Hasbro Games 20251 User Manual

AGES 5+  
WARNING:  
20251  
CHOKING HAZARD-Small parts.  
Not for children under 3 years.  
LITE BRITE product!  
Batteries included. Replace  
with 4 x 1.5V “C” or LR14 size  
alkaline batteries. Phillips/cross  
head screwdriver (not included)  
needed to replace batteries.  
Includes paint spinner,  
4 bottles of paint and  
7 design cards  
Note that paint may stain  
some surfaces. Wash with  
soap and warm water.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3. You can drip two paints at once  
to create a whole new effect.  
Remember, you can use your  
imagination to make all kinds of  
cool designs!  
OTHER IDEAS  
Here are a few extra play features and  
suggestions:  
1. Put paint on your design card before  
you place it on the spinner platform.  
Try making a smiley face, a favorite  
symbol or any design you wish!  
2. Once the paint has dried on your  
design card, you can stand the FLASH  
ART Neon Paint Spinner upright and  
put it on display in your room!  
3. You can also frame or hang your dry  
design cards.  
4. Check out our FLASH ART Neon Paint  
Spinner refill sets to create other cool designs.  
Available at your local LITE BRITE retailer!  
CLEANING UP  
Turn off the FLASH ART Neon Paint Spinner and wipe with a  
damp paper towel to clean and prevent paint build-up.  
TROUBLESHOOTING  
If your FLASH ART Neon Paint Spinner shuts off automatically  
after 6 seconds, press either the  
or  
buttons while  
the spinner is on. You will need to repeat this step each time  
you replace the batteries.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
TO REPLACE BATTERIES  
Use a Phillips/cross head screwdriver to  
loosen screw in battery compartment door  
(screw remains attached to door). Insert  
4 fresh 1.5V “C” or LR14 size alkaline  
batteries. Fit door back into place and  
tighten screw.  
CAUTION: TO AVOID BATTERY  
LEAKAGE  
1. Be sure to insert the batteries correctly and always follow the toy  
and battery manufacturers’ instructions;  
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc)  
or rechargeable (nickel-cadmium) batteries;  
3. Always remove weak or dead batteries from the product.  
IMPORTANT: BATTERY INFORMATION  
Please retain this information for future reference.  
Batteries should be replaced by an adult.  
CAUTION:  
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert  
them correctly by matching the + and – polarity markings.  
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.  
3. Remove exhausted or dead batteries from the product.  
4. Remove batteries if product is not to be played with for a long time.  
5. Do not short circuit the supply terminals.  
6. Should this product cause, or be affected by, local electrical interference, move it away  
from other electrical equipment. Reset (switching off and back on again or removing and  
re-inserting batteries) if necessary.  
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always  
remove from the product before recharging. Recharge batteries under adult supervision.  
DO NOT RECHARGE OTHER TYPES OF BATTERIES.  
FCC STATEMENT  
This equipment has been tested and found to comply with the limits for a Class B digital device,  
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection  
against harmful interference in a residential installation. This equipment generates, uses and can  
radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may  
cause harmful interference to radio communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause harmful interference to radio  
or television reception, which can be determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of the following measures:  
- Reorient or relocate the receiving antenna.  
- Increase the separation between the equipment and the receiver.  
- Consult the dealer or an experienced radio/TV technician for help.  
© 2005 Hasbro. All Rights Reserved.  
TM & ® denote U.S. Trademarks.  
U.S. Patent Pending  
20251  
P/N 6453540100  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Grizzly Switch G4672 User Manual
Hamilton Beach Toaster 22408 User Manual
Harbor Freight Tools Motorcycle 91764 User Manual
Hotpoint Range RGB533WEW User Manual
HP Hewlett Packard Satellite Radio HP 4945A User Manual
Hummer Automobile 2003 Hummer User Manual
IBM Laptop 140A User Manual
IBM Projector 520Q User Manual
IBM Welding System DS4700 Express User Manual
Ice O Matic Outdoor Storage B100 User Manual