INSTALL INSTRUCTIONS C-VS-800-CV
VEHICLE SPECIFIC CONSOLE &
RADIO/HVAC RELOCATION HOUSING
1997-2008 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench
Tin snips (if necessary)
Standard/Metric socket set
Screwdriver set
Powered Drill w/ 5/16” drill bit
HARDWARE:
QTY DESCRIPTION
PART #
GSM33195
C-HK-1
2
1
#10 x ¾” Phillips sheet metal screws
Torx Screw Kit
Always!
ꢀ Disconnect the vehicles’ battery. Removing seat bolts on
some vehicles may give the vehicles computer a false
reading resulting in warning lights. This requires the
vehicles’ computer to be reset.
ꢀ Read all instructions before installing any Havis-Shields
Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.)
before drilling any holes!
ꢀ Use hardware provided with install kit.
ꢀ For product support, visit the Install Instructions Section
of our website at
[email protected] or call 1-800-524-9900.
Ford Crown Victoria dashboard
Remove ashtray and power point
housing from dash
A flat head screwdriver is needed to
release the tray from the slide tracks
Download from Www.Somanuals.com. All Manuals Search And Download.
Note: If NOT relocating
AM/FM radio and/or
Notch
HVAC controls, resume
installation at this point
Re-route HVAC controller and the
AM/FM radio harness and antenna
to the VS console
It is necessary to notch the OEM
ashtray/power point frame assembly if
relocating the HVAC controls to the VS
console. This will allow the HVAC
vacuum hoses to reach the VS console
Remove wire plug going to
Ashtray/Power point frame
assembly
Drill out spot-welds that hold the
power point bracket to the frame. This
needs to be removed in order for the
console to slide into the rail
Power point detached from
assembly
Re-install ashtray frame bracket
Slide console into ashtray
frame slide rails
Ashtray frame rail re-assembled
C-VS-800-CV_INST_9-07
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Pre-drill OEM dash using holes in
console as a drill template
Holes are for screws to attach to the
OEM dash
View of console from inside
Attach using #10 x ¾” sheet metal
Final installation of console
screws.
Install components according to
specific application
Install HVAC controller into C-
EB40-ACV-1P as shown and install
into console above AM/FM radio
Install AM/FM radio if necessary, as
shown above.
C-VS-800-CV_INST_9-07
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|