Setting and using Alarm
1. Slide the mode switch, located on the right hand
side of the clock, to the SET ALARM position.
2. Press the hour button, on the front of the clock, until
the desired hour appears on the screen.
Alarm Clock
Alarm Clock
3. Press the minute button, on the front of the clock,
until the desired minute appears on the screen.
Micro Music Player
Micro Music Player
Ages 5 & Up
Item No. 02008
Instruction
Instruction
4. Return the mode switch to the TIME position after
you have finished.
5. To activate the alarm, slide the mode selector on the
front of the alarm to the HitClip alarm position to
awaken to your favorite HitClip, or to the buzz position
to awaken to a buzzing alarm.
Battery Installation
Note: Please make sure that you follow all instructions
below within “Playing a HitClip” in order to wake to
a HitClip Single.
6. When the alarm goes off, you can press the
SNOOZE button to reset the alarm for 4 minutes.
Note: The SNOOZE button will not operate, if you are
using a Yahoo! HitClips Downloader Recordable Chip.
7. To deactivate the alarm, slide the mode selector on
the front of the alarm to the ALARM OFF position.
8. Press the LIGHT button to view the clock when dark.
Playing a HitClip
1. Per diagram, unscrew battery door lock.
2. Insert 4 new AAA batteries.
1. Remove the clip and string from the HitClip Single.
2. Slide HitClip Single into Alarm Clock.
3. Replace battery door and tighten screw.
To ensure proper function
3. Press the RELEASE button at the top of the clock
to the down position and rotate the blue wheel until
the clip you would like to listen to is at the top.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon zinc), or
rechargeable batteries (nickel-cadmium).
- Battery installation should be done by an adult.
- Non-rechargeable batteries are not to be recharged.
- Rechargeable batteries are to be removed from the
toy before being recharged (if removable).
- Rechargeable batteries are only to be charged under
adult supervision (if removable).
Note: Do not rotate if button is up, damage will occur!
4. Press the RELEASE button again, so that it is in the
up position and the HitClip is secured.
5. Press the PLAY button to start and stop music.
- Only batteries of the same or equivalent type as
recommended are to be used.
- Batteries are to be inserted with correct polarity. (see
engraving on back of alarm)
- Exhausted batteries are to be removed from the toy.
- The supply terminals are not to be short-circuited.
Setting Time
1. Slide the mode switch, located on the right hand
side of the clock, to the SET TIME position.
2. Press the hour button, on the front of the clock, until
the correct hour appears on the screen.
3. Press the minute button, on the front of the clock,
until the correct minute appears on the screen.
4. Return the mode switch to the TIME position after
you have finished.
Download from Www.Somanuals.com. All Manuals Search And Download.
90-Day Limited Warranty
FCC Statement
Tiger Electronics, Ltd. (Tiger) warrants to the original
consumer purchaser of this product that the product
will be free from defects in materials or workmanship
for 90 days from the date of original purchase. This
warranty does not cover damages resulting from
accident, negligence, improper service or use or
other causes not arising out of defects in materials
or workmanship.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
During this 90-day warranty period, the product will
either be repaired or replaced (at Tiger's option) without
charge to the purchaser, when returned with proof of
the date of purchase to either the dealer or to Tiger.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and , if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
Product returned to Tiger without proof of the date of
purchase or after the 90-day warranty period has
expired, but prior to one year from the original date of
purchase, will be repaired or replaced (at Tiger's option)
for a service fee of U.S. $8.50. Payments must be by
check or money order payable to Tiger Electronics, Ltd.
The foregoing states the purchaser's sole and exclusive
remedy for any breach of warranty with respect to
the product.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
All product returned must be shipped prepaid and
insured for loss or damage to:
Tiger Repair Department
1000 N. Butterfield Road, Unit 1023
Vernon Hills, IL 60061, U.S.A.
- Reorient or relocate the receiving antenna.
The product should be carefully packed in the original
box or other packing materials sufficient to avoid damage
during shipment. Include a complete written description
of the defect, a check if product is beyond the 90-day
warranty period, and your printed name, address and
telephone number.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is needed.
- Consult the dealer or an experienced radio/TV
technician for help.
THIS WARRANTY IS IN LIEU OF ALL OTHER
WARRANTIES AND NO OTHER REPRESENTATIONS
OR CLAIMS OF ANY NATURE SHALL BE BINDING ON
OR OBLIGATE TIGER IN ANY WAY. ANY IMPLIED
WARRANTIES APPLICABLE TO THIS PRODUCT,
INCLUDING WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED TO THE NINETY (90) DAY PERIOD DESCRIBED
ABOVE. IN NO EVENT WILL TIGER BE LIABLE FOR
ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES RESULTING FROM POSSESSION, USE, OR
MALFUNCTION OF THIS PRODUCT.
For more information about Tiger Electronics, our
products and special promotions, please visit our web
Please retain instructions for future reference.
Some states do not allow limitations as to how long
an implied warranty lasts and/or exclusions or
limitations of incidental or consequential damages, so
the above limitations and/or exclusions of liability may
not apply to you. This warranty gives you specific
rights, and you may also have other rights, which vary,
from state to state.
®, TM, & © 2000 Tiger Electronics, Ltd.
All rights reserved.
980 Woodlands Parkway,
Vernon Hills, Illinois 60061, U.S.A.
PRINTED IN CHINA
020080001IWTI-02
Download from Www.Somanuals.com. All Manuals Search And Download.
|