shaded area
1/4
2
19" MIN. from wall
24" From wall
21-1/2*
*Add 1/4" for
*rear insulation
White (neutral)
Panel
Thickness
Ground
Black (line)
Models/Kits
GPF325 Kit
A
B
C
24" MIN.
3-1/4
4 (Adjustable)
18-7/8” 23-9/16” 3-11/16”
4-1/4” to
1/4”
GPF375 Kit 18-15/16” 23-5/8”* 3-3/4”**
3/4”
*Bottom of panel must be notched 1-1/2"x1/2" to clear
access panel. (See illustration above)
**Adjustment required to match adjcent cabinets fronts due to
leveling leg adjustment, 4" nominal.
Note: Dishwasher must not be installed more than 10' from sink
for proper drainage. All plumbing and electrical work must be in
accordance with local codes. Dishwasher includes drain hose
and leveling legs.
Electrical Rating
Voltage AC.......................................................120
Hertz ..................................................................60
Total connected load amperage.......................8.6
®
Calrod heater watts.......................................500
Installation Information: Before installing, consult installation
instructions packed with product for current dimensional data.
For use on adequately wired 120-volt, 15-amp
circuit having 2-wire service with a separate
ground wire. This appliance must be grounded
for safe operation.
Listed by
Underwriters
Laboratories
R
Specification Created 10/00
Download from Www.Somanuals.com. All Manuals Search And Download.
|